Questions tagged [sill]

The tag has no usage guidance.

Filter by
Sorted by
Tagged with
6
votes
1answer
11k views

How do you finish a window installation?

After the window has been secured in the rough opening, how do you finish the inside part of the installation? For example adding a window sill and trimming out the inner portion of the rough opening, ...
5
votes
2answers
6k views

How can I correct the slope of a marble shower sill?

Our master shower is tiled in marble; it's almost perfect except... the sill has a slight slope running out of the shower instead of into it. As a result, every time we take a shower, a small amount ...
5
votes
1answer
14k views

Replacing sill (bottom plate) of wall

I need to replace the sill of an exterior wall (load bearing wall that faces the outside the home). I ripped the sheet rock off and noticed some very old termite which was apparently treated years ago ...
4
votes
1answer
2k views

Is there a recommended distance between fasteners on sole plates?

We've just started installing pressure treated 2x4s as sole plates in our 5 year old basement. We drove 3 nails into each 8' plate, one at each end (around 3 or 4 inches in) and one somewhere at the ...
4
votes
2answers
2k views

What can I do about this gap between the sill/exterior board and the subfloor?

I just discovered that my sill plate and joist setup is different than others I've seen (and I was a Realtor, so I've seen a lot of sills). As you can see from the picture, there's a gap between the ...
4
votes
3answers
25k views

How to seal between sill plate and foundation wall with wide gap?

Here is a picture of the top of my uninsulated basement wall. The foundation is poured and from early 1970s. For orientation to the photo: the white in the lower left corner is the vertical face of ...
2
votes
1answer
108 views

Tips for extending the window sill

The extended sill would have a depth of about 2 inches. If I were to extend the window sill using the below approach, would that be strong and stable enough? I may plan to add an additional interior ...
2
votes
2answers
856 views

Should I be worried that the anchor bolts are not centered on the sill plate?

I am in the process of having my first home built and have been trying to learn as much as I can along the way. Today I visited the home site and saw that the builder installed the sill plates on ...
2
votes
1answer
3k views

Replacing a sill, on a factory built Marvin window?

The following windowsill, and the ones like on the same building, have failed. Patching with Smith's Flexible Epoxy kept the sills alive for a few years, but now the entire sill feels like balsa wood ...
2
votes
1answer
2k views

Attaching sill plate to concrete, how do I attach framed wall to sill plate?

I am building a 12x12 shed on a concrete slab. I am going to bury j-bolts in the wet concrete so that I can attach the treated sill plate to it. The problem I'm running into is that the nut will be ...
2
votes
1answer
55 views

Tricks to repair window sill?

We had a roof leak that ran down the window frame and got the window sill wet. Everything is dried out and the roof is fixed. Any ideas on how to fix this window sill? I'd prefer not to have to remove ...
1
vote
2answers
1k views

Repair a crack in a brick windowsill

How do I repair a crack in a brick windowsill? I assume that it needs to be sealed to prevent water from getting in, especially during the winter when it could freeze. The other side of the window ...
1
vote
3answers
5k views

Use Gap and crack sealant on the window sill

I have a small gap (2mm) under the window sill that is causing some draft to come inside the house. I have attempted to correct this using the Ge Silicone Caulk, but the draft continues to come in. ...
1
vote
2answers
1k views

Running conduit between basement and 1st floor

My basement is currently unfinished but within the next few months we plan on finishing half of it as living space. Before the framing and drywall goes up I want to run a conduit between the ...
1
vote
3answers
2k views

Need help with attaching wood to cinder block

Ive been researching and toiling over this as opposed to actually getting it done for too long, finally had to turn to a forum! I purchased a relatively old house (1957) some time ago and we've ...
1
vote
1answer
93 views

PVC Exterior Window Sill on a Brick Veneer Home

I have a brick veneer home with a rectangular hole in the wall that currently holds an unneeded window air conditioner. I bought a window I would like to install there. The hole does not have a brick ...
1
vote
1answer
833 views

How to remove a granite window sill?

