Questions tagged [washer]

The tag has no usage guidance.

Filter by
Sorted by
Tagged with
1
vote
2answers
72 views

Which side are these washers supposed to go?

I’m trying to assemble this trolly and the instructions are blatantly useless. Attempting to check it from the box picture, I was convinced that the washer goes on the nut side, but as I tried fitting ...
0
votes
1answer
28 views

Old-style Kenmore washer door switch

Is there an adjustment I can make to the door switch plate? It's the top loader, old style door lid switch with the little pin in the lid that makes contact with the switch plate when the lid's closed,...
1
vote
0answers
39 views

GE brand new front load washer trips breaker every single time within 5 mins (model GFW850SSNWW)

GE brand new front load washer trips breaker every single time within 5 mins (model GFW850SSNWW). Connected to a GFCI protected outlet (does not have TEST/ RESET buttons on it) and GFCI breaker (SWD ...
1
vote
2answers
127 views

Solve washer/dryer closet outlet issue. Lacks 110v outlet, need to know my options

I have a washer/dryer closet with a SINGLE 220V outlet serving a SINGLE laundry-center type machine. I need to make another 110V outlet available in this closet space so I can upgrade to a SEPARATE ...
0
votes
1answer
63 views

How tall should my washing machine standpipe be?

My drain line to the vent is pretty high/long ( had to avoid some other plumbing ). How tall should the standpipe be? Is there height requirements for the box itself? Also, I have the option of ...
1
vote
0answers
24 views

Using a single pipe off the main drain for a washer and utility sink, venting?

I am renovating my bathroom. I am using this as an opportunity to additionally: Move my washer and dryer from the mudroom, into the garage. Add a utility sink to the garage. The current plumbing ...
1
vote
0answers
27 views

Samsung Washer turns itself ON

My samsung washer has started (4 time over 5 days now) turning itself ON. Yes ON. No lights on front panel but it sounds like it is draining water although it is empty. When I open the door, it ...
2
votes
1answer
60 views

Samsung washer trips breaker during spin

I appreciate any help. I have a 5.6cf Samsung washer. Model WF56H9100ag/a2. It pops the circuit breaker mid spin cycle. It’s only 4 years old and has not moved. I have opened up everything except the ...
2
votes
1answer
351 views

Rocks in Washing Machine?

We recently purchased a home that had the washer and dryer left behind. The washer is a GE and in good condition. We were told by the previous owners that the washer worked fine, but we tested it with ...
8
votes
3answers
2k views

How to combine flat and split lock washers on a bolt

So I'm assembling a pull up bar and its assmebly instructions look like this In the parts list it mentions only one type of spring washer (quantity 4). But it actually came with two types of ...
0
votes
0answers
53 views

Pipe leak occasionally when washer is running

So this has been a very weird case for a few months. We have sent at least 6 different plumbers there for over 10 times and nobody could find out the reason. What happens is sometimes when the ...
0
votes
0answers
15 views

Brand new Whirlpool Cabrio washer makes a snoring sound during agitation. Normal or trouble?

During the agitation cycle, the washer makes a snoring (cloking) sound. I had it replaced and the second one makes the same noise. What could the reason? Brand newew Whirlpool Cabrio washer.
0
votes
0answers
20 views

Install washer drainpipe

I have a washer currently draining into a utility tub sink. We heard a horror story about kids putting toys in the sink and the washer drainage flooding the house. I want to remove the drywall to ...
1
vote
0answers
22 views

Washer doesn’t spin

I have a top load direct drive whirlpool washer. It does not spin at all in the spin cycle but the motor,pump,motor coupler spins. I checked the drive block and no wear or tear. I replaced the clutch ...
0
votes
0answers
28 views

Installing 2 pull 30 amp breaker on 30 amp panel

Am I able to run a 2 pull 30 amp breaker on a 30 amp panel for a washer and dryer? It seems the whole house is running on 30 amp main breaker
0
votes
1answer
120 views

Washer Does Not Drain Water Before First Spin Cycle Begins

My Maytag Atlantis 2005 washer begins the first spin cycle as soon as the first wash cycle ends. So, the spinning starts with a full load of soapy water. Isn't it supposed to drain all the way down ...
1
vote
1answer
298 views

Screw and washer should go through flat area or curved?

