Skip to main content
Jack's user avatar
Jack's user avatar
Jack's user avatar
Jack
  • Member for 10 years, 6 months
  • Last seen this week
  • WA
25 votes

Should gaps be left between sheets of drywall for any reason?

20 votes

Best location to install floor door stop

20 votes
Accepted

How to cut wood panel for angled ceiling?

20 votes

Why do many construction projects leave so many nails behind?

19 votes

Is this a stress fracture or natural cedar characteristics on a swing set?

18 votes
Accepted

Can I put a 6" hole in this ceiling joist?

18 votes
Accepted

When is pipe dope/tape needed?

17 votes

How to sand/smooth out this uneven/chipped wood?

16 votes
Accepted

How do I cut an arc in a pine board?

15 votes

Tongue and groove floorboards - which way up?

15 votes
Accepted

Why does a laundry drain need to be installed at a minimum height of 30"?

14 votes
Accepted

Using a board when studs don't line up

14 votes
Accepted

Is it reasonable to expect to be able to cut down a cheap slab door to size?

13 votes

Replacing hardwood floor in 100 year old house with no subfloor

12 votes
Accepted

Removing water from oak hardwood floors

12 votes
Accepted

What are these metal tags attached to my poured concrete basement wall?

12 votes
Accepted

What is this tool set for?

10 votes
Accepted

Grout or caulk between acrylic bathtub and tile?

10 votes

How to properly install tongue and groove plywood subfloor?

10 votes

Why can't I drive this Tapcon into concrete?

10 votes

Baseboard corners seem wrong but contractor tells me this is normal

9 votes

Can I install heat mat and backer board over cork flooring?

8 votes

What is a NON-self-tapping screw? What does self-tapping mean, really?

8 votes
Accepted

Having difficulty fixing my sagging door by bending its hinge

8 votes
Accepted

Concrete sealant vs spraying to cure a concrete slab

8 votes
Accepted

Should I install soffit or gable venting with a 3:12 pitch roof?

8 votes
Accepted

Is it possible to remove and replace base molding, and not have to repaint the wall?

8 votes

What's the best material to use to fill in a 1/2" gap between drywall and stairs?

7 votes

Caulk or Grout the base of a toilet?

7 votes

Can't replace hardwood floors, what are my options?

1
2 3 4 5
47