Questions tagged [tile]

For questions generally relating to stone or ceramic tile, including selection, preparation, installation, maintenance, cleaning, and removal.

Filter by
Sorted by
Tagged with
3
votes
3answers
442 views

Do we need to re-install tiles if it was exposed to water for 20 minutes after installation?

The tile installers didn't shut off the shower valve when they left after installing tile work in our shower. We turned on the main water supply and 15 minutes later, we went to the bathroom to check ...
2
votes
4answers
43k views

Hardie Board Subfloor—Thinset or No?

I'm remodeling the bathroom in my house that was built in the 1930s. I stripped out the old flooring down to the 1x8 wood planks (about 1/4" between each). I have 1/4" Hardie Board to put down in ...
8
votes
3answers
11k views

What kind of backing should I use for a glass mosaic backsplash?

I want to install a glass mosaic backsplash. These are a bunch of small square tiles of different colors on a mesh. Each meash measures 13 x 13. They are so thin, that I want to put some plywood or 1/...
0
votes
0answers
111 views

What is the fastest way to remove adhesive from ceramic tile?

What is the fastest way to remove adhesive from the ceramic tile? I have no patience for removing the adhesive by using an utility knife.
3
votes
2answers
18k views

Tape or corner bead where Hardi meets Drywall?

I need to finish the outside corner above the shower alcove. The shower ceiling is hardibacker and the wall outside the shower is drywall. Where these two meet, what is the proper way to finish it so ...
1
vote
1answer
326 views

Tile Shower Surround—Cement Backerboard Location?

I'm in the process of remodeling an old bathroom and I'm coming up on the point where I'll need to drywall/install backer-board. I've been reading up on this and I just want to make sure I have my ...
0
votes
1answer
494 views

How can I safely remove stick-on tiles that are on top of asbestos tiles?

I have an issue when I started renovating my basement. When I bought my house 3 years ago, the basement had 12" stick tiles through-out. I removed a bar, a built in cabinet and a few other things ...
3
votes
2answers
41k views

How to level bathroom plywood subfloor before tiling?

In a bathroom remodeling project, I noticed the newly installed plywood sub-floor is flat but not level, which may cause issues when installing the shower and the sink cabinet (water evacuation and ...
3
votes
1answer
3k views

When drilling a tiled wall, should I aim for the seams or avoid them?

I'm going to drill a couple of holes in a tiled wall in my bathroom. Is it best to drill through the seams or the tiles? Should I avoid vertical or horizontal seams, or does it really not matter? The ...
3
votes
2answers
11k views

Can tile be removed and placed again before it sets?

20 x 20 tiles were started today in my living room. The tile has been laid straight without any kind of staggering. They are in complete rows which is not what I had wanted. The room has not been ...
0
votes
1answer
210 views

replace one tile bathroom floor

18" tile part adjacent to toilet and under the flange cracked during toilet install (plumber). first try result: replacement tile is too high, i I had to remove it. Complication: tile rocks due to ...
2
votes
1answer
149 views

Should I be concerned about water spilling behind tile wall?

I recently attempted to replace a single handle shower valve (cartridge and all). During removal of the assembly, there was water remaining in the pipes after I had shut off the main. The water leaked ...
1
vote
2answers
2k views

Sill plates (thresholds) before floor tiles or otherwise?

The contractor wants to install the granite sill plates now and later have the tiles installed. I heard from one granite fellow that the sill plates should be last. Is there any advantage for going ...
7
votes
2answers
72k views

Should I use self-leveling concrete or mortar to level a patched area of concrete prior to tiling it?

I had to repair cast iron pipe in the basement. This left me with a 2ft x 3ft hole in my tiled basement floor. We cut along the grout lines, so I just need to replace the tile and concrete. Well, ...
3
votes
1answer
495 views

How should I prepare a concrete slab for plank porcelain tiles?

I have several questions about laying plank porcelain tile on a concrete slab. First do I need to get 100% of the glue from the concrete floor, there are small spots and patches here and there that ...
1
vote
1answer
2k views

How can I transition from tile to stained concrete?

What are some good ways to transition from tile to stained concrete? We pulled up the carpet that was next to our tile and stained the floor instead of new carpet? I am looking for simple DIY ...
1
vote
1answer
912 views

Can I apply grout over grout to change the color?

