Skip to main content
Tim Post's user avatar
Tim Post's user avatar
Tim Post's user avatar
Tim Post
  • Member for 13 years, 9 months
  • Last seen more than 1 year ago
14 votes
Accepted

Would running a new subpanel in parallel meet NEC requirements? If not, what should I do?

13 votes
Accepted

How do I add more circuit breakers once the breaker box is full?

9 votes

Is it against NEC code to re-use pulled cable?

8 votes

Why won't the bulbs light even when the fixture is has power?

8 votes
Accepted

Could I use a UPS to power my humidifier on an underrated breaker with a little trickery

6 votes
Accepted

Is there a way to mark/label a special use switch?

6 votes

How can I add/alter wiring inside single-brick walls?

6 votes

What is the correct way to attach a receptacle to a metal face plate?

6 votes

Can I use indoor Romex in buried outdoor conduit?

5 votes

How can I make my sink smell better?

5 votes
Accepted

What is code for installing a dishwasher in the U.S.?

4 votes

Identify type of switch

4 votes

Is this 230V steampunk metal robot lamp safe?

3 votes

What is the purpose of a window well for a window that is above grade?

3 votes

Why does my receptacle tester say open ground on my new outlet?

2 votes

Is it possible to use a power inverter to run a sump pump?

2 votes

Is it OK to have 10ga wire running from breaker to switch then 8ga from switch to pump?

2 votes

Is this a faulty GFCI receptacle?

2 votes

Non-recessed pancake box for ceiling fan

2 votes
Accepted

Circuit breaker trips every couple of weeks

2 votes
Accepted

What is causing the SUPER loud noise from my dryer

2 votes

Correct amps for cooktop and separate oven

1 vote

Can I split a 3 wire circuit into two separate 2-wire circuits?

1 vote
Accepted

Can I extend the ground/bus bar in a main service to accomodate subpanel equipment ground?

1 vote

What could cause a brand new fluorescent fixture to not work?

1 vote

Dual Grounding Electrodes In Parallel versus series

1 vote

How do I choose which breaker breaks first?

1 vote

Can a Knob & Tube live hot wire be left disconnected without the neutral in a switch box?

1 vote

Is there a keyed switch that can be used to power off a subpanel?

0 votes

Breakers tripping