vidarlo's user avatar
vidarlo's user avatar
vidarlo's user avatar
vidarlo
  • Member for 6 years, 5 months
  • Last seen this week
39 votes
Accepted

Does this downspout design make sense?

21 votes

What are these washers?

12 votes

Small nick on power cord from an electric alarm clock, and copper wiring exposed but intact

7 votes

Turning on light no matter which switch is on

7 votes

How can I stop bolts from loosening over time?

7 votes
Accepted

What's the proper way to secure stranded wire in screw clamps?

6 votes

Is it possible to dangerously short a U.S. power outlet with multimeter probe?

5 votes

How can I tap a M5 hole in hardened steel bearing?

5 votes
Accepted

2x non terminated ethernet cable - size of drill bit

5 votes

Melted electrical outlet

4 votes
Accepted

How to make this pulley system more efficient?

4 votes

Disposal of sulfuric acid in baking soda

4 votes

Is there a standard screwsize / thread for wiring applications?

3 votes

How can I remove a broken thread tap from a metal surface?

3 votes

Can a fridge use a regular socket?

3 votes

Running fiber between buildings. How to enter enter/exit building with proper bend radius?

3 votes
Accepted

Is electrical tape enough to insulate contact that may be touching wall?

2 votes

Can i run cat7 cable parallel to electrical wiring?

2 votes

Will a thin or thick cutoff angle grinder wheel last longer?

2 votes
Accepted

How to run 10 AWG ground wire along basement wall?

2 votes

Does the outer diameter of 4.78 indicate an M4 or an M5 bolt?

2 votes

What is the proper name for this rubber edging trim for fibreglass?

2 votes

How can there be voltage but not power in a circuit when no breaker turns it off?

2 votes
Accepted

Painting central heating radiator

2 votes

I painted over rust with rust-resistant paint. A few days later it's back. How can this be possible?

2 votes

Trying to feed two buildings on a property with one Incoming cable service

2 votes

How does this controller board (and contactors) for Harvia Sauna Stoves regulate the kW that reaches the heating elements?

1 vote

Notification lamp shuts off if any one of 3 phase supply is lost

1 vote

Proper torque specs and cleaning busbar and lug connections

1 vote

How to remove threaded insert that went in wrong?