Skip to main content
ThreePhaseEel's user avatar
ThreePhaseEel's user avatar
ThreePhaseEel's user avatar
ThreePhaseEel
  • Member for 9 years, 8 months
  • Last seen this week
  • USA
0 votes
Accepted

Old furnace with extra wire, but no c terminal Janitrol, 19 year old furnace

0 votes
Accepted

Looking to replace light switches - 2x blue, 2x black wires

0 votes
Accepted

Need to identify wires coming from external AC Unit

0 votes

I have an unused C wire hooked up to thermostat and have no idea where to connect it to the furnace for power

0 votes
Accepted

Rth5160d1003 New Thermostat wiring from Older 7 Wire Setup o & b wires?

0 votes

Grounding TV Antenna and Metal Porch, And Resolving Ground Rod Issues

0 votes
Accepted

Does code allow for in-wall mounting of low voltage transformers?

0 votes
Accepted

Appliance upgrade

0 votes

Terminating unused wiring in electrical box

0 votes

30a rv box from main panel

0 votes

How do I wire a/c if furnace wiring compartment has no y terminal?

0 votes
Accepted

Where do I put my c wire the un used or c wire for me is blue but where do I connect it to?

0 votes

My 240 volt outlet seems to be delivering 219 volts

0 votes

Rewiring Outdoor Light to Switched Outlet (half hot, half not)

0 votes
Accepted

Will my electrical sub panel handle a HVAC load

0 votes
Accepted

End-line switches for new overhead lighting and new ceiling fan

0 votes
Accepted

replacing toggle switch on furnace red-green with thermostat

0 votes
Accepted

Service Feed Split box

0 votes
Accepted

Connecting a C-wire to a Burnham Independence Boiler

0 votes

Grounding requirements for multipanel, multiservice installation

0 votes

Multiple outlets w/bottom switched from two switch locations

0 votes

Metal clad (MC) cable: cut or rearrange it? Plus other questions on the options to install it

0 votes
Accepted

Help creating a half hot switch: 3 sets of wires

0 votes

Does the ground bar on a subpanel need to be bonded to the subpanel?

0 votes

Should Neutral and Earth be bonded at the meter instead of in the main panel(s) with tandem 200A main panels

0 votes

Bathroom circuits code

0 votes

60 amp Fuse box as junction box for 150a panel

0 votes

Adding Locks to Antique French Door

0 votes
Accepted

Honeywell C wire on a dual transformer system

0 votes

What to do with the neutral in a 240V 2-pole hot tub disconnect?