Questions tagged [lock]

A device for securing access, typically on a door, and typically controlled with a key or combination.

Filter by
Sorted by
Tagged with
27
votes
5answers
200k views

What kind of lubrication should I use for a lock?

I recently made the Yale lock on my front door much easier to open by spraying some WD-40 in there. However, I just saw this question on WD-40 not being a “true” lubricant, and wondered whether it ...
3
votes
1answer
11k views

How do I replace mortise locks with bored cylindrical locks?

I purchased an older home that has mortise locks in all of the doors. They're all very difficult to use and some of them don't work at all, making the doors difficult to impossible to close. Since I'm ...
26
votes
3answers
10k views

How to open a door that has the insides of a door handle inside without a door knob

Currently this is what my doorknob looks like below I was trying to change out my doorknob and left both sides inside of the room but the AC kicked on and shut the door on me and now I am stuck ...
6
votes
5answers
18k views

How can I prevent an outside lock from freezing?

I store a bunch of the "outside stuff" in the shed for the winter. Mainly things that I only use when the weather is warmer. It pretty much remains locked up for the winter. Occasionally though, I ...
5
votes
5answers
3k views

Where can I find a key for my old locks?

My house was build in 1938 and the whole house has these door knobs everywhere. I believe they were made by Dexter. Is there a way to ID them properly and, if so, where can I find someone who makes a ...
4
votes
1answer
5k views

How can I remove a Mortise Lock and deadbolt from a door?

I got an old door from a junk yard that I'm trying to reuse. The door is going to end up being sliding barn door so I have no use for its existing door knob and lock mechanisms. From what I can tell ...
2
votes
4answers
92k views

How to drill a hole in the wood without an electric drill?

During a travel in Laos, I need to drill some holes into a double-door's wood to install a locker. The wood is rather hard, and I don't have an electric drill (and can't find it). I only have 2 small ...
1
vote
3answers
376 views

Temporary lock for a door

Is there a way to lock a door temporarily without making modifications to the door or its frame; or making minimal modifications like screw holes. I don't want to be cutting big circular holes in the ...
1
vote
1answer
650 views

What can I use to back a door jamb strike plate with no framing behind?

So I'm trying to replace the original entrance handleset door lock from my almost 100 year old house and after removing the old lock and patching up the holes. I looked inside the door jamb and ...
0
votes
1answer
69 views

Door Jamb Rotted Where Latch Goes

I just installed a lock in my door and when attempting to install the latch I found that the wood was splintering and not stable, so I cut it out. My problem is similar to this one. What can be ...