Questions tagged [wire]

Questions about wires, usually seen in electrical applications. Questions with this tag are typically about sizing wires appropriately for the projected usage, but could also be about properties of or problems with a wire.

Filter by
Sorted by
Tagged with
2
votes
2answers
55 views

Removing a switch

I have a light switch that turns on an electrical outlet. I want to remove the light switch completely and leave the electrical outlet always "on". When I turned the power off to the room and ...
0
votes
2answers
44 views

Ground Wires in Bathroom Vanity Light

I am replacing a vanity light in my condo. I removed the old fixture, which was a cheap long shallow box with five round bulbs. Lo and behold, there was no junction box behind the fixture, as all ...
1
vote
2answers
56 views

RCD wiring with heating cable

Hi, I want to use the heating tape (constant wattage) and I was told that I should use RCD for the safety. I am new to RCD so I wanted to double-check if this is a correct way to wire the RCD with ...
1
vote
1answer
36 views

Separating 2 Light Switches (1 is a 3 way) Hardwired Together

I have 2 light switches (in one box) in my laundry room. The one switch is a 3 way which operates the light in my garage (just behind the laundry room). There is only 1 switch to the laundry room. I ...
0
votes
0answers
83 views

Does this wire covering contain asbestos?

I am wondering if anyone (who actually knows) can say whether this wire is likely to contain asbestos. Thank you in advance! Jack
0
votes
0answers
37 views

How to extend a power outlet from an existing outdoor light

There is an outdoor light owned by HOA, located outside of the door of my apartment unit. And I'd like to install a security camera near the light. There is no outlet there, and How can I extend an ...
1
vote
4answers
1k views

Can I connect 12 gauge wire to 18 gauge wire for an outdoor light post and plug?

I am replacing a front yard light post that has a GFCI outlet attatched. The old post has 12 gauge wire connected from the house thru the post and outlet to the the light. The new post is prewired ...
2
votes
1answer
105 views

Reading electrical clamp tester higher voltage/amp 400A

A sub panel CH 60AMP 3 Pole breaker keeps tripping. I'd like to test the AMPs on the three wires. My clamp tool measures 7.9A while on the 400A AC setting. That seems awfully low to trip a 60 AMP ...
1
vote
0answers
99 views

Is this cloth jacket surrounding my electrical asbestos?

Checked to see what was going on behind the electrical socket, and discovered this fibrous wire insulation. Also, I think who ever installed this 3 prong outlet in the first place did so illegally ...
5
votes
2answers
795 views

How to repair basic cable/wire issue for household appliances

I have a set of very old computer speakers that works fine except for one problem. One of the wires connecting to the volume control dial is loose, so that if the wire is jostled or flexed, the ...
0
votes
0answers
51 views

Remaining AC Voltage [duplicate]

So I have a three switch box and one goes to a light/receptacle outlet on the wall. The other two go to my ceiling fan. When I read the wires out when they are switched off I get 0vac. When I turn ...
1
vote
2answers
85 views

Voltage/current stabilizing

I am running a wire 300+ feet. I'll need to place a transformer every 100 feet that would maintain voltage/current, therefore I wouldn't get any drop so that I can maintain 110vac 20 amp. Which ...
0
votes
1answer
32 views

Recessed Lighting Junction Box Cord

A little while ago I bought some of the below recessed lights for the basement. Had an issue where one wasn't working so I punched a hole into the ceiling and pulled the junction box down, re-nutted ...
0
votes
0answers
48 views

higher amperage rating

Ok, I live in an historical home and am required to minimize the visual imperfections {conduit} So I would like to get the highest amperage capacity possible running #6 wire so I can stick to 1" ...
0
votes
2answers
125 views

I need a 'female' 120V AC Plug / socket for a wall plate?

I cannot find what I am looking for anywhere, I don't even know what to search. Something that would be the child of these two, if they had one. I realize you can buy a kit that includes this piece, ...
0
votes
1answer
35 views

grounding wire extension

I have an above ground pool which was grounded for safety. I had to buy a new pump (motor) and unfortunately the ground wire was too short to reach the pump. I had to move the filter and pump to reach ...
0
votes
0answers
47 views

Ground wire goes nowhere from another property into mine

I live in a flying freehold and doing a renovation found a yellow and green ground wire that goes nowhere from the property below.Is it safe to cut it?
0
votes
2answers
68 views

How to find heater wire cut?

