Questions tagged [tile]

For questions generally relating to stone or ceramic tile, including selection, preparation, installation, maintenance, cleaning, and removal.

Filter by
Sorted by
Tagged with
2
votes
1answer
18k views

What underlay is used for installing pool tiles

Is it concrete? (i.e. cement and water) Is it some kind of special caulk? Is it something else?
0
votes
1answer
3k views

Should I use thinset or silicone to reattach shower tiles? [duplicate]

My tiled shower needs to be repaired only where the walls meet the floor. While preparing for this by taking out the old grout, two small pieces of floor tile came out. Each piece that came loose is a ...
1
vote
0answers
409 views

Should I seal bathroom ceiling and wall tiles?

The previous owner put tiles around the bathtub like ceiling and side walls. I wonder if I need to seal these tiles in order to protect them from the water? Will it increase its lifespan?
4
votes
1answer
937 views

How do I remove mineral stains from tiles?

The water in our apartment has higher salt levels, which ultimately makes stains on tile. I tried to remove them with various bleaching agents, but with no effect. Can anyone help?
3
votes
1answer
14k views

Should I use underlay when tiling a bathroom?

Recently I had a water leak in the bathroom. I noticed water spilling out from the tiles grouting and I removed them to prevent any more water penetration. I noticed that the following layers have ...
3
votes
2answers
59k views

How do I transition between tile and drywall in a tub surround?

I'm working on a tub surround, which is about to be tiled. And the last piece I need to figure out, is how to transition between finished tile and adjacent wall. This is how my wall looks right now. ...
1
vote
1answer
1k views

How can I smooth a seam between cement board?

I have a joint between two sheets of cement board that forms a small ridge elevated maybe 1/8" relative to the centers of either board. I was wondering if extra thinset on both sides can be used to ...
5
votes
2answers
4k views

What is a recommended height for tile edging?

I'm trying to put up a tiled mosaic back splash and I'm trying to figure out the profile height for the edging. My tiles are 1/4" (6mm) thick. Should I be getting an edge where the profile height ...
2
votes
2answers
2k views

How can I affix this wood transition piece?

I made a perfect looking transition to go from wood floating floor to tile for a bathroom. Problem is that this is where the old marble transition was. Can I set the transition with mortar? If not ...
4
votes
2answers
7k views

How do I fill a gap between wall tile and acrylic shower base

The bottom row of a newly installed tile wall has a gap with the shower base that is about 1/2 inch wide, too wide to caulk. How can this be filled in a way that will not crack, will make a water ...
2
votes
1answer
383 views

Is this the proper procedure for attaching a mosaic to the wall?

When I began this mosaic project, it was suggested, because the tiles and stone chips were different thicknesses, I lightly glue the tiles, upside down, to brown craft paper. the mosaic is complete, ...
5
votes
2answers
675 views

Do I need water protection over tile grout in my bathtub?

A handyman suggested to me that I might need to periodically apply water-sealant to the tile and grout on the tile wall of my bathtub. Is he correct? If so, what's a good sealant to use, how is it ...
2
votes
1answer
203 views

Which tile cutter to use for commercial flooring tiles?

I am putting (vinyl?) commercial flooring tiles in one of my hallways. The product I've seen one guy (pro) use at a supermarket once was this: Now, that baby is $200+. I was wondering whether the ...
1
vote
0answers
697 views

How do I reattach pool tiles?

The following tiles: Have fallen off the side of the swimming pool here: Questions: What should I use to stick them back on? I notice that they appear to have grouting between them. Is that a ...
2
votes
2answers
3k views

How do I patch my wall with tile along the seam?

I just removed the top 6" of tile from my bathroom wall which is tiled from the floor to about 4 feet up. I just didn't like the pattern of tiles at the top. The tile seems to have been attached to ...
4
votes
2answers
2k views

Should I remove nailed-down plywood before laying tile?

In my bathroom there is vinyl on top of plywood, which is nailed to the sub floor. Should I pry up the plywood before putting down cement backer board for tile, or can I go over the plywood?
3
votes
3answers
10k views

How can I attach a shelf to a tile wall in a repairable manner?

I am renting a flat and have permission from the landlord to put up shelves etc as long as "I don't wreck the place". In the kitchen there is a lack of storage space, and a large blank tiled wall ...
2
votes
1answer
53k views

How can I remove the tile from this wall?

