Questions tagged [plaster]

The tag has no usage guidance.

Filter by
Sorted by
Tagged with
0
votes
2answers
5k views

Tile over Plaster (bathroom)

I am remodeling a bathroom to add a shower to a previously tub only bathroom. It is an older home (Built late 40's) and I believe the two interior walls are lathe and plaster the exterior wall I ...
1
vote
1answer
125 views

What can we do about a section of plaster that has fallen off the wall?

We have an old style terraced house which normally has a breast wall which accounts for the chimney; either side of this are two alcoves that are set back perhaps half a foot. The dimensions of these ...
4
votes
1answer
1k views

What's the best practice for non-90 degree corners on drywall / plasterboard?

I am putting up some drywall in my basement which has been tanked out. I'm using metal C-Stud to keep the plasterboard away from the walls. Am just about to board round the bay window and wanted some ...
3
votes
2answers
9k views

How do I prep and plaster a bowed wall before tiling?

I'm about to tile a shower alcove. However, I put a straight edge against the walls and the rear wall bows out very badly. The wall is 950mm wide and putting a straight edge across shows a gap about ...
0
votes
1answer
2k views

Repair/replacement of overdrilled wall

After taking down one of those cantilever "invisible fixing" Ikea LACK shelves, I discovered that there were twice as many holes in the wall as required and all of them were enlarged and ruined (the ...
2
votes
1answer
832 views

How can I fix a large gap between wall and countertop caused by bowed walls?

We live in an old house with plaster walls. We recently installed a new counter top and discovered that our walls are bowed and curvy. There is approximately a 3/4 inch gap on either side of the bow. ...
2
votes
1answer
1k views

Can I stud out a wall without removing the plaster

I'm in the process of re-doing my kitchen. One of the issues I have to deal with is that the original construction is double brick, furred out with 1 inch strips, then plaster over gypsum. This ...
2
votes
3answers
2k views

Is plastering a job best left to the professionals?

We have moved into an older house which needs re-wiring - the plaster is also in poor condition so a fair amount of plastering is going to be required over the next few months. We are trying to save ...
1
vote
2answers
2k views

Repair long narrow gap in plaster

I need to fill a tall narrow gap in a plaster wall as shown in the image below. My question is: what is the best way to repair this? I have cut some ~1 pieces of drywall to fill the gap then tape the ...
1
vote
1answer
472 views

What does this concrete pool surface look like?

This is a surface of a concrete pool after an acid wash. I first thought it is plaster covered with paint, but then, by the feel and look of it, it does not seem to be paint. Hence I have several ...
2
votes
1answer
950 views

How do I smooth a concrete pool surface after an acid wash?

After an acid wash, the surface of the pool is very rough. What should I do to smooth it out?
6
votes
3answers
2k views

What tool and technique do I use to achieve this finish in plaster?

Our shed (in Switzerland) has an outdoor wall that is finished with plaster texture called crépi here which Google translates as roughcast. The plasterer here says it is impossible to replicate today. ...
0
votes
1answer
287 views

What should I use to fix chips in veneer plaster?

I had some water issues in my shower and finally got fed up enough to remove the miss-cut plastic back-splash that previous contractor had tried to install using thin-set. Upon removal I found a ...
4
votes
2answers
318 views

What should I do about this unfinished corner?

I've got this bit next to my back door that looks like it was never properly finished. There doesn't seem to be any structural issue, so I'd feel comfortable fixing it myself. Trouble is, I have no ...
2
votes
2answers
32k views

Mudding over plaster walls with pre-mixed joint compound

I just read a blog stating that pre-mixed joint compound should not be put over pre-existing plaster walls. Why? What is the best product to use?
0
votes
3answers
21k views

Drywall over plaster with furring strips

So I just removed staple on ceiling tiles from my curling to find they were done on top of plaster, my questions are: 1) is there any fear in any case of the drywall adding to much weight to the ...
3
votes
3answers
6k views

Should I be concerned about the repair to a ceiling after water damage?

We're in the middle floors of an apartment building and have had some damage done to our bathroom ceiling around the manhole due to some leaking pipes (minor rupture so there was a bit of water). The ...
4
votes
1answer
825 views

How do I make channels in plaster for electric lines?

