Skip to main content
added 173 characters in body
Source Link
Luiz Borges
  • 2.3k
  • 16
  • 69
  • 83

I want to make a half wall beside a staircase (on the edge of the upper floor). One end will be attached to a concrete column, but the other will be (so far) unsuported. Something like the picture below: enter image description here

What is the best way to ensure that It stays put and strong? If nothing else I will make a square tubing post (100x100mm, 1.5mm thick) from floor to ceiling and attach the drywall to it.

Any other ideas?

EDIT: No wood studs in Brazil, actually it is very hard to get good construction lumber around (most aren't dry, and pressure treated is rare and expensive as hell).

I want to make a half wall beside a staircase (on the edge of the upper floor). One end will be attached to a concrete column, but the other will be (so far) unsuported. Something like the picture below: enter image description here

What is the best way to ensure that It stays put and strong? If nothing else I will make a square tubing post (100x100mm, 1.5mm thick) from floor to ceiling and attach the drywall to it.

Any other ideas?

I want to make a half wall beside a staircase (on the edge of the upper floor). One end will be attached to a concrete column, but the other will be (so far) unsuported. Something like the picture below: enter image description here

What is the best way to ensure that It stays put and strong? If nothing else I will make a square tubing post (100x100mm, 1.5mm thick) from floor to ceiling and attach the drywall to it.

Any other ideas?

EDIT: No wood studs in Brazil, actually it is very hard to get good construction lumber around (most aren't dry, and pressure treated is rare and expensive as hell).

Source Link
Luiz Borges
  • 2.3k
  • 16
  • 69
  • 83

How to prevent half wall (drywall, steel studs) from wobbling

I want to make a half wall beside a staircase (on the edge of the upper floor). One end will be attached to a concrete column, but the other will be (so far) unsuported. Something like the picture below: enter image description here

What is the best way to ensure that It stays put and strong? If nothing else I will make a square tubing post (100x100mm, 1.5mm thick) from floor to ceiling and attach the drywall to it.

Any other ideas?