Doing a tile removal on our master tub/shower. I'm pretty sure the tile is original to the house, which is 34 years old (1978). It's a 4 1/4 inch tile, that has been backed by dry wall. When I was ...
4
votes
5answers
19k views

Laying Tile Over Asbestos Floor Tile

In my laundry room, I've got asbestos floor tile. (The house was built in 1967.) The tile is laid on the concrete slab. Is it possible to lay ceramic penny tile over the asbestos tile if I put down ...
3
votes
1answer
377 views

How can I tile the raised edges in my basement?

I'm looking to tile a basement floor that was dug out about 6", so there is a roughly 6" tall x 4" wide raised concrete border around the whole room, as they didn't dig out the edges. This border is ...
1
vote
2answers
513 views

How can I get my shower tiles really clean?

My shower tiles in my apartment are kind of nasty, and I've tried spraying them with Clorox Bleach Foamer and also Tilex:Mold & Mildew and then scrubbing with a magic eraser thing. I can try ...
5
votes
1answer
1k views

How do I install a glass tile backsplash on 1/2" drywall?

I am currently building a house and am at the point where the builder has just finished the drywall and is ready for the kitchen cabinets and countertops to be installed. There will be no backsplash ...
5
votes
1answer
813 views

How do I prepare my new bathtub alcove?

I will be expanding my bathroom and moving the bathtub, meaning I need to prepare a new bathtub alcove. I know how to frame and plumb - but preparing for tile is new to me. I know that there are ...
3
votes
1answer
2k views

How can I fix/polish a slate tile imperfection after it has been laid down and grouted?

Our contractor laid down a tile on our renovated bathroom and somehow did not realized that it was defective (see picture). The defect is some sort of metal mineral (kind of rough) the kind that ...
4
votes
2answers
300 views

Any tips on fixing a difficult wall for tiling?

I've got this small old bathroom that I want to lay with ceramic tiles. But to do that the walls should be straight - which they are not. Three of them are almost fine, but the fourth is... well, take ...
13
votes
1answer
3k views

Should cement board be glued and screwed to the studs?

I've seen some people recommend that cement board be glued and screwed to the stud framing for wall and ceiling application. I haven't seen this recommendation on any of the manufacturers install ...
3
votes
2answers
3k views

Should I apply waterproofer on the subfloor beneath a shower pan?

I'm going to be using the Kerdi shower pan and membrane to seal a steam shower. I understand the process of installing the membrane, deck and preparing the wall and ceiling substrate. This question ...
5
votes
1answer
664 views

Will this floor tile break?

So, I've got some 12"x12"x1/4" tile laid over a concrete floor. I'm cleaning up between the tiles getting ready to grout and I notice I can see some concrete between and underneath (the small amount i ...
0
votes
1answer
480 views

Are “Waterproofing Primer” and “Grout Sealer” the same?

As I'm getting close to end of bathroom renovation, hardware store recommends me to purchase 'grout sealer' to finish off new layered grout. When I test it out, I found out it is very similar to '...
6
votes
1answer
6k views

How can I fix an uneven and damaged transition from drywall to tile in the bathroom?

We recently replaced some old, cracking shower walls in a bathtub area with tile. Looks great. However, on one wall the drywall next to the tile bows out so it's not even with the tile in the middle ...
6
votes
2answers
10k views

What should I use as backing for mosaic accent tiles that are a different thickness than the main field tiles?

I noticed, too late (during install), that the mosaic tile my wife chose for accent in our shower is a different depth than the regular tile we're using. The mosaic tiles are about 1/8-3/16" thinner ...
3
votes
2answers
4k views

How can I prevent water pooling on a windowsill from getting behind wall tiles in a shower?

I have a windowsill in a shower which had regular 6" ceramic wall tiles over drywall. Some water had obviously pooled on this, got under the joint at the lip of the tiles and rotted the drywall. So I ...
6
votes
1answer
385 views

How do I fix a broken tile?

I broke a tile and am trying to work out how I can fix it. Any ideas?
4
votes
1answer
2k views

What size screws and spacer should I use for installing shelves on tiles?