I have a screw with a washer. Which one of the two sides should it go through (ie which side the washer should be "in contact with"), the flat or the curved one? The structure is symmetrical so it can ...
3
votes
1answer
393 views

Kitchen drain causes basement laundry drain pipe to overflow

We have a setup where our washer is in the basement directly below our kitchen sink. From the looks of it they both drain directly into the same sewer/drain line. To the right of the washer is a floor ...
0
votes
1answer
38 views

Washer outlet extension after adding wall tile

This is the washer hot and cold water before I added tiles After I installed tiles, the connection was flushed to the tile so I had to add an extension To me, this is an ugly hack because it makes ...
0
votes
0answers
49 views

Changed washer in shower and now it squeaks at low volume

I changed a standard rubber washer on the cold water in my 50 year old shower and now the cold water makes a steady, high pitch, squeaking noise at low volume. The squeak changes pitch as I turn the ...
0
votes
1answer
41 views

Help with washing machine installation

I purchased a washer and dryer from Best Buy and the guys came to install it in my home. They told me they couldn’t finish the installation because they said there’s typically only one drain outlet ...
1
vote
3answers
4k views

Should I put a surge protector on a washer or dryer?

I think the question title says it all, but is there a reason that I should or should not put a surge protector on my washer or dryer? Growing up, I don't recall ever seeing them in my parents' house ...
1
vote
1answer
393 views

Speed Queen washing machine stopped working mid-cycle

I have a Speed Queen washing machine model AWN432SP111TW01, serial 1110013649. It's been working fine for years and we had never had any trouble with it, but today it stopped mid-cycle, and won't ...
1
vote
2answers
426 views

New washer overflows from the stand pipe

I just got a new washer and it’s overflowing from the stand pipe. My old washer was in the same stop and the standpipe never overflowed. I took a garden hose and put it in the drain and let it run for ...
0
votes
0answers
182 views

Samsung Washer WF218ANS-XAC -is it worth repairing?

This question branched from this one Samsung Washer WF218ANS-XAC troubleshooting help needed, smoke in the drum compartment The long story is in the thread pointed above. Short story..it broke and ...
2
votes
1answer
754 views

Samsung Washer WF218ANS-XAC troubleshooting help needed, smoke in the drum compartment

I think that our washer is toasted and I would like to know if it can be fixed before I decide to buy another one Here is the history of this issue: Yesterday my wife was doing the laundry and the ...
0
votes
0answers
1k views

washing machine makes clicking noise but won't start at rinse cycle

Frigidaire stackable washer/dryer The washer does the wash cycle normally and drains the water. Then it re-fills for the rinse cycle. The motor clicks like it is trying to transition to the spin ...
0
votes
1answer
508 views

How do I remove this Electrolux drum paddle?

I have a Simpson SWF-1076 (now owned by Electrolux). The paddles look exactly like this Electrolux part no. 50249701009, though I can't be sure it's the same underneath. How do I remove this design ...
0
votes
1answer
88 views

Flexible duct behind dryer looks a little sketchy

So we just noticed that the air flow in our house is always bad when we run the dryer. Looking behind the unit, we found a foily looking mess of a flexible duct behind the dryer. It looks almost like ...
1
vote
1answer
1k views

GE washer fills, then drains

11/29/18 Moved into a condo and inherited this laundry pair. I have same exact problem with the washer as OP on 02/19/18 except model # is GE GFWN1100L3WW. Washer fills with plenty of water, drum ...
1
vote
1answer
2k views

Where do you put multiple washers when you have a bolt and a threaded hole?

I bought a bed second hand, and it came without instructions, the bed posts have threaded holes, for bolt to go into, and the bolts have a locking washer, and a bigger bigger, flat one. I wish to know ...
0
votes
0answers
2k views

Washer drain pan installation

I am trying to install the drain pan for the washer. I found the pipe to fit in the drain pipe underneath the tile.(when I put 3/4 inch pipe inside the pipe underneath the tile, it goes few inches ...
0
votes
3answers
240 views

Washer drain pipe flush against outside wall

I am looking for a way to fix an every winter, problem with the drain pipe from our washer. We live in Alaska and we have a 1960's built ranch with no basement but crawl space under entire house (no ...
0
votes
1answer
78 views

How to physically disable the “large load” option on a washing machine?

