Questions tagged [lath-and-plaster]

or "plaster and lath" is an old fashioned technique for finishing interior walls. It consists of horizontal strips of wood (the laths) nailed to the stud work and then that is plastered.

Filter by
Sorted by
Tagged with
1
vote
0answers
24 views

How to get new wire into old box in plaster wall?

I'm rewiring my house, which was built in 1921. I need to bring new cable to a triple-wide switch box (see photos). I cannot push the old knob & tube wire out through the knockouts--it must be ...
2
votes
3answers
272 views

How to keep Structolite from cracking as it dries

I have a house that was built in 1901 and needs a lot of plaster work. I've tried both Structolite and Gypsolite as a base coat over bare brick. Both of them crack as they dry, less than an hour after ...
0
votes
1answer
66 views

Plaster and Wire Mesh - dating?

My home dates to the 1890s. It has clearly been through many renovations over the years before I owned it. The walls in my living room have defied all stud finders: normal ones find nothing, magnetic ...
0
votes
1answer
66 views

Is there space between plaster ceiling lath and joists?

Two story, midwestern suburban colonial built in 1947. Gable roof. Plaster walls and ceilings. House faces north, and ceiling joists run north-south direction. I am hearing rodents inside of interior ...
1
vote
1answer
31 views

What kind of paint should be used on old plaster and lathe walls?

Are the steps to painting a plaster and lathe walls, house is early 1900's, the same as any other type of wall? What type of primer should be used? What type of paint? On the internet I read about the ...
4
votes
4answers
149 views

How should I fill channels left in old plaster after dado rail removal?

I just purchased a condo in the Boston area. The house has been built early 1900s. I'm removing dado (chair) rails in the dining room that don't look great and are just dust collector at this point. ...
0
votes
2answers
64 views

What is the role of re-enforcing mesh in plastering, when is it required, and which mesh types are prefered?

What is the role of re-enforcing mesh in plastering? Keep in mind, I'm not talking about the lathe, which is shown in this image. I'm talking about the mesh, shown in this image. When is a re-...
1
vote
2answers
92 views

Based on the picture, what do you recommend using to patch this hole?

This is a 90 year old lath and plaster wall that was cut into to install a thermostat. The hole is 1.5" by 14". Should we use: drywall patch mesh tape and joint compound just plaster ...
0
votes
1answer
116 views

What do you think this odd layer under wall paper may be?

I'm taking down wall paper in my 1920s house. The walls are plaster/lath. At some point, the room seems to have been skim coated, primed, and then wallpapered. The wall paper has come down fairly ...
0
votes
1answer
3k views

What can I use to fix a gap between the light fixture and the ceiling?

It's a very old house that the ceiling is made out of lath and plaster so it would be too much work to dig a hole to put in a large junction box for the wires. They won't fit in the base of the light ...
0
votes
3answers
123 views

What is the best way to fix broken OLD plaster in a very old house? [closed]

I've recently bought a house which was built in the 1900s. The entire plaster walls are covered with wallpapers. First time home buyer mistake, our first project is to remove the wallpaper and paint ...
1
vote
2answers
669 views

How should I go about insulating a 1920's stucco house in LA?

I own a two story, 3200 Sq ft house in Los Angeles. The exterior is stucco and the walls are lathe and plaster. A year ago we had some water damage after a rain storm. When the contractor demo'd ...
6
votes
1answer
728 views

How to patch a wood lath plaster rounded corner?

I am attempting to repair a rounded plaster corner. (Image below). The plaster was blown out during an electrical re-wire for the bathroom switch pictured. I’m assuming the wire corner bead runs ...
1
vote
1answer
106 views

Exposed lath and keys on entire ceiling

We bought a house built in 1846. In one room, the ceiling has suffered immensely from a previous, serious roof leak. In said room, almost all the plaster skim coats over the lath and keys are missing, ...
12
votes
6answers
31k views

Am I having trouble finding studs because my walls are lath and plaster?

I picked a TV mount from Ikea. The TV itself is being mounted to some paneling which in turn is mounted to set of wooden draws. In addition, it gives you hardware to mount the panels to the walls. It'...
0
votes
1answer
537 views

Securing French cleats to drywall over lath and plaster with structural screws

I'd like to build a French cleat storage system on an exterior wall in my basement shop, but am concerned about whether the cleats will have sufficient support given the construction of the wall. The ...
4
votes
4answers
812 views

Can I use hollow wall anchors in a lath and plaster wall?

