Skip to main content

All Questions

Tagged with
Filter by
Sorted by
Tagged with
2 votes
1 answer
323 views

Can I use subfloor to align a house-length starter row of hardwood flooring to the house, rather than to a single room?

Carpet has been removed and subfloor exposed and cleaned. The floor has been leveled to <3/16" out of flat over 6', primed to cover some pee spots, and is ready for the underlayment. The new ...
J.D. Mallen's user avatar
2 votes
1 answer
377 views

Should I use glued or floating flooring at a beach condo? [closed]

I am putting a new floor down in a beach condo, and I've been told by some that glue down LVP is best for the job, while other contractors are telling me that floating is better. This is a rental ...
SandyBeach's user avatar
0 votes
2 answers
2k views

How to install vinyl flooring around rough edge fireplace?

I am wanting to replace my carpet with vinyl plank flooring but I have a stone fireplace that is kind of jagged stone at the bottom. I am hoping to be able to do the installation myself but don’t know ...
K Hanco's user avatar
0 votes
1 answer
2k views

Laying Flooring Under Water Heater?

Looking to add some laminate under the laundry area of our garage, including a water heater (which is not directly on the floor, but instead on a metal table per previous owners). We're DIYing it and ...
Brian's user avatar
  • 1
0 votes
0 answers
64 views

Should we accept? Split wood/too dark inlay in floor installation

we recently had our floors refinished/installed. In our kitchen, the old linoleum was ripped out, and we had hardwood floors installed to match the rest of the house. The house has an accent inlay in ...
user169751's user avatar
1 vote
1 answer
106 views

Staples or nails for installing this particular type of engineered flooring?

I am installing some engineered flooring in my downstairs and have ordered some silicone "vapor shield" underlayment to place underneath it (between my plywood subfloor and the planks of ...
hotmeatballsoup's user avatar
-1 votes
1 answer
624 views

Hardwood Flooring around Floor to Ceiling Windows

we are in the mist of installing 3/4" hardwood flooring in the house. The great room has several floor to ceiling windows, including around the front door. In the bedrooms and hallway we did not ...
testuser900's user avatar
0 votes
0 answers
53 views

Started putting ceramic planks in home and got as far as putting the uncoupling membrane. Question, can I pull the membrane up and reuse it elsewhere?

I got screwed. Paid someone to put ceramic tile in mobile home. He put self leveler down but he did not mix it correctly and it did not spread out and level out so the floor is not level and he ...
Fullafun1's user avatar
1 vote
1 answer
7k views

Nailing Down a Floating Floor?

I am installing laminate tongue-and-groove floating floors in my kitchen with the aid of my Grandfather. I was always under the impression that a floating floor was just that - not pinned down by glue,...
TheLittlePeace's user avatar
1 vote
1 answer
1k views

Raising Level Of Concrete Floor to Equal Existing Tile In The Same Room

We would like to install vinyl luxury planks in our dining room. We have removed the 20 year old carpet, padding and tacking strips so that the concrete slab is exposed. The room was laid out with a ...
Florida Dawn's user avatar
0 votes
1 answer
5k views

What is this plastic strip inside my laminate flooring?

I'm installing this laminate flooring and noticed a plastic stirp in the groove of each plank. What is it for and should it stay where it is or be removed during the installation? Laminate brand: ...
mishap's user avatar
  • 317
2 votes
2 answers
10k views

Do I need to "fill in" concrete control joints before floating floor installation?

I am preparing to install a laminate floating floor over a concrete slab in my basement. The concrete slab is installed in what appear to be 18' x 18' squares, broken up across the dimensions of my ...
2and2IS5's user avatar
2 votes
1 answer
363 views

Do I glue luxury vinyl flooring ON or UNDER angled, metal threshold that transitions exterior to interior kitchen floor?

I’m installing LVF, gluing to wood floor (tongue & groove flooring). There is an angled piece of metal the width of the threshold, transitioning the exterior threshold into the kitchen. My ...
Donna's user avatar
  • 21
7 votes
2 answers
869 views

Distributed expansion gaps in solid hardwood flooring

I am planning to install prefinished solid 3 1/4" wide by 3/4" thick ash hardwood in my home using 2" cleats. I live in Canada, so the average indoor humidity difference between winter and summer is ...
jLegris's user avatar
  • 118
0 votes
2 answers
895 views

Laminate flooring direction?

I am about to pull up carpet and put down laminate in our home. The previous owners installed laminate in the kitchen and dining room. I am not removing it, they installed it before installing the ...
Bates's user avatar
  • 1
2 votes
2 answers
6k views

Can porcelain tile planks be installed in a crawl space house?

