I bought a cheap impact driver and I noticed that the bit is moving inside the chuck, like back and forth. Is this normal, like part of the hammer mechanism, or should the bit stay fixed?
-
1Is it an impact driver or a hammer drill? Those are two different tools.– Dan D.Commented Apr 26, 2018 at 18:45
-
it is a impact driver– minnyCommented Apr 26, 2018 at 19:02
-
Which direction is "back and forth"?– isherwoodCommented Apr 27, 2018 at 1:46
-
forward and backward, like a drill bit inside a SDS plus chuck– minnyCommented Apr 27, 2018 at 5:42
Add a comment
|
1 Answer
It's normal
If this is an impact driver (see below)
then it uses a 1/4" hex chuck. Most use a simple ball-detent system to lock bits in place, which allows for some slip, especially forward and backward.
If you got an impact wrench (see below)
then it would be a problem, but if you were getting an impact wrench, you likely wouldn't be asking this question.