I have an old and damage sidewalk with a heater wire inside it. The wire is cut somewhere but I don't know how to find where. Is there any electrical tool or way to find where is it cut? This is ...
0
votes
1answer
65 views

Removing light switch permanently

I have a light switch that powers an outlet when it's turned on. I want to remove the switch, connect the wires and make the power in the outlet permanently on. In that case, what am I supposed to do ...
4
votes
2answers
1k views

Can't find the release for this wiring harness connector

I am unable to unlock any "tabs". The video text just says use a slot screwdriver to release the locking tabs. Any help is appreciated.
0
votes
1answer
30 views

How to attach old style stacking wire in-basket brackets

Old style stacking wire in-baskets have a heavy wire that is used for the stacking feature. How are the other ends of the wire attached to the next basket in the stack?
1
vote
1answer
122 views

Electric range stove burned black hot wire

Ok. So my range has burned off one of the 2 black wires on the terminal block, which I'm assuming was due to a loose connection. My whirlpool range goes to a 50A breaker. There is 2 red /1 white/ 2 ...
2
votes
2answers
194 views

Kenmore Elite Refrigerator Door Pinched / Broken Wires

TLDR; What is the best way to splice wires together that will be moving? I purchased a Kenmore Elite 106.51773510 refrigerator in March 2017. I had a few issues with the ice maker during my first ...
2
votes
2answers
231 views

TV cables getting stuck in conduit after mounting TV on fireplace

We are first time home owners and trying to learn basic things. We mounted our TV ourselves yesterday. I'm now trying to hide the wires. There is already a rugged conduit (something like this) behind ...
0
votes
2answers
49 views

dishwasher wiring

so the power cable I need to hook up to dishwasher has one white one tanish color and then the ground so do I go white whit black to the tanish and then green to ground the bare copper one?
0
votes
1answer
55 views

Can I use a terminal wire kit meant for a dryer on an electric range stove?

So one of the terminal wires on my families range melted off (one of the black wires) which was probably caused by a loose connection and they ordered a terminal kit but apparently it's meant for ...
0
votes
2answers
64 views

Power cable for DVD Player too short

I recently wall mounted my TV and put a shelf underneath for my dvd player. Unfortunately the power cable for the dvd player is too short. I've searched and searched for dvd players that have either a ...
3
votes
1answer
65 views

Should I increase wire size when extending a 75 foot circuit to reduce voltage drop?

I have a 1200W smoker which I currently hook up to an outdoor outlet. The outlet runs on about 75' of 12 gauge wire from a 20A breaker. There is nothing else on that circuit. I am moving the outlet to ...
0
votes
0answers
78 views

Rubber electrical tape safe under code for attics?

I'm buying a house. The attic had a wire with frayed outer insulation. I negotiated repair of the cable. The seller has responded that the repairperson wrapped the fray with rubber electrical tape (...
0
votes
2answers
216 views

Fan and Light Switch Reversed

I have a switch in my master bedroom that my family replaced. The controls are switched. The fan turns on when you put the light switch on and the light turns on only when the fan switch is all the ...
2
votes
3answers
174 views

Hit wire on concrete wall while drilling a hole - problem?

Hit a wire while drilling a hole on a concrete wall. Didn't feel like hitting anything, except there was a short, spark, and tripped the breaker. With the breaker back on, haven't noticed any ...
9
votes
4answers
2k views

Want to switch to tankless, but can I use my existing wiring?

The tankless water heaters I am looking at require 8 AWG wire but the existing wiring is 12 AWG. Can I do this without having to rerun new wire?
0
votes
0answers
40 views

Multiple port in-line push-in connector?

I've been working in some very tight light fixtures lately, and it was basically impossible to get the wires with wire nuts tucked into the fixture. So I came across multi-port push-in connectors, ...
0
votes
0answers
24 views

What's the deal with the 18ga wire in a light fixture? [duplicate]

I always read "rule #1: never use less than 14GA wire on a 15A breaker, and never use less than 12GA wire on a 20A breaker". The idea being that if the circuit gets to the max current allowed by the ...
3
votes
1answer
528 views

Does copper wire need to say it's copper?

