Skip to main content
Kerry Thomas's user avatar
Kerry Thomas's user avatar
Kerry Thomas's user avatar
Kerry Thomas
  • Member for 6 years, 3 months
  • Last seen more than a month ago
15 votes
2 answers
6k views

Are pressure-treated posts that have been submerged for a few days ruined?

6 votes
2 answers
2k views

Sacrificial Barn Roof

5 votes
2 answers
1k views

How to connect flex NMC to Rinnai tankless

3 votes
2 answers
2k views

Hard-Wiring Sprinkler Controller(s) Into Junction Box

3 votes
3 answers
809 views

Can I split off a 20a with a conduit body?

2 votes
2 answers
3k views

Is solvent fitted 2” pvc safe for use with drinking water?

2 votes
3 answers
1k views

EMT or PVC in Bathroom?

2 votes
2 answers
3k views

OK to bundle wires together in conduit with colored electrical tape?

2 votes
4 answers
32k views

Is it safe to run a propane appliance from a portable propane cylinder?

2 votes
1 answer
669 views

Brand New Propane Range Not Boiling Water

2 votes
2 answers
4k views

What does the Length Dimension of a Rotary Hammer Really Mean

1 vote
1 answer
66 views

Will individual irrigation branches with varying numbers of holes flow at the same rate?

1 vote
2 answers
193 views

Requesting Evaluation of Power Plan at Rural Cabin

1 vote
2 answers
871 views

Cabin Wiring Plan Revisited

1 vote
2 answers
3k views

Will a consumer UPS clean up power from a conventional genetator

1 vote
3 answers
196 views

Can the Distance of a Subpanel affect Outlet Tester Results

1 vote
1 answer
424 views

How should I hang a receptacle on a rim joist?

1 vote
1 answer
206 views

What is a proper size air conditioner for Texas 384 sq ft?

1 vote
2 answers
236 views

Are Ideal Greenie 30-192P Ground Wire Nuts approved for use with stranded wire?

1 vote
1 answer
2k views

Can I combine 2x4 lumber to build posts for barn?

0 votes
5 answers
1k views

Protecting PEX/UF-B/Ethernet from gophers with hardware cloth?

0 votes
1 answer
549 views

How can I drill a hole 8 ft deep through hard sandstone with a rotary hammer? [closed]

0 votes
1 answer
817 views

Is URD #4 Appropriate for 100ft run for generator hookup?

0 votes
2 answers
535 views

Is this the correct cable wiring for a dewalt generator and a Lincoln pro-MIG 180?

-1 votes
1 answer
925 views

Galvanized 5V Crimp roofing screw placement with battens/counterbattens