cathode's user avatar
cathode's user avatar
cathode's user avatar
cathode
  • Member for 7 years, 9 months
  • Last seen more than 3 years ago
5 votes

Is my water contaminated?

5 votes
Accepted

Building a ledger for indoor use with with some cut to size 2 by 4s, should I stain or paint them?

5 votes

How to connect 6x12 AWG wires?

4 votes

Missing front of cabinet drawer, need to sell my house

3 votes

Bubble of air out of toilet when flushed

3 votes
Accepted

Add expansion joints on garage floor - too late?

3 votes
Accepted

How one is supposed to "plug" a conduit running from basement to attic?

2 votes

Can I thread the inside of a steel water pipe (encased in concrete) to safely make a connection to the remainder of the water system?

2 votes

What's the difference between "physical damage" and "severe physical damage" in the NEC?

2 votes

Can you use casing molding for baseboard molding?

1 vote

How can I secure wire fished between two plastic switch boxes?

1 vote

What size wire should I use for a 60amp subpanel?

1 vote

What's a high R-value insulation material alternative to dimensional lumber

1 vote

What types of tubing can I use with Push-to-Connect fittings?

1 vote

In layman's terms how much pressure is 4000 psi?

1 vote

What's the best way to select windows for heating efficiency? I have an older house in a northern climate

1 vote

How do I fill drilled holes on a concrete floor and won't make it look fresh and blend it with existing floor?

1 vote

How can I prevent water from flowing into my carport under the wall plate?

1 vote

What are the risk of floating a solid hardwood above grade floor using a clip system?

1 vote

Acceptable material to cap a brass/copper fitting

1 vote

How do I move the strike plate on my bedroom door down by 1 cm?

1 vote

Can I convert galvanized ducts to wood stove black ducts by coating it with high temp RustOleum paint?

1 vote

How long can I leave a wood fence after pressure washing, before staining it?

1 vote

Compatibility of aluminum fittings with brass rough-in valve

0 votes

How to measure and cut square tiles to make a herringbone pattern?

0 votes

Should gaps be left between sheets of drywall for any reason?

0 votes
Accepted

How should I fix an electric shower pull cord that doesn't work anymore?

0 votes

How do I properly prepare newly-finished drywall for priming?

0 votes

Fixing ceramic tile that have a large ceramic chip off

0 votes

Removing a Schlage door knob with stripped screw heads