Search Results

I was thinking that I could clean up the fiberglass and make a repair with the fiberglass mat/cloth/resin they sell at auto parts stores. …

What tools and techniques should I use to get the job done? …

I have a circular saw that quit working for no obvious reason. I cut a board and sat the saw down to get another board. When I tried to cut the next board, the saw wouldn't work. Pull the trigger an …

I have a bench vise that can rotate something like 270°. The problem is that the clamp that's supposed to stop it from rotating seems to only work in one direction. I can crank as hard as I can on the …

A few days ago, my wooden rake handle broke during use, so I grumbled about it, went to the hardware store a few days later, bought a new handle, and set about installing it. Unfortunately, I can't se …

Our tub drain is severely plugged. Cannot get a snake down into it. Our crawlspace is only about 18" tall (WHY?!?), and due to both the confined space and the angle we cannot leverage the wrench in p …

I have a hand tool - Needle-nose plier that had a rubber that is used as the handle. Currently, I managed to clean up all the rust on the metal and would like to clean up the rubber handle as it is st …

I need a jam/hex nut for the mic input for the below speaker. On the picture the connector have been pushed in because the nut is missing. Question It should be a 3/8-32 jam nut, but how can I veri …

I need to cut a header down on an angle to match my stairs. It needs to be cut on a 51° angle, which my circular saw can handle, but there isn't enough clearance under the joists to get my saw in ther …

I have a pair of scissors which I happen to like a lot. Unfortunately, one of the blades is bent towards the other blade, so that a gap forms when the scissors are closed. Bending the blade back with …

I'm trying to take apart an old bed frame. The fasteners are square head bolts, but they're tucked away with only 1/2" of clearance to access them. I can't find square head bits shorter than an inch, …

I've put together a wagon for a child, but I've messed up something. Now I need to remove a plastic cap that has metal bits inside and that goes over the end of the wheel axle. A spare part of this ca …

This tool is used to fix DuPont lighter but that is not its real name please you can help me a lot if you know the real name

How can I repair this to be able to keep using the saw? …

I'm in a bit of a pickle here, so I'm replacing the bolts on my diving board, and I noticed that the brace is bent, in such a way that makes it hard to tighten the nut. There was barely enough space t …