Questions tagged [receptacle]

A contact device installed at the outlet for the connection of an attachment plug.

Filter by
Sorted by
Tagged with
0
votes
1answer
691 views

I have Direct tv plugged into a gfci protected receptacle. All of the receptacles on same circuit will go dead, but not trip the gfci. Why?

Ok the GFCI is located in the 5th wheel upstairs bedroom/sink. It is protecting 4 of the receptacles in lower level next to sink and tv/stero area. I have a direct tv (tailgater) plugged into the ...
3
votes
2answers
85 views

Does a 16“W x 13” deep counter space need an electrical outlet?

I have a 15"W x 24" Deep base cabinet. The counter top overhang is 1" on the front and right side. There is no overhang on the left side as there is a gas range there. There is a 15" W x 12" deep ...
1
vote
2answers
2k views

would a bathroom without a gfci outlet be a violation in a rented appartment

Would a bathroom without a GFCI outlet in a rented appartment be a violation? I have section 8 and my apartment failed inspection because of this.
1
vote
3answers
742 views

How do I bring a recessed wall outlet flush with newly installed paneling?

I paneled a wall with three quarter inch thick paneling and now the two wall plugs are recessed in. Do any of you know if the have specialty plugs that would plug into the wall outlet to bring it to ...
0
votes
3answers
269 views

How to repair an electric outlet which died while running a carpet cleaner?

I ran a carpet cleaner in my condo for the first time in a bedroom and the outlet and lights died. Then I went to the living room and ran the cleaner and the outlet died too. But I was able to use two ...
1
vote
2answers
372 views

Troubleshooting outdoor electrical outlet

I bought a new house and noticed the outdoor electrical outlets are not working. I checked the electrical panel and all the switches are on (the outdoor outlets are labelled on the panel and I turned ...
1
vote
4answers
4k views

Sump pump & ejector pump: can I (and should I) change single dedicated non-GFCI receptacle to a dual receptacle GFCI?

Moved into a new home about 6 months ago which had been gut rehabbed. Our mechanical room has 2 pits, one for the sump pump and another for the ejector pump. I was planning on installing a ...
0
votes
1answer
790 views

Why am I reading 20V at the receptacles on one household branch circuit?

I have a series of three household receptacles through which I am getting maybe 20 volts. All other receptacles in the room on other circuits have normal voltage. I replaced the breaker and ...
3
votes
2answers
3k views

How can I extend a circuit so I can plug in my under cabinet lighting?

I am replacing halogen under cabinet puck lighting to LED. The old system was hardwired right into a switch with a power source that was starting to make noise so I thought I would replace the whole ...
2
votes
1answer
454 views

Are portable electrical outlets permitted in a basement?

I would like to install a portable outlet box near a work area in an unfinished basement. I have seen these installed in commercial buildings and educational laboratory type areas, always dropped from ...
0
votes
1answer
370 views

Just bought a house, 70 years old, want to upgrade 2 prong outlets [duplicate]

I've done some searching on this already and I think I know the answer. But I'd like to ask just to double check. If i am not sure if the outlets are properly grounded, my best bet would be to ...
0
votes
1answer
680 views

How do I properly install GFCI outlets with existing 12/3 wire in parallel and on a switch?

I am trying to help my inlaws with a problem in their living room. Two of their outlets stopped working and I don't really know why. The outlets were wired to a switch in the hallway, which ...
2
votes
2answers
3k views

Why would only the top outlets work in my two kitchen receptacles?

I have two outlets in our kitchen, one on either side of the sink, where only the top plugs work. I've tried to do some trouble shooting and here is what I know: There is a red, white, black, and ...
14
votes
1answer
17k views

Can a GFCI receptacle protect other receptacles?

My contractor has wired one GFCI receptacle in the main bathroom on the same circuit as a normal receptacle in our en-suite bathroom (it is less than a foot from the sink). he says that since they are ...
0
votes
1answer
321 views

Is there a way to change this circuit so that the receptacles are not controlled by switches?

I have this one outlet in my house that, when exposed, has three wires protruding from it (while there are two wrapped in a nut). As far as I can test, two are feeding power and one is acting as a ...
2
votes
2answers
2k views

How can I connect my 30 amp electric dryer to a 50 amp plug?

