user avatar
user avatar
user avatar
vidarlo
  • Member for 4 years, 8 months
  • Last seen this week
21 votes

What are these washers?

12 votes

Small nick on power cord from an electric alarm clock, and copper wiring exposed but intact

7 votes

Turning on light no matter which switch is on

6 votes

Is it possible to dangerously short a U.S. power outlet with multimeter probe?

3 votes
Accepted

Is electrical tape enough to insulate contact that may be touching wall?

2 votes

Can i run cat7 cable parallel to electrical wiring?

2 votes

Will a thin or thick cutoff angle grinder wheel last longer?

2 votes
Accepted

How to run 10 AWG ground wire along basement wall?

2 votes

Does the outer diameter of 4.78 indicate an M4 or an M5 bolt?

2 votes

What is the proper name for this rubber edging trim for fibreglass?

2 votes

How can there be voltage but not power in a circuit when no breaker turns it off?

2 votes
Accepted

Painting central heating radiator

1 vote

converting induction cook top wiring into plug

1 vote

how to know if the water valve connection is metal or plastic?

1 vote

Can I double-feed a low voltage DC system?

1 vote

Why do I still read voltage on outlet when I turn off breaker?

1 vote
Accepted

Proper name and origin of tiny drill bit

1 vote

Elegant way to jack two materials apart, applying spreading pressure to pin them in place?

0 votes

Installed ceiling lamp, but phase meter screwdriver lights up when testing its body, neutral line

0 votes
Accepted

Refrigerator leaked water but otherwise fine (Pic of potential problem)

-1 votes

Why do insulated screwdrivers have a maximum voltage that they're rated for?