Skip to main content
ThreePhaseEel's user avatar
ThreePhaseEel's user avatar
ThreePhaseEel's user avatar
ThreePhaseEel
  • Member for 9 years, 8 months
  • Last seen this week
  • USA
7 votes

Can I add a second set of lugs to a 200A panel for a second sub-panel?

7 votes

Always using gray 14/2 outdoor electric cable... indoors and out

7 votes

How can I get 30 Amps @120V using several 12AWG and/or 14AWG cables?

7 votes
Accepted

Should I run cable through pipe?

7 votes
Accepted

How to find out what breakers are compatible with my panel?

7 votes

Is it OK to borrow a ground wire from a different circuit?

7 votes
Accepted

Should I install GFCI outlets or run new grounded cabling in my older home?

7 votes

Do I NEED to use correct colors when wiring always?

7 votes
Accepted

Looking for or adding a ground to an existing NEMA 10-30 socket

7 votes

Are LED's always necessary/desirable?

7 votes
Accepted

Connecting 6 gauge aluminum wiring to 10 gauge copper with AlumiConn

7 votes

Efficiency of a heat pump water heater during the winter

7 votes
Accepted

Can I use a single 20-amp breaker for a bathroom and adjacent small bedroom in my basement?

7 votes

Code: How can a transfer switch not switch neutrals?

7 votes
Accepted

Can I use 14 AWG pigtails on a 20 amp 12 AWG circuit with 15 amp receptacles?

7 votes
Accepted

How to wire programmable switch to only a single set of white-black-ground wires

7 votes
Accepted

HELP!! Why is my stove turning my lights and furnace back on when they go out?

7 votes
Accepted

Wiring for 120 now with 240 option later?

7 votes

Are all ground wires inside electrical junction box grounded?

6 votes
Accepted

Are outdoor receptacles required to be GFCI receptacles in the US?

6 votes

multi tester showing 10 volts on in active wire

6 votes

What is the proper method for repairing insulation nicks in wiring?

6 votes
Accepted

Remove old ceiling pancake (pan) junction box, or how to work around bolt in that box?

6 votes

NEC code regarding grounding and conductor pass through

6 votes

Discovered 10/2 wired 3-prong receptacle for dryer. Is it ok to leave as is?

6 votes

Electrical wire to use w/ 240V outlet for EV charger?

6 votes
Accepted

Electric Bidet Toilet seat started tripping GFCI

6 votes
Accepted

Are splices made with insulated cable connectors required to be inside a junction box?

6 votes

Is it safe to enable a service panel that has been recently flooded?

6 votes

How bad is it for my A/C unit if I cut the power while it's working?

1
5 6
7
8 9
82