Questions tagged [load-bearing]

A load bearing wall supports the structure above it, and thus cannot be removed without replacing that support. Use with the [walls] tag

Filter by
Sorted by
Tagged with
41
votes
4answers
30k views

Are there ways to determine if a wall is load bearing?

Other than looking up blue prints, which many homeowners may not have, are there ways to determine if a wall is load bearing? Methods I can think of might include: Going up in the attic to check if ...
8
votes
2answers
153k views

Proper size of header to support new door in load bearing wall?

We're going to install a new linen closet off the hallway next to our recently(ish) remodeled bathroom. The wall in question is load bearing. I know how to properly build out the King and Jack studs,...
27
votes
5answers
17k views

Is it unsafe to remove one stud from a load bearing wall?

I need to cut a hole for a recessed medicine cabinet. This wall is at the end of the house. I only need to cut one stud to make a frame for the cabinet. Will this damage the integrity of the bearing ...
3
votes
1answer
22k views

Can I build a pergola on an existing deck, without digging more footers?

A couple of years ago I built a deck onto my house. It is 32' x 14' I used a cantilever design at 12' with 2x8" floor joists, with 2x6" decking boards. The Cantilever beam was set on 6x6" posts that ...
16
votes
5answers
16k views

Contractor cut joist hangers to make them fit

(edited with additional info re. header) We are removing a couple of load bearing walls as part of renos in our home. The engineer specified a W8x21steel beam to replace the load bearing wall. The ...
10
votes
1answer
922 views

Can I modify a load bearing triple stud?

I am installing a small safe in a wall and when I cut the opening in the drywall I noticed that the studs were in an unusual distribution. The stud on the right was normal but then there were multiple ...
2
votes
1answer
2k views

How to estimate the load bearing of MDF plates on a wood/beam construction?

I have a 2000mm x 1400mm x 15 mm MDF panel (green) which I want to use on a to be constructed high plane for a bed and some space around. The depth should be 1600mm. The room is not rectangular which ...
2
votes
1answer
117 views

load bearing stair components

I've just opened up the under stair area with a plan to convert into storage. Can anyone tell me what parts A and E are doing in the following images? They don't appear to be load bearing to me. I ...
2
votes
1answer
7k views

what is the design load limit for a jack stud and header plate?

Assuming an over-strength column composed of one jack and two king studs - how much load can a single jack stud support - assuming #2 stud grade SPF for the header and jack. I've found a table that ...
2
votes
1answer
607 views

What would a calculation be for the weight bearing capacity of 6 x 2 studwork?

I'm building a campus board (a training aid for rock climbing) and my landlord wants to know how someone can be sure a person's body weight can be supported from it. I'm at a loss on how to give him ...
1
vote
1answer
311 views

Is this wall load bearing? See photos

I'm looking to tear down the wall between my kitchen and dining room, and I'm wondering if it's load bearing. If so, it's a 9' section that I want to remove. Would two 2x10s with 1/2" plywood ...