Home Improvement
ThreePhaseEel's user avatar
ThreePhaseEel's user avatar
ThreePhaseEel's user avatar
ThreePhaseEel
  • Member for 8 years, 11 months
  • Last seen this week
  • USA
Profile Activity

2,389 Answers

Score Activity Newest
13 votes
Accepted

Crimp spade connectors in breaker box?

13 votes
Accepted

Can you use a 2 pole 2-slot wide breaker to provide 240V?

13 votes
Accepted

code-compliant to put smaller main breaker in a load center?

12 votes

What did I do wrong when replacing a switched power receptacle?

12 votes
Accepted

HPS lamp goes on and off all night long

12 votes

Question about wiring multiple lights in parallel as well a multiple lights in a parallel 3 way

12 votes

Why is there a jumper wire between the hot screws on my outlet?

12 votes
Accepted

What are the allowable ways to wire a kitchen range hood? (USA)

12 votes

Can I put three NM 12 awg wires into a breaker box knockout?

12 votes

Is it safe to swap a 30A "Dryer Socket" with a 40A "Range Socket" if the breaker is 40A?

12 votes
Accepted

Properly grounding junction box for conduit transition

11 votes

Electrical outlet in low voltage bracket?

11 votes

Why is this shared-neutral wiring bad?

11 votes

GFCI and "normal" outlets

11 votes
Accepted

Can I use 12-2 wire on a 20amp breaker to power an entire bathroom?

11 votes
Accepted

Safe to use a 16 amp motor on a 20 amp circuit with a 15 amp outlet?

11 votes
Accepted

Swapping wires in electrical panel to move outlets to different phase of service. Is this safe?

11 votes
Accepted

Can I use different wire gauges in quick disconnect and from panel?

11 votes

Can I use three 2-wire Romex runs to wire 5 switches?

11 votes
Accepted

What kind of wire can I use in my crawl space?

11 votes

Water shut off valve and backflow preventer

11 votes

Circuit breaker tripped and stuck, can't turn off

10 votes

What should I leave in the walls to allow me to fish future wires?

10 votes

Why is XHHW more costly than other similar cable?

10 votes

Breakers loose in main panel, does whole panel need to be replaced?

10 votes
Accepted

Are all wall-switch dimmers created equal? If not, what are the differences?

10 votes

neutral bar is burnt

10 votes

Why aren't GFCI and AFCI breakers combined or used together?

10 votes
Accepted

Bathroom fan fluctuates in power when using countdown timer switch

10 votes
Accepted

Odd wiring setup in light switch

1 2
3
4 5
…
80

Your privacy

By clicking “Accept all cookies”, you agree Stack Exchange can store cookies on your device and disclose information in accordance with our Cookie Policy.