Skip to main content
Dave Tweed's user avatar
Dave Tweed's user avatar
Dave Tweed's user avatar
Dave Tweed
  • Member for 11 years, 4 months
  • Last seen more than a month ago
  • Lowell, MA
9 votes

Toaster oven makes my kitchen lights flicker

9 votes

Identifying wires in junction box

7 votes
Accepted

Will a GFCI device work on circuit where the neutral is switched?

6 votes
Accepted

How far can I run a DC line to some LEDs

5 votes
Accepted

Can you run 230v powertool on single pole 20 amp breaker?

5 votes
Accepted

237V seen across terminals of a dimmer switch when 'off'

5 votes

What could cause my boiler to provide hot water, but not heating?

5 votes

Can a plumbing vent pipe be vented horizontally?

5 votes

One-way switch. Why is a separate pvc conduit used?

4 votes

Is this a compliant way to control three circuits with two switches?

4 votes
Accepted

Close Garage Door?

4 votes
Accepted

Can I wire my under cabinet lighting in parallel?

4 votes

Danger of Christmas lights on aluminum trees

4 votes

Indicator with two-way switch

3 votes
Accepted

LED strip forgets last setting when turned off

3 votes

Why do type 2 SPD’s* require overcurrent protection (*load side, mains, Surge Protection Devices)

3 votes

Is it OK to draw different current from L1 and L2 on NEMA 14-50?

2 votes

Is this old doorbell 12V or 220V?

2 votes

Best way to divide TV roof antenna to several rooms

2 votes

Transformer core size and breaker size

2 votes

How can I verify that the protective earth/ground is separate from the neutral wire in an electrical AC installation?

1 vote

How to drill a groove to the side of a plywood board?

1 vote

Why does one outlet trip the breaker, but not others?

1 vote

Did my home's builder not properly protect the outside molding from water?

1 vote

Remove interior concrete chimney

1 vote

Recurring banging in water pipes, cured by draining system

1 vote

Is using a shielded industrial cable a bad practice when used as an outdoors AC mains cable?

1 vote

Is there is a Standard on how much main service panel / main circuit breaker amps should be?

1 vote

Borewell circuit box button coming out

1 vote

How many terminal bars N / PE do I really need?