I don't have enough clearance to install a filler plate because of a power meter for load shedding EVSE that touches the electrical panel cover. See photos. What other options do I have? Is welding a previously removed twistout an option?

[![enter image description here][1]][1]
[![enter image description here][2]][2]
[![enter image description here][3]][3]
[![enter image description here][4]][4]
[![enter image description here][5]][5]

**Update 1:** Since I was asked, here are photos of the meter and the EVSE:

[![enter image description here][6]][6]
[![enter image description here][7]][7]
[![enter image description here][8]][8]
[![enter image description here][9]][9]
[![enter image description here][10]][10]


**Update 2:** I moved the meter in a small compartment at the top left, mounted it on a stick-on DIN rail and now I was able to properly put a filler plate. See photos:

[![enter image description here][11]][11]
[![enter image description here][12]][12]
[![enter image description here][13]][13]
[![enter image description here][14]][14]


  [1]: https://i.sstatic.net/delfC.jpg
  [2]: https://i.sstatic.net/UMrzi.jpg
  [3]: https://i.sstatic.net/p1kzK.jpg
  [4]: https://i.sstatic.net/0hbnW.jpg
  [5]: https://i.sstatic.net/U1Nh9.jpg
  [6]: https://i.sstatic.net/dccAs.jpg
  [7]: https://i.sstatic.net/E4gmZ.jpg
  [8]: https://i.sstatic.net/bhKBW.png
  [9]: https://i.sstatic.net/d0Zzx.jpg
  [10]: https://i.sstatic.net/7uM63.jpg
  [11]: https://i.sstatic.net/UBliQ.jpg
  [12]: https://i.sstatic.net/mzrAH.jpg
  [13]: https://i.sstatic.net/0HYOu.jpg
  [14]: https://i.sstatic.net/DdMno.jpg