The Stack Overflow podcast is back! Listen to an interview with our new CEO.

Questions tagged [sanding]

The tag has no usage guidance.

9 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
1
vote
1answer
98 views

Wood frame door and window repair. Steps by step answers please. In Ecuador

These are the wood parts that have been very badly damaged by sun and water. How can i restore them to the natural color they had. Id like step by step information please. Also i am in Ecuador so some ...
0
votes
1answer
21 views

Sanding between coats of water-based finish

I built a farmhouse table with Douglas Fir, applied Saman water-based stain, and then applied the first coat of water-ased finish. The folks at the store said I should sand after the first coat, using ...
0
votes
0answers
31 views

Re staining a deck -how I have to sand only the area that lost the stain?

I stained my deck with using this product https://www.olympic.com/products/us/exterior-stains/olympic-summit-woodland-oil Afer two years the heavy traffic area looks likebelow. The rest of the deck ...
0
votes
1answer
39 views

Mineral spirits not drying on unfinished hardwood floor (12 hours later)

I'm looking for suggestions on how to dry down or remove excess mineral spirits from our unfinished hardwood floor. We installed new, unfinished hardwood flooring (yellow birch), sanded it and then ...
0
votes
0answers
33 views

Which sander and sandpaper should I use on floor after using wood filler?

I've sanded my 100-year-old floor with a drum sander, and troweled wood filler over the entire surface. Now I'm ready to sand again before staining. How aggressive of a sander (drum, random orbital) ...
0
votes
0answers
46 views

Painting fiberglass repair on kitchen sink

I recently did a fiberglass repair on my fiberglass kitchen sink. Now it's ready for paint. So I have a can of Rust-Oleum gloss white. Now it's been awhile but I'm pretty sure I should prime it first. ...
0
votes
0answers
68 views

Best way to open cuts in thin steel without hitting the borders

I need to cut thin metal plates/shells: < 1mm and 1mm ~ 3mm These shells are originally curved in a dome-like surface. Basically they're bowls. I must start from the middle of the plate ...
0
votes
0answers
360 views

Repairing rust damage and dents on my standby car

My standby car has got some nicks and minor small dents. Also there is some rust damage on two of the doors and part of the fender, usually spots where dew drop collects. At some places the rusting ...
0
votes
1answer
834 views

Correct grit and sander for sanding a cedar railing?

We have a cedar railing around a deck. The railing needs to be sanded prior to applying a water sealer. Two questions: What is the best grit of sandpaper to use? I read that using too fine of a grit ...