StayOnTarget
  • Member for 6 years, 5 months
  • Last seen this week
  • near Syracuse, NY
5 answers
21 votes
7k views
1 bookmarks
Is this a tool? Or a nail?
10 answers
21 votes
17k views
1 bookmarks
Turning a hard to access nut?
7 answers
18 votes
33k views
1 bookmarks
Caulking a corner instead of taping with joint compound?
3 answers
9 votes
2k views
Are "terminal block" style junction boxes allowed in the US?
4 answers
5 votes
902 views
How can I fill two or more adjacent spaces on a QO panel?
2 answers
5 votes
532 views
Can I add a 'service entrance barrier' to a QOC electrical panel?
3 answers
5 votes
31k views
2 bookmarks
Guidelines for poured concrete over corrugated metal
2 answers
4 votes
8k views
1 bookmarks
How is a pipe nipple's length measured?
2 answers
4 votes
317 views
Can I route the neutral wire from a surge protection breaker across the panel busbars?
4 answers
4 votes
3k views
Is it acceptable to retrofit a new-work plastic electrical box by screwing through it into a stud?
4 answers
4 votes
2k views
What to do with the neutral in a 240V 2-pole hot tub disconnect?
4 answers
4 votes
14k views
What is the proper method to install a "close" metal pipe nipple?
1 answers
4 votes
749 views
Does this small clamp have a special use?
2 answers
4 votes
744 views
How to seal straight-thread faucet shank / nipple to the faucet?
1 answers
4 votes
8k views
Can polyalloy (plastic) pex fittings be used with both styles of attachment rings?
3 answers
3 votes
5k views
1 bookmarks
Is copper clad aluminum wiring safe to use?
3 answers
3 votes
8k views
Manual methods to compact base for concrete?
1 answers
3 votes
4k views
What kind of tubing should I use for draining condensate from a furnace / boiler?
1 answers
3 votes
25k views
1 bookmarks
What are the allowable ways to wire a kitchen range hood? (USA)
2 answers
3 votes
279 views
1 bookmarks
Pex bend supports keep breaking
1 answers
3 votes
49k views
What is the WOG rating for valves?
2 answers
3 votes
161 views
What does "architectural" really mean when used to describe building products?
6 answers
2 votes
13k views
How do you remove a Carrier / Bryant Infinity thermostat control from the wall?
0 answers
2 votes
70 views
What's the term for a rotatable plumbing pipe "union" in the UK?
0 answers
2 votes
71 views
Do push-to-connect (Sharkbite) couplings allow for any thermal expansion?
2 answers
2 votes
2k views
How to remove this PVC to cast iron adapter?
1 answers
2 votes
214 views
Are you supposed to leave the pigtail lead on an GCFI / AFCI breaker curled up?
0 answers
2 votes
244 views
Grundfos Alpha pump shows 0 GPM but consumes power and heating works?
1 answers
2 votes
4k views
Is it required to electrically ground rebar in an exterior concrete slab?
2 answers
2 votes
293 views
Is a noisy / humming GFCI breaker OK?