I have a stable enough lath and plaster wall, which I would like to put a box framed picture on. Usually with a box frame picture on to a plaster board or dry wall, or even a brick or stone wall, I'd ...
0
votes
2answers
2k views

How to take down a lath and plaster ceiling

I have a lath and plaster ceiling to remove, but it is quite large, and my first attempts have created masses of dust. Is there some way to take it down easily? (For example, would lifting the ...
0
votes
1answer
79 views

Hanging heavy things on old walls. Running out of options. What would you do

Just moved in to an old victorian home and the wife wants shelves in the mud room. Now I know what you are thinking "Shelves?! Seriously?!", Just hear me out. These are 6 foot shelves with 4 steel ...
0
votes
1answer
88 views

What is my wall made of and how should I hang a 50lb mirror?

I plan to hang a mirror weighing 50lb on the wall. What type of anchors should I use? I think my wall is plaster over drywall, but I'm not sure. The house was built in the US in 1952, and the surface ...
4
votes
2answers
1k views

How to anchor coat hooks and shelving in a rock-lath & plaster wall?

I've purchased an older home from an era when they used rock lath and plaster for the walls. I had never heard of this kind of construction, though I've done plenty of electrical wiring in older homes ...
1
vote
1answer
66 views

What methods for installing light fixture in middle of room, with lathe and plaster ceiling?

What options are there for running electrical to the middle of a lathe and plaster ceiling? My room is about 9' by 9' with a slab floor. The joists run east-west, and the lathe runs north-south. ...
0
votes
1answer
483 views

Repair Small Holes In Brown Coat & Plaster

Removing nails from a plaster wall results in much of the surrounding plaster cracking and falling away. The brown coat under the plaster is a sand aggregate that also starts to crumble easily since ...
0
votes
2answers
812 views

Cut plaster hole, without hole saw, options?

I need to cut one 6" hole for a can light into a plaster ceiling and don't want to spend the money on a hole saw. What are my best options?
0
votes
1answer
220 views

What metal is along the top of a plaster wall in a 1930s house?

I have a house built in the 1930s with lath and plaster walls. I was planning to install a hook, so I needed to find a stud. My normal stud finder didn't work (as expected), so I used some rare earth ...
2
votes
1answer
651 views

How to deal with lath and plaster over top plate of partition wall?

I'm renovating a bathroom, and there was lath and plaster on one wall and in the ceiling, which I have ripped out. The problem is that the room was not originally a bathroom, but a bigger room that ...
3
votes
4answers
23k views

How do I patch a large hole in plaster and lath?

I am having some plumbing repaired in my 1913 house that will result in a large access hole (2' x 16") on the first floor. The wall is currently plaster and lath and I'm trying to get a handle on the ...
2
votes
3answers
2k views

How can I effectively replace sections of 7/8" plaster with drywall?

We had to take down several large sections, about 6x4ft sections, in order to run updated electric. The problem is that the 3 layer plaster is 7/8in thick. What is my best solution to put up new even ...
12
votes
5answers
19k views

How to fix cracks in lath and plaster?

I have an old house with lath and plaster walls. When I moved in a year ago I fixed dozens of cracks in the plaster with spackling, but many of them have opened back up again. What is the best way ...
0
votes
0answers
77 views

Fixing up a 1920 Rowhouse - second floor ceiling insulation

So - I thinking of pulling the whole plaster and lath ceiling down in a second floor bedroom and putting up drywall and thought might be a good opportunity to insulate between the roof and the ceiling....
2
votes
1answer
2k views

Broke plaster anchoring electrical box

I put a little too much pressure on my electrical box when tightening down a new switch. It was previously anchored by what I believe was overhanging tabs on both the top and bottom of the plaster, ...
0
votes
1answer
115 views

Repairing lath & plaster wall- structural elements

I'm repairing/replacing a lath & plaster external wall in a tenement flat. It has been very badly mould damaged by long term damp, the source of which has now been fixed. The plaster was in very ...
1
vote
2answers
11k views

How to fix a stripped hole in a plaster wall?

I hired a "professional" painting crew to paint the stairs area, where the crew installed new brackets for the handrail. Unfortunately I did not supervise the work myself. I recently noticed that I ...
1
vote
1answer
743 views

Found Lath and Plaster wall under remodel drywall. Is it restorable?

