Skip to main content
Mark's user avatar
Mark's user avatar
Mark's user avatar
Mark
  • Member for 7 years, 7 months
  • Last seen more than 1 year ago
  • Maryland
28 votes
1 answer
20k views

How do I remove this wall plate with no visible screws?

12 votes
8 answers
10k views

Is straight lumber a thing of the past?

9 votes
2 answers
24k views

How to Lubricate a Hammer/Rotary Drill

5 votes
2 answers
4k views

Grout cures too fast in the bucket

2 votes
2 answers
2k views

Dryer vent through cinder block and then through yard - is this ok?

2 votes
1 answer
460 views

Substitute for an electrical clamp, when the wiring is already connected

1 vote
1 answer
10k views

How to wire one switch to two lamps, power at first light, continue to second light, end wiring at switch

1 vote
1 answer
2k views

Basement sliding glass window (Pella) - how to remove the pane opposite of the sash

1 vote
0 answers
155 views

Is a double elbow code-compliant for merging two residential drains?

1 vote
4 answers
3k views

Best way and best tool to file sch. 40 PVC

1 vote
2 answers
14k views

How to seal the hole for a spigot through a stone wall

1 vote
2 answers
62 views

Stuck plastic tile to basement concrete floor

1 vote
2 answers
7k views

Which thinset to connect USG Durock® Brand Cement Board with EdgeGuard?

1 vote
2 answers
2k views

What kind of treatment should I use on bottom wall plates to prevent decay?

1 vote
1 answer
734 views

Should I dig a hole to pump water from under basement?

1 vote
2 answers
4k views

Basement partition wall sole plate - do I need sill plate gasket?

0 votes
1 answer
883 views

HardieBacker with Hydrodefense very difficult to drill

0 votes
1 answer
584 views

What is the best way to re-level wall tile?

0 votes
2 answers
1k views

Where to apply liquid membrane at a tile/drywall ceiling edge in a shower?

0 votes
1 answer
298 views

How to fill in exterior paint on plywood

0 votes
0 answers
587 views

basement drywall over vertical brick surface

0 votes
0 answers
1k views

"Floor-leveling compound" for a Kohler Tresham shower base

0 votes
1 answer
2k views

When marking a door hinge mortise, how far from the edge does the hinge go? New construction, interior door