I bought a used electric dryer and the connection that came with it says it's 30amp. I also have an old school plug in my wall that doesn't go with the connection provided. My current plug has 3 ...
2
votes
3answers
1k views

Wiring electrical outlets from a single outlet

I'm building an entertainment center unit, and on the unit I want to embed wall outlets into it so I can plug things like my receiver, NAS, consoles etc in a clean method. I thought the entertainment ...
2
votes
5answers
2k views

TV Arcs with Cablebox through both Coax and HDMI

Here is our setup Outlet in older house that was replaced with a GFI last year. (no issues until recent) The GFI doesn't have a ground wire running up from the basement. Just the white and black ...
3
votes
2answers
2k views

What is the preferred method for removing & replacing electrical wiring in the garage?

I just purchased a house built in the mid-1990s in Kansas, U.S. The garage is generally finished: It has sheetrock walls and ceiling. It also has outlets spaced every 6 feet or so about 4 feet above ...
2
votes
2answers
4k views

Adding USB Dual Port Charger Receptacle Blows Mains

I purchased a Hubbell "USB Dual Port Charger with 15A Duplex Receptacle" from Lowes to replace the duplex receptacle on my kitchen island. I first opened the circuit labelled for the island. The ...
2
votes
2answers
2k views

Did I make a mistake with this fluorescent light installation?

I bought a fluorescent light fixture with 2 light bulbs. I wanted to test if the light bulbs where good before mounting the fixture to the ceiling. So I simply plugged the cable to a 120V outlet. I ...
3
votes
2answers
15k views

Why use AFCI receptacles rather than AFCI breakers?

Is there any reason to use an AFCI receptacle rather than replacing the breaker with an AFCI type? It seems that providing protection on the whole circuit makes much more sense than to just one ...
16
votes
3answers
12k views

Is there ever a reason for reversing hot and neutral on a receptacle?

I moved into a new home and several receptacles have the hot and neutral reversed. I confirmed this with a basic receptacle tester. I opened one up and found the white wire on the brass terminal, ...
4
votes
2answers
748 views

How do I change which half of a receptacle is controlled by a wall switch?

I have a switched outlet in a bedroom. The top receptacle is controlled by a wall switch while the bottom is always hot. Can I make it so the top is always hot and the bottom is switched by just ...
0
votes
1answer
8k views

Should I replace a receptacle with a small burn mark?

I have a window A/C in my room. I turned it on last night and power from that socket, the restroom lights, second bedroom and hallway lights are not working now. The plugs in the restroom do work. The ...
2
votes
2answers
266 views

Why are only half of my receptacles working after an electrical arc in one of them?

I live in an apartment above an older building that I help care for. I was unplugging my phone charger (I may have pulled it out too fast) and there was a huge arc and flame color and it smoked. This ...
2
votes
1answer
2k views

How safe is this power configuration?

I have a regular 2 socket, 15 amp outlet in my garage. I need to run my miter saw and shopvac at the same time, the saw draws 15A and the shopvac 8.5A. I've currently been running them off one ...
7
votes
3answers
5k views

How should I go about fixing a faulty 240 V Electrical Outlet

This afternoon, my wife and I noticed a peculiar smell coming from the garage. We localized it to a faulty 3-wire 240 V outlet. Something got really hot resulting in part of the rubber melting on ...
3
votes
1answer
1k views

What size GFCI and receptacles on 20A circuit?

I am adding a string (5-6) of receptacles to an existing 20A circuit in my basement that currently has just one 15A duplex receptacle on it (with 12/2 Romex). I am planning to replace the existing ...
1
vote
2answers
1k views

Power Strip/Extension Cord on TV stand

I have a question. I have a TV stand with a capacity of 80 lb., and on it a TV that weighs ~50lb. On the wall directly behind my TV, I have two electrical outlets. On the floor, I have a surge ...
1
vote
2answers
853 views

Why do I have no power in two rooms after plugging something in?

I plugged something into an outlet, and heard a sort of a sizzle noise. Now I have no power in two rooms, but the breaker did not trip? Any ideas into what happened?
5
votes
3answers
727 views

How can I seal this hanging electrical outlet in my horse barn?

I really am not a fixer type of gal but this seems like it should be simple enough. Please respond appropriately for someone who has limited knowledge. I have a hanging outlet in my horse barn. ...
2
votes
1answer
33k views

Electrical outlet has two black hot wires but one neutral white wire?