I'm currently in the process of restoring my 1906 home's bathroom. At some point in the last 10-15 years the bathroom was given a cheap remodel. New plumbing and outlets were run and drywall was hung ...
1
vote
1answer
68 views

All new Plaster needed for unmodernised Victorian Terrace?

I've seen and am tempted to put an offer on a (mostly) unmodernised Victorian terraced house in London, UK. The interior walls are a bit of a state.. layers of paint and wallpaper, and where the ...
2
votes
3answers
16k views

Merge walls of different thickness on same vertical without notice

Picture a plaster wall. Now imagine that a significant section has been removed of it and now needs replaced. Ive tried to replace the plaster with 1/2 inch only to realize the wodth difference im ...
9
votes
6answers
15k views

How can I install a recessed light container in an abnormally thick ceiling?

We are in the middle of our home remodeling and we have just noticed that our ceiling seems to be a bit thicker than what the maximum our recessed lights allow for. As shown within the picture link ...
2
votes
2answers
1k views

Repairing small damage to outside corners. Plaster walls.

I'm thinking of using bondo. Is there a less-complex way to do it. I'm concerned that regular plaster material will fall off.
1
vote
1answer
395 views

What to do about a damaged stipple ceiling?

We have a stipple ceiling in our master bedroom, it appears to be lining paper over lathe & plaster with stipple/textured paint over that. We are concerned that it may have asbestos in it (we are ...
0
votes
1answer
495 views

What is this thin metal wire in wall of 50s home?

What is the purpose of this thin metal wire? It attaches to a nailhead on the other stud, which is securing an electrical box. Is this a grounding wire or something else?
0
votes
2answers
786 views

Repair damaged plaster behind door trim

I have begun pulling off the original trim in my 1920s townhouse. The plan is to strip away the 100 years of paint to reveal some of the detail. The plaster behind the trim is in pretty bad shape. Do ...
2
votes
3answers
2k views

Attach partition wall to lath and plaster wall

I am looking to add a small closet (2×4 ft) in the corner of a room with lath and plaster walls. I would like to frame in two sides and attach it to the existing wall. Do I have to limit myself to the ...
1
vote
3answers
392 views

Importance of plaster repair skills/experience

I have an old 1920's house in the Chicago area with many lath-and-plaster walls and ceilings. We are going to be removing a whole-house fan, which will leave a 3' square opening that will need to be ...
1
vote
2answers
4k views

How can I tell if there is brick behind plaster on a fireplace?

We have a 1952 home with a fireplace in it (original to home). There is brick around the opening of the fireplace, then a wooden frame and then plaster about 8" past the wood frame and back about 8" ...
2
votes
2answers
2k views

Unable to screw through plaster and lath wall

I am trying screw in a 2 1/2" screw into a wall that I'm pretty sure is plaster and lath. But when the screw is about 1 1/2" deep of drilling, it doesn't go in anymore no matter how much force I put ...
4
votes
1answer
2k views

Plaster Wall Ice Damming Water Damage

A couple weeks ago ice damming in my gutters caused a lot of damage to my plaster wall inside my house. I got an estimate of around $2500 to fix the issue so I'm going to attempt it myself. Here is ...
3
votes
1answer
854 views

How can I attach a curtain rail to a lath and plaster wall?

I need to attach a curtain pole (for a heavy curtain) above a window. To be consistent with another window in the same room, I'll need to affix a 4-inch wide strip of wood to the wall, and attach the ...
1
vote
1answer
691 views

Can I mount a 60" TV and mount weighing a combined 95 pounds to a drywall or plaster? [duplicate]

I cannot find studs on my firewall but, when I drilled a hole on the wall, it seems to me that either the plaster or drywall was thick enough (like 1/2"). Can I Mount a 60" TV and Mount Weighing a ...
3
votes
1answer
2k views

How do I patch a 3'x3' hole in a ceiling made up of plaster, lath, and metal mesh?

I've fixed leaks above my plaster-and-lath-and-chicken-wire ceiling, and now I need to fix the ceiling below it. The ceiling is a sandwich of wood lath on top, then 1/4" of solid plaster, then ...
3
votes
3answers
17k views

What is up with this wall, and what is the right way to hang something on it?

I just moved in to a new apartment, in a very old house. The landlord mentioned that it is over 100 years old. The walls are plaster, which means (to the best of my knowledge) that there is lath ...