My old washing machine has 4 options (with the highest setting to be "large load"). How can I physically disable the dial in such a way that the large load will no longer be an option for the users?
1
vote
1answer
50 views

1~60 Hz can be used as 50~60 Hz?

I purchased a pressure machine of KARCHER for car wash purpose from Saudi Arabia. In the catalogue it is written 1~60Hz whilst in Pakistan 50Hz cycle is used. The question is if the 1~60Hz unit can ...
1
vote
3answers
152 views

What is the proper name for this type of washer?

I'm trying to find a replacement for a washer / spacer that I lost, and it looks like this: I know I need one that's M5 in size, and can probably measure the length of the one I've got remaining. But ...
0
votes
1answer
2k views

Shower valve washer on hot needs replacing constantly

We've got a setup very similar to the picture in the answer to this: 3 valve shower allowing flow to tub and shower I've read some similar questions here, but none is just like this: The washer, ...
2
votes
1answer
205 views

Why is there a wave spring washer and a plain washer between these two sealed bearings? [closed]

I replaced the bearings in my Vitamix blender and I’m curious as to why there is a wave washer and a plain washer with a smaller diameter in between the two sealed ball bearings. My guess is that the ...
1
vote
2answers
4k views

Can you use dishwasher hoses for a washer?

I have a small apartment kitchen, and would like to add a small washing machine/dryer combo Taps on the kitchen sink are 1/2 inlet and 3/8 outlet. Drain on the sink is 1 1/2" feeding into 2" plus ...
1
vote
0answers
204 views

How to fit 3 pipes into 1 laundry box drain?

I am trying to install an LG TwinWash washer + pedestal washer combo in a new 3-story townhome. Laundry room is on the 3rd floor. The 2-washer combo requires 2 drains. LG supplies a part to merge them ...
5
votes
3answers
419 views

Are the washer drain and electrical outlets underneath up to code?

My daughter got her washer and dryer only to find out that the water supply/drain is 6 feet from the ground. Obviously none of the hoses can reach. I am aware that the maximum height for washer ...
3
votes
0answers
295 views

Can I easily add a drain for my basement laundry? [closed]

We just bought a house. The basement has a receptacle for an electric dryer, and taps for hot and cold water, but no drain for a washer. Would this be an easy fix? Don't know why they would have hot ...
1
vote
1answer
4k views

Tap keeps dripping even after reseating - broken?

I've replaced the washer in the tap and used a reseating tool, but when I feel with my finger there's what appears to be a "notch" in the area the tap washer would be pressing down on. Picture is ...
0
votes
0answers
175 views

My Maytag Atlantis washer spins but doesn't agitate

I have a Maytag Atlantis washer and I replaced the water pump because it was seized up and the belt couldn't turn it. Before I turned it on to test it, the center pulley spins easily in one direction ...
0
votes
2answers
10k views

Can I convert a 240v plug serving a stacked washer/dryer to 120v plug to serve the washer only?

I have a stackable washer dryer combo with one 240V plug. The dryer works on 240V and the washer works 120V, but they have 1 control panel. The dryer died and the room only has one 120v and one 240v ...
0
votes
2answers
139 views

Front load washer doesn't power up unless I hit it with hand

I've a problem in my fully automatic front load washer that is explained in this video https://youtu.be/wFKcGBseDgs As I mentioned in the title of the question, The washer won't power up until I hit ...
9
votes
3answers
2k views

What is a carriage bolt washer with mounting spikes called?

The "washer" below is from a carriage bolt. It's like a t-nut, but used on the square side of a carriage bolt and holds it steady. I'd love to get my hands on a box of these but can't for the life of ...
1
vote
1answer
869 views

Wiring washer, dryer, tankless water heater

Trying to wire for washer/dryer combo in the garage, and we need to add a tankless water heater to get hot water to the washer. In their current location, there's a (EDIT: 15) AMP circuit for washer, ...
2
votes
2answers
583 views

Washer water out from basement

I have a stupid question. Originally, I have a washer that pumps out the grey water into a laundry tub / sink. Attached to the laundry tub is a pump that pumps that grey water from tub into the ...
1
vote
3answers
2k views

How can I relocate hookups for washer and electric dryer?

EDIT: added info and added alternate locations. Our washer and dryer hookups are located out of reach, 40" behind the appliances. They are mounted on what, in the 1940's, was the exterior side of an ...