I attempted to replace an electrical outlet that was not working. My voltage tester indicated nothing was working. A receptacle analyzer indicated nothing was working as well. but when opening it up,...
0
votes
1answer
18k views

How to attach outlet box in soffit?

I'm now planning to install out outlet flush, or as flush/above as possible, to the soffit. I've read other threads, and believe I'm good on how to protect it, etc. I buy a rate outside box correct? ...
4
votes
1answer
2k views

Replacing outdoor outlet

How can I replace an outdoor outlet cover that has a stripped center screw? Do I need to replace the outlet as well? Do I need to replace the box that the outlet is housed in if it is coming out ...
1
vote
1answer
1k views

How do I add an outlet to the end of a circuit that terminates with a recessed light fixture?

I have a closet with a light switch and a recessed light. I want to add an outlet to the ceiling of the closet. I have really good attic access to the recessed light, so actually placing the ...
2
votes
1answer
715 views

Switched outlet in my attic - requried by code to not always be hot?

I was installing an HDTV antenna in my attic and there's an outlet up there to which I can plug in the amplifier. The problem is that both outlet plugs are switched - they're connected (along with two ...
0
votes
2answers
900 views

How should I mount a rework box if it has to go through an MDF/wood panel and drywall?

I need to install a combination power and low voltage box in the ceiling of my finished basement for my home theater projector. I can't bolt the projector mount directly to the studs because of ...
5
votes
1answer
2k views

How do I wire a switch/receptacle combination?

Here's my current situation. I've got 14/2 to the ceiling. The hot wire has a runner, which runs down to the switch, and the other wire is a switched hot, back to the light. The other side of the ...
1
vote
3answers
1k views

What are the pins in this socket?

What's the correct orientation for a plug in this outlet? What are line, which are neutral, which is ground? It's from India.
1
vote
3answers
8k views

Why does this switch throw the breaker when turned on?

I volunteered to help a friend with an electrical problem she was having - two of the receptacles in her bedroom did not work. All the receptacles that I looked at had two black wires and two white ...
5
votes
3answers
414 views

Provisioning for a hypothetical electric car

I'm doing a remodel on my house which involves building a new garage. I have no plans to get a new car soon but presumably will in 1-5 years. How should I wire for an undetermined electric vehicle (...
1
vote
1answer
250 views

Can I install a new outlet here?

I saw a blank faceplate at our new place, decided to open it up, and found two black cables going straight through the box (see picture). This would be a great spot for a new outlet, so I wanted to ...
3
votes
1answer
622 views

How can I provide GFCI protection to my kitchen receptacles?

I Live in Round Lake, Il., in a 1940's built home. In my kitchen I have four counter top receptacles surrounding my sink area. Two of the receptacles are close to the sink, and I want to replace them ...
1
vote
3answers
15k views

How can I trace an electrical cable?

I'm installing a wall mount over an existing electrical socket - so I want to remove the socket I've read that just capping off the Hot and Neutral wires is not the best approach and that ...
2
votes
1answer
762 views

Is this surge protector defective?

I have purchased a high quality surge protector of a known brand in my country featuring six outlets. However, when I plug the adapter of my laptop into it or the surge protector or plug the surge ...
1
vote
1answer
3k views

Shorted a wire and now no outlets work

I turned off the wrong circuit breaker by mistake and when I cut a wire thinking it was dead there was a large spark. I went to the circuit breaker box and the circuit breaker did not look as though ...
1
vote
0answers
2k views

Wiring Leviton Timer to Bath Fan and Switch to Light

I am a DIYer with a basic knowledge of electrical wiring. I am having trouble wiring a bath fan to a timer and light to a switch. I can get get power to one or the other, not both. Here is the ...
4
votes
1answer
3k views

How do I wire this 30A 250V straight blade pass and seymour receptacle?

This is the receptacle I'm trying to wire. The ground says green next to it, but the other two wire inputs don't say anything. I need to know which is positive and negative. there is no + or - the ...
2
votes
1answer
94 views

How do I replace my electrical receptacle?

There is 1 hot and 4 neutrals tied into one receptacle two neutrals on each screw with one hot on the other side. I want to put GFCI in its place on that circuit. I added a GFCI receptacle downstream.