I need to remove a granite window sill in order to install plantation shutters. How can this be done? Can it be done without damaging the wall that the granite is affixed to (at the base of the ...
1
vote
1answer
134 views

What to use as a knee high wall sill

I removed the sill that was on top of the knee wall between my shower and bath tub. It seems to be made from some carbonate/plastic. I cannot find anything similar anywhere. I dont even know what they ...
1
vote
1answer
817 views

How to protect foundation, sill, and siding from moisture (snow)

I have an old house with a stone foundation and ~6x6 sill plate. The deck used to butt right up to the siding. I cut the deck away about 18" in order to get access to the area for some weatherization.....
1
vote
1answer
191 views

Covering Exposed ICF and sill plate?

new guy here. I am hoping you guys can help. We had a 2x6 built Wisconsin Homes modular placed on top of an ICF basement. Then, we had vertical vinyl board and batten siding installed, it was run down ...
1
vote
0answers
624 views

Pier Beam Foundation Sill Beam

Background: I live in upstate New York, just outside of Ithaca. My wife and I have recently purchased a home at a steal because of an existing relationship with the previous owner. So the fact that I ...
1
vote
3answers
1k views

How can I prevent water from flowing into my carport under the wall plate?

The carport was enclosed but no additional concrete was poured. The sill was screwed directly into the concrete. As a result of being so close to to ground, water has come in under it about 2-3 inches....
0
votes
2answers
2k views

Bare Wood Window Sill Stinks Bad

So I've been redoing my window sills. Basically I smashed out tile sills and replaced with routered wood sills. There are maybe 15 in the house. I have not had time yet to prime any of them, so for ...
0
votes
1answer
113 views

Joists extended by tecos

I recently purchased a house and have noticed the floors seem to sag in certain spots. I notice in the basement that there are several sections where the joists were cut and then extended via tecos to ...
0
votes
2answers
2k views

How to attach a new sill to an existing concrete foundation

I have a foundation of block wall. To get it to the correct height I need to put 4" solid block top cap on it and my sill plate on top of the 4" solid top cap. I can fill in the voids in the block ...
0
votes
1answer
36 views

Replace rotted wooden sill of the door?

I think this wooden piece is called sill but not sure, (as seen in the picture below, in red box) I am think of replacing it with a new one, the question is, is it standardized? I measured it and the ...
0
votes
2answers
129 views

Sill plate on an 8 inch wide cinder block wall

So I have a cinder block block that is about 4 feet high.in which I will be putting a framed 8' wall. I will be using a 2x6 sill plate PT. How much space do I leave for the sheathing. It's an exterior ...
0
votes
1answer
106 views

How to protect sill plate from water when slab is bigger than the structure sitting on it?

I am building a small garage extension. I want the walls in plane with the existing walls, but the existing slab in this area extends 3" beyond where the sill plate will sit. What is the proper way ...
0
votes
2answers
907 views

Remove Paint from outdoor metal sill of Main Door

So I guess when the door was painted 10 years ago, paint might of spilled on the metal sill? I'm not sure if that is the correct word for it. But I've taken a picture of it for reference. I've ...
0
votes
1answer
45 views

Base sill plate overhanging concrete slab [closed]

The sill plate in my home is hanging off the concrete slab about 2 inches and I am able to stick my hand between the plate and slab. This is a bearing wall 10 feet long. As far as I understand, from ...
0
votes
0answers
29 views

Replacing a Marvin window sill

I need advice on replacing a rotten Marvin window sill. It is a three-piece sash window with heavy mullions. Diagram of mullion to sill would also be useful. Thanks
0
votes
0answers
43 views

Snap Chalk Line for sill plate, or for rim joist?

What do you guys find is best for layout after getting the foundation poured for a house or garage? When you go and snap your lines that are perfectly square, is it better to have your sill plate ...
0
votes
1answer
45 views

Sill thickness larger than 2"

Can a sill plate be larger than 2" thick? I installed a footing to carry a point load. I will be installing 3 LVL's on top of this and then trimmers to support a header. So I need the need to get ...
0
votes
0answers
154 views

Leveling a 2x8 sill plate on top of a cmu wall

What type of shim do I use to shim up a sill plate 1/4 inch on top of a cmu block wall?
0
votes
0answers
130 views

Is there any alternative to sill replacement?

If my house needs sill (plates) replaced, is there any alternative to full replacement? Could I just cut 2x8s and use structural screws to hold it to the old sill to make sure the floors are secure? ...
0
votes
1answer
901 views

Repaint masonry window sill

Our house has a Victorian bay window and what appears to be chunky masonry/concrete window sills. They look like they are painted with some form of gloss which has become flaky and green over the ...