We grouted tile on counter tops and glass tile backsplash last night and the grout looks white and it was supposed to be a tan color. Can I grout over it with a darker coloured grout?
2
votes
2answers
142 views

Best way to affix plywood to wood unit?

I'm planning on affixing some mosaic tile to a panel of plywood (43" x 44"), and then affixing that tiled panel to the back of an entertainment center which I'm re-purposing to become a bar. Once I'...
2
votes
1answer
69 views

Can I safely affix tile to a panel of plywood?

I plan on affixing some 5/8" glass mosaic tile to a panel of plywood roughly 43 x 44". I then plan on using that as the face of our bar by affixing that plywood to the bar. My concern is that they ...
1
vote
0answers
1k views

Will porcelain tile provide enough thermal mass for off peak heat storage?

The U.S. department of energy suggests electric radiant heat can be cost effective if preheated during off peak electricity hours if installed within an appropriately massive covering. Is there a way ...
4
votes
1answer
12k views

How should I clean stone surfaces prior to applying sealer?

I apply impregnating sealer to all my tile and stone surfaces annually. I had been cleaning it with just soap and water, then letting the surface dry for a few minutes before applying the sealer. It ...
0
votes
2answers
3k views

Custom pocket door with insulation, water pipes and tile!

So I have a little house and would love to use pocket doors all over it. It seems the Johnson hardware 1500 series doors with the ball bearing rollers have great reviews and slide like butter. So I'm ...
4
votes
5answers
13k views

How can I clean floor tile grout?

Someone I know had tile laid in their kitchen and was supposed to seal the grout after the work was done. This never happened and now they have dirty grout. What's the best way to make the grout look ...
0
votes
1answer
170 views

Bathroom floor - what should I do?

I am renovating my bathroom. Previously the plan was to replace the old floor with new floor tiles. But after some investigation, it's too much effort for its worth. So now I am thinking more along ...
2
votes
2answers
19k views

What is the best choice for patching and leveling concrete before tile install?

We have a small area of concrete foundation that we need to patch and level prior to ceramic tile installation (12×12 tiles). It is concrete that we chipped the old tile mortar off of, so there are ...
0
votes
2answers
6k views

Tile over Plaster (bathroom)

I am remodeling a bathroom to add a shower to a previously tub only bathroom. It is an older home (Built late 40's) and I believe the two interior walls are lathe and plaster the exterior wall I ...
1
vote
1answer
553 views

How to repair broken grout in shower tile?

Just moved into this house a few months ago, and noticed the stub wall in the shower that holds the controls has cracked grout. I'm guessing that somehow water got in behind the tiles and started to ...
0
votes
1answer
273 views

How can I deep clean grout in my kitchen?

I've tried homemade recipes with baking soda and lemon juice. I've also tried store bought cleaner/repair stuff. So far, it's still dingy. Anyone know of a powerful (and somewhat safe) product that ...
7
votes
2answers
52k views

How do I make where my carpet meets tile look nice?

We've recently replaced our kitchen tiles. I'm happy with the results but have no idea what to do with the edge. How do I clean this edge up so that it looks more appealing?
3
votes
2answers
10k views

How do I prep and plaster a bowed wall before tiling?

I'm about to tile a shower alcove. However, I put a straight edge against the walls and the rear wall bows out very badly. The wall is 950mm wide and putting a straight edge across shows a gap about ...
1
vote
2answers
166 views

Does my travertine-tiled shower have thin set leaking out the bottom?

I have shower tiled with travertine and along the entire bottom a thick almost rubber-like substance is slowly leaking out. It is a grey / black color. I'm assuming it is thin set that wasn't mixed ...
1
vote
0answers
101 views

Red reclaimed victorian tiles (outdoor) crumbling after only 6 months

About 6 months ago we had red/blue reclaimed Victorian tiles laid in a checkerboard pattern outside the front of our house. Red dust seems to be constantly coming off the red tiles, so that the grout ...
0
votes
1answer
246 views

The best kind of tiles for using on floor and walls

I'm in the process of doing up a room in my home for short term rental. It is a small room, and approximately square; about 12.5 ft by 12.5 ft. This room is on the edge of a building; we normally ...
0
votes
2answers
7k views

Shower Base over or to the side of tiles

I am tiling my bathroom floor and putting in a new shower base. What do i do first? Do I put tiles on the whole floor and then but the base over it? or put the base and then put the tiles to it?
1
vote
4answers
2k views

Imperfectly cut tile (4mm short) within acceptable range of error?