I just saw this picture of wire. Pirelli Cable-X - 500 MCM Type THHN or THWN-2 600V Gasoline & Oil Resistant II AWM (UL) Wait a minute. It's routine common THHN, like you might use in a ...
0
votes
2answers
95 views

QT/tandem breaker wire gauge

Can I use a 14-3 Romex for two different electrical circuits on a 15A QT/tandem breaker? Or should I use one 14-2 for each? My mistake, apologize. Post edited: the QT breaker is a space saver. My ...
1
vote
1answer
243 views

Replace wire terminal connector to heating element

I have GE Range JB640SR3SS and one of the element wire connector got burnt out: https://www.searspartsdirect.com/model-number/jb640sr3ss/0432/0124111.html I cut it and here are the photos front and ...
0
votes
3answers
79 views

Soldering AC wires to this PCB [closed]

I'm working on a DIY Mirror Touch frame and am on the final stages connecting everything. I have the issue where I was unable to find a deep enough aluminum frame and therefor have the issue where ...
2
votes
4answers
527 views

What size wire gauge for 1000ft service run?

Want to run wire 1000 feet under ground from pole to house. Will be using 100 amp service single phase. Would like to know what size gauge of wire should I use.
1
vote
0answers
100 views

Name that mystery switch!

I've seen other similar questions (How to trace mystery switches), but I have some more details: This is in a master bedroom There is a 2 gang box right near the inside of the door - one switch (...
0
votes
1answer
108 views

NEC 422.16(B)(2) Built-in Dishwashers and Trash Compactors Requirement

According to the titled part of NEC, "(4)Receptacles shall be located to protect against physical damage to the flexible cord." I have installed a dishwasher recently, but the plugged to a receptacle ...
0
votes
3answers
358 views

Can I use 14 gauge wire on a 20 AMP electrical circuit? [duplicate]

Running 12-2 Romex cable from the electrical panel to a J-box located in attic. J-box will connect two GFCI outlets and extend a 14-2 cable to the ceiling light fixture box, where other 14-2 cable ...
1
vote
3answers
126 views

What is this thing for?

I've been shopping for houses and found this gadget in the garage. It's up near the ceiling and I don't know what it is for. There's nothing nearby that would give any hints. My image is ...
1
vote
2answers
69 views

Broken wire inside Rangehood, advice needed

My range hood was damaged, which caused it to flare up and spark. I immediately powered off the main to the house (as in the pictures). I can see that the connection has been damaged. I have no idea ...
2
votes
0answers
178 views

C-wire on Weil-McLain CGA Series 2

I have an old thermostat with only 2 wires connected to my Weil-McLain CGA Series 2 boiler. I would like to replace it with a Nest thermostat. I need to add a C-Wire in order for it to work. Luckily, ...
1
vote
3answers
440 views

Can 14/3 wire, with all three conductors hot, be the only cable in a switch box?

I currently have a bathroom light and a single pole switch at the door. The power for the light first comes into the ceiling box directly above the light. The hot is tapped in right there by using the ...
7
votes
4answers
2k views

Will my breaker accept #10 wire even though the chart lists #14?

I am hooking up a disconnect for heating air unit. The instructions state use a 25 amp 2 pole breaker with 10-2 wire. The breaker says wire size 14-2. It is an Eaton BR225 beaker. Will it work with 10-...
1
vote
1answer
158 views

Is a horizontal hang track necessary for wire shelving installation?

Can I install 2/4 shelves on three of four vertical standards without using a horizontal hanger? Verticals will be going into studs.
1
vote
3answers
188 views

How can I extend an electric wire without a large cross-section connector?

I want to extend a couple of electric wires coming out of a ceiling to get to a hole at the top of a lighting fixture. Let's assume for the sake of discussion the lighting fixture is fixed and will ...
4
votes
2answers
2k views

Household Wire Insulation (Asbestos Risk?)

So I am redoing light fixtures in my 1946 house located in the USA. I guess I'm overly scared of asbestos, and just wondering on your opinion if this household branch wire is asbestos containing. It ...