I need help confirming what size of screws, spacer and drillbit to use for installation of a shelf in my kitchen. Some specifics: shelf is 200 x 30 x 1.8cm (spruce). shelf brackets ask for 4mm screw. ...
6
votes
1answer
429 views

How do I size this wall to make tiles look right?

I am expanding my entryway by building a new half-wall, and then I will be tiling (which I have never done before). What I'm looking for is some advice on the best way to size the wall so that the ...
3
votes
1answer
3k views

How to install tub into non-square rough opening?

I am remodeling a bathroom and I am putting in a new tub and then tile the walls of the tub. My problem (right now) is that my rough opening is 60-3/4" at the back and 60-1/2" at the front. This ...
0
votes
2answers
1k views

tiles getting spongy and water coming up between the cracks

I have press-on tiles in my bathroom. We noticed they are getting spongy near the cooling vent. When I press it with my foot, I can see little bit of water coming up between the cracks. Duct work is ...
2
votes
1answer
523 views

Do tiles need to be cut to fit area between back wall and the edge of the bathtub?

I am in the process of remodeling a bathroom and I am putting in a new tub and plan to tile the walls. It seems most tubs are standard depths of 30 or 32 inches, ours is 32". Now the new tub is ...
2
votes
1answer
1k views

How should I prepare the shower walls for tiling to prevent mold and mildew?

What is the proper way to prepare a bathroom wall before tiling for a shower area to prevent the growth of mold and mildew?
2
votes
2answers
972 views

Our tiler put Grout Boost on after laying grout, thinking it was grout sealer. What should we do?

Our tiler made an error and put Grout Boost on after laying the grout, thinking it was grout sealer. What should we do? Will Grout Boost act as sealer when applied after grout is put down and dry? ...
4
votes
1answer
12k views

How much thinset is enough?

I'm having a shower tiled and I noticed that the tiler didn't put thinset over the entire area, just on the back of individual tiles. The tiles are heavy stone 3/8x6x12. He used a 1/2 x 1/2 trowel to ...
5
votes
3answers
1k views

What preparation is required for tiling over poorly laid floor boards?

4" hardwood floor boards mounted on a poorly-designed frame made out of whatever wood the constructor had lying around it seems. There's a lot of bounce, some boards even drooping 1/2" when walking on ...
4
votes
1answer
446 views

How robust is ceramic tile paint?

A friend wants to paint the ceramic tile around her fireplace including some of the tiles on the floor in front of it. If those floor tiles get just a little foot traffic, is ceramic tile paint strong ...
8
votes
1answer
16k views

How do I put up a travertine tile backsplash?

I'm trying to put up a tile backsplash in the kitchen (approx 25 sq ft) and I'm having trouble deciding between mastic and thinset for putting it on the drywall. For that matter, is it OK to put the ...
12
votes
1answer
4k views

Where should the floor transition from tile to carpet go?

I have 2 rooms planned, one will be tiled and the other will be carpeted with a door opening between them. Where should the tile stop and the carpet begin? In the figure below I have 3 different ...
3
votes
2answers
3k views

Can you use an outdoor paving stone for indoors?

I want to tile my kitchen with a tile that continues outside to a patio. I have seen a nice 25 mm thick lime stone tile (outdoor) that would look good, but I'm not sure about using an outdoor tile ...
6
votes
1answer
16k views

What size drill bit do I need for a 3/16" plastic anchor in tile?

And yes, the obvious answer is 3/16" ... that doesn't work. I'm installing a towel rod and hook in a bathroom that is fully tiled. The instructions with the rod & hook both said to drill a 3/16" ...
8
votes
4answers
8k views

Can I install tiles directly over a concrete floor in my basement?

We are redoing our basement. In some areas (bathroom and laundry room) I plan on putting tile down. The basement is dry and level. Can I attach the tile directly to the basement floor?
5
votes
1answer
2k views

Do products like Ditra make tile removal more complicated?

Products like DITRA are great to use when installing tile, but I can't help wondering what it'll be like to remove the tile later. Is it more difficult to remove tile that's been laid on this type of ...
4
votes
1answer
5k views

How do I properly seal slate tile?

We recently installed slate tile in our renovated bathroom. We have sealed it with a penetrating water-based sealant. Water still seams to soak in to the tile and little water spots on the tile are ...