Most of my walls consist of solid plaster over masonry, which makes electrical work difficult to say the least. I want to add some wiring to an existing wall in order to add light fixtures to a room ...
2
votes
2answers
4k views

How can I figure out what material my row home's interior and party walls are made out of?

I'd like to hang some shelving on the wall in my kitchen that separates my home from my neighbor's. How can I figure out what material this wall is made of? The home was built in 1950. The party wall ...
2
votes
1answer
733 views

How do I repair damage to the plaster on my bedroom ceiling?

I have noticed that the ceiling plaster in my front bedroom seems to be crumbling off and the ceiling around where it is coming off feels spongy. My house is a mid terrace over 100 years old I guess. ...
5
votes
3answers
698 views

Should I fix my swimming pool with plaster or a clorinated rubber?

I have below ground swimming pool. The plaster is cracking and pealing off. I need to apply new plaster or another type of coating. I am wondering whether it would be easier to apply a coating of ...
11
votes
3answers
700 views

What type of drywall tape should I use for a drywall to plaster patch?

What would be the best drywall tape for drywall to plaster patch? The patch is on a non-insulated garage ceiling, so there will be temperature swings from 0 to 100 probably through the year. I had ...
2
votes
2answers
2k views

Soft crumbling walls, electrical mounting box

I wonder if anyone can help. I'm having my kitchen refurbished including the electrics but when my partner tried to insert and secure the mounting boxes into the wall the plaster around it has ...
9
votes
1answer
2k views

What distance should I see between studs in a wood frame home built in 1943?

My house was built in 1943. It is a wood frame house and the interior walls are lath and plaster. My goal is to find the studs so I can mount a TV bracket for a flat screen TV. I have read that the ...
4
votes
2answers
4k views

How do I repair crumbling wall plaster?

I found this in a closet behind something that a previous owner had nailed into a wall. It's inside a closet, so it doesn't have to look pretty, I just don't want it to keep crumbling. I was going ...
1
vote
1answer
150 views

“Recipe” for home-made SmoothOver?

Polycell sell a SmoothOver product that is a "quick and easy way to transform cracked and damaged walls to a perfectly smooth surface that's ready to paint. Fills imperfections such as cracks, gouges ...
2
votes
1answer
3k views

Is it necessary to fully cure plaster if covering if with a layer of joint compound before paint?

So I have a wall that I had to replaster. Usually, what I do with plaster walls is, because I am never happy with the smoothness of plaster alone, apply blue lightweight drywall joint compound and ...
1
vote
0answers
404 views

Should I worry about plaster walls in bathroom?

I just moved in to a new house, which has plaster walls. I was told that the owners never took a shower, due to worry over the walls. There is tile all over the walls, but I still wonder if I should ...
2
votes
1answer
1k views

How can I repair severly water-damaged interior wall plaster or sheetrock?

A water issue with a rain gutter has caused damage to my interior wall: How should I repair the damage in the process of preparing the wall for new wallpaper?
1
vote
0answers
1k views

How long should I wait for plaster to dry/cure between coats?

Even though I am in the U.S., my city row house is old and the brick walls attaching to neighbors on each side have an inch thick plaster. During the recent demolition/renovation, I had to tear some ...
3
votes
1answer
177 views

Can I mix joint compounds with different setting times to get a custom setting time?

I'm currently skim coating some really bad looking walls and my 45 minute joint compound is setting too fast for me to get a nice finish. Can I mix the remainder of my 45 minute Joint Compound with ...
2
votes
2answers
5k views

How do I tape a joint between drywall and plaster?

I have old old plaster (on lath) bordering new drywall. Is it better to use mesh tape or just paper?
1
vote
3answers
3k views

Will plaster on basement walls and ceiling provide insulation?

My basement's insides are completely unfinished. It has bare brick walls and bare concrete beams-vaults as the ceiling. I though of coating the walls and the ceiling with 2 inch thick plaster with the ...
2
votes
1answer
934 views

How can I hang a heavy mirrored bathroom cabinet?