My home is a single story, about 1200 square feet, and is built on a crawl space foundation with a plywood sub-floor. The people we bought the house from had flipped the home after a foreclosure, and ...
ConcernedHobbit's user avatar
-1 votes
1 answer
2k views

What is the proper technique for starting a click laminate install diagonally that is floated?

I'm planning on floating my click laminate floor in a diagonal placement in my space. When researching, I came across an article that describes some of the challenges with installing diagonally. ...
Scott Lin's user avatar
  • 493
1 vote
1 answer
2k views

Can I float click laminate diagonally without transitions in my space?

I'd like to float click laminate on our floor in a continuous manner without transitions. I'd like to float diagonally, but am open to another orientation if this isn't feasible. I understand ...
Scott Lin's user avatar
  • 493
0 votes
1 answer
583 views

Should I float or glue locking bamboo?

I have 800 sq ft of 1/2" locking solid stranded bamboo floor on its way and I'm trying to decide between floating and glue. I'm doing every room on my 1st floor (see attached pic), except for the ...
flynnecf2's user avatar
1 vote
1 answer
122 views

Where should I start laying a nail down hardwood floor in this room?

I am planning on installing a nail-down 2 1/4" hardwood floor in our great room. Each wall of the room has an "interruption", so I'm wondering where the best place to start is. One side has a large ...
Mary's user avatar
  • 11
2 votes
1 answer
1k views

Why is my ceramic tile popping out of the floor?

I have old wood floor. My contractor installs a wire to the floor and then install the ceramic tile over the top. When they dry, the tiles do not stick with the floor. What should I do with these? ...
Richard Sayakanit's user avatar
0 votes
3 answers
2k views

Can I glue two 1" solid oak treads to make one 2" tread?

I am licensed floor contractor in the state of California. I am installing solid oak treads in open steps in stairs 2"x12"x43", because open steps over 39" wide must be over 1 1/2" thick. But, 2" ...
zak 's user avatar
  • 1
1 vote
1 answer
2k views

How much expansion space is need for solid oak flooring?

I have purchased Bruce 3/4" solid oak flooring and I am looking for some guidance with respect to expansion space. This is standard tongue and groove flooring that will be nailed down. This is also ...
Rozwel's user avatar
  • 508
1 vote
1 answer
818 views

Tile over Luan which is glued to a cement floor

Can tile be laid over luan that is glued to a cement floor? WE are updating a second kitchen and bath. pulled up the origianl vinyl sheet lino. Luan is in excellent condition and glued tightly to ...
Phyl's user avatar
  • 11
4 votes
2 answers
1k views

Hardwood flooring installation, first row question

I am about to install engineering flooring for my living room. At first, I plan to start based on wall A (the longest wall, please see image below). However, there is a projection (or indentation, ...
Minghui Yu's user avatar
3 votes
2 answers
11k views

Should I remove and replace base trim or install quarter round when installing laminate flooring?

I want to install laminate over my existing tile floor. The problem is that I have small 3¼" baseboards. If I don't remove the base moldings and install quarter rounds I think it will look ...
Trish's user avatar
  • 41
2 votes
3 answers
12k views

Starting row of laminate flooring

Just wondering how to start the 1st row of laminate flooring. I have a door to deal with right off the bat. Wondering which is the better option (see diagram). This diagram is not to scale. The wall ...
Ariel's user avatar
  • 23
2 votes
4 answers
16k views

How do I cut a brick fireplace hearth to allow for a laminate flooring expansion gap?

I am attempting to cut a small piece out of the brick fireplace (already in place) to allow for the expansion of the floating laminate flooring that I am installing. I don’t want to just leave the ...
SwDevMan81's user avatar
-1 votes
2 answers
4k views

Should I have a break between rooms when installing laminate flooring?

I'm going to be putting in laminate flooring in my basement on top of a concrete slab. The basement consists of two rooms, the boards will be running perpendicular to the wall with the door between ...
John's user avatar
  • 546
5 votes
2 answers
949 views

How Is "Super Laminate" flooring installed?

I recently learned about AABSO "Super Laminate" flooring (aka Vinyl flooring planks). It seems to have some advantages over standard laminate flooring when it comes to moisture resistance so I'm ...
Mike B's user avatar
  • 8,153
19 votes
14 answers
380k views

What direction should laminate flooring be placed in?

I'm thinking of installing laminate flooring and have a question: If I'm installing laminate throughout the house, should ALL of it be going in the same direction? Say for example, let's say I have ...
Mike B's user avatar
  • 8,153