Recently we had a tiler who tiled the backsplash in our kitchen. He had to cut a tile to fit right below the extractor fan (hood). And he grouted the space between the top of this tile and the ...
5
votes
3answers
39k views

How do I properly cut pre-existing kitchen backsplash tile for new low voltage wall plates?

I'm doing a little bit of kitchen remodeling, overflow from my home theater remodeling. I'm adding some RCA input ports to a pre-existing low voltage wall plate that previously hosted just Cat5 and ...
6
votes
3answers
61k views

How to remove dry grout

How do you remove dry grout on tile. We have tried everything from vinegar to tile cleaner, but nothing is working. Any suggestions?
1
vote
2answers
48k views

How to finish tiling an outside edge for a shower?

I am installing stone tile (travertine) in a shower. I do not have bullnose tile so I was planning on simply finishing the edge by slightly filing the corners of the tile so they're not sharp and then ...
3
votes
3answers
6k views

Questions after a test-run grout replacement

I have very little experience with this sort of thing, so after reading and watching you-tube videos I attempted a test patch - a 3 tile wide, 1.5 tile deep section (these are 12" floor tiles). And ...
1
vote
1answer
317 views

How to clean grout over grout?

We are doing over our bathroom. We have tiled the shower with large white tiles with a gray strip down each side. After we grouted the white tiles (waited a couple of days) we used gray grout for ...
2
votes
1answer
175 views

Tile cracks on a convex edge

I am a DIY newbie, and I need help with some damage that starts to appear in tiles along a convex edge. The corner of my bathroom looks like this (walls, floors and that "cube" are all tiled): The ...
4
votes
0answers
1k views

What material might be behind my old bathroom tile? [closed]

I am considering removing the tile in my bathroom. The house was built in 1948, and I am concerned of what I might find behind the tile. Can anyone tell me how they attached the tile back in those ...
11
votes
2answers
31k views

How do I do a minor grout repair properly?

I've got grout between some floor tiles that is cracking and coming out in small chips, over time. The tiles and remaining grout are otherwise in great shape. I suspect this is just a problem high-...
1
vote
3answers
2k views

How do I level a sloping floor that has been tiled?

We have a large room that we want to use as a bedroom and it has been tiled, over a concrete slab. On further inspection we now realise that there is a slope of approximately 5cm from one end of the ...
2
votes
1answer
304 views

Do I need to use a waterproof sealant in my entryway?

Do I need to use a waterproof sealant in my entryway, over the backerboard and under the porcelain tile or is the thinset adequate? Sub floor is above grade, 3/4" plywood. thanks!
2
votes
1answer
983 views

Is the thickness of glass tile important in pool installations? If so, would thicker be better?

I have a gunite pool which desperately needs resurfacing. I'm seriously considering going with glass tile mosaics for the entire thing. What I'm somewhat confused about is whether I should be looking ...
2
votes
4answers
3k views

Our backsplash tile has raised oval design a how do we work around electrical outlets?

The tile we chose for our kitchen redesign is long and narrow (3" x 9") with a raised oval design. This image isn't the same brand as ours (We purchased Portfolio) but this is almost identical. ...
1
vote
2answers
7k views

When installing backer board for wall tiles, do the screws need to be absolutely flush or even pushed into the backer?

I'm asking because some screws will not go in fully flush. But I'm thinking the layer of thinset then tile will surely cover any screws that aren't flush, so tiles won't 'pop' out.
0
votes
1answer
261 views

Laying new tile on subfloor with old plumbing holes, patch needed?

Laying floor on a subfloor that has old plumbing holes in 3 places. The biggest one is just 2 inches, the rest are smaller. Otherwise the floor is in excellent condition. I'm using ditra. Is it ...
0
votes
0answers
2k views

How to resolve a crack in the shower floor?

My dad did a great job renewing his bathroom, but sadly a crack has appeared on the shower's plastic floor base. He believes the crack has developed because he installed it on top of wooden beams ...