I purchased a bathroom cabinet today that is 1200 mm wide, by 750 mm tall, and 150 mm deep. When I brought it home, I discovered it weighed nearly 40 kg (88 pound) empty. I was told that I could use ...
6
votes
3answers
633 views

How can I tell if the sagging in my plaster ceiling is getting worse?

We moved into an old house, and one room still has the original 1890 horsehair lathed plaster all over. On the walls it's the consistency of sawdust held in place by a layer of paint. On the ceiling ...
3
votes
2answers
536 views

Settlement crack - is this one?

Presently disagreeing with a letting agent responsible for a property I recently moved out of over a large wall crack. This crack was there (albeit smaller) when we took residence, and it has become ...
3
votes
2answers
1k views

What should I do to make good on some lightly water damaged plaster?

When we moved in to our house (an early 1970s build in the UK) we noticed some damage to the plaster above a window; the surface was uneven and some was loose. It appeared dry so the surveyors and ...
0
votes
1answer
159 views

Which pH should I aim for when neutralizing restored/refinished antique surfaces?

I have recently used different chemicals to restore, refinish and treat various types of wall and millwork surfaces. E.g. I have stripped old paint using Peel Away 1 from plaster and antique millwork,...
6
votes
1answer
2k views

Is it possible to earthquake-proof furniture when you have plaster walls?

Is it possible to earthquake-proof furniture (e.g. tall bookshelves) when you have plaster walls? I was dissuaded from attaching to studs by an employee at a local hardware shop, while at the same ...
3
votes
1answer
1k views

What considerations do I need to make when mounting heavy objects on plaster walls?

I have just moved into an old apartment in Brooklyn. The landlord has warned us that all the walls are plaster with wood framing. I have not dealt with this type of wall before. I would like to hang ...
4
votes
2answers
11k views

What's behind the hard plaster walls?

Most of the walls in the old part of my house are plaster. Hard, nasty, amazingly solid plaster. While this is nice in some areas, there's others that it's rather annoying -- such as on the stairs (...
1
vote
0answers
831 views

What should I do about baseboard anchors in plaster-over-brick walls?

I am restoring some plaster walls in my very old house. Most of the areas that need restoration are around the bottom of the walls since I ripped out old ugly baseboards and that also crumbled the old ...
2
votes
0answers
1k views

How do I finish an outside corner where plaster meets exposed brick?

I have an outside corner where plaster on one side meets exposed brick on the other. It all used to be plaster but I stripped off the side where it's now brick. The line is pretty straight cause I cut ...
3
votes
2answers
4k views

Can drywall with ripped paper be repaired?

I damaged some drywall when doing demo in a bathroom. Some of the paint peeled back and exposed the paper, which ripped off of the drywall. Can I do a thin coat and sand? please help, already ...
3
votes
1answer
9k views

How do I repair cracks in a plaster ceiling?

I have a bungalow house built in the early 1930's. It is in remarkable condition and has been well maintained. In the last few weeks a few cracks have shown up in the ceiling. There is an upstairs ...
6
votes
3answers
3k views

Is there an easy way to make a square hole in plaster/brick to put an electrical outlet box in?

I am about to fix a few new sockets, I can run the cables down the back of some built in cupboards, but would rather not use surface mounted sockets. I do not have a SDS drill, just a standard hammer ...
2
votes
1answer
986 views

How can I damp proof this wall?

I have stripped plaster from our dining room walls to reveal the brickwork in preparation for plasterboard and skimming. The room features one main exterior wall and an adjoining wall. Prior to ...
1
vote
1answer
1k views

How can I patch 1“- 2” gaps between coved plaster ceilings and new sheetrock walls?

We had to replace some old lath/plaster walls with new sheetrock. We left the coved portion of the plastered ceiling in place, but where the sheetrock meets the coved ceiling there is a 1" - 2" gap (...
4
votes
1answer
213 views

How could I fix up some old plaster

I'm in a house where the plaster was done in an old style. Not lath-and-plaster as one of the tags suggests but simply plaster mixed in with hay or something fibrous on top of brick. With the ...
1
vote
1answer
2k views

sanding old plaster wall texture to prepare for mudding

Should I sand/grind old plaster texture before skim-coating? If so, what is the best tool to use? The goal is to prepare for new smooth walls.