Questions tagged [installation]

For questions generally relating to the proper insertion of a particular device or feature into a home, building or other structure. As this topic is very broad in general, when using this tag please include additional tags to narrow the scope of the discussion to a particular room, subsystem (electrical, plumbing etc) and/or feature (tile, appliances, cabinetry, lighting).

Filter by
Sorted by
Tagged with
-5
votes
1answer
87 views

Getting electricity to the woodshed [closed]

Have 200ft from panel box to wood she'd what kind of wire am breaker for air compressor refrigerator two hanging light 4 Outlets table saw
4
votes
2answers
195 views

How do you calculate the right size furnace to maximize efficiency?

Given that sizing of the equipment is the most important issue to get right to maximize efficiency, what are the factors an installer should take into account to determine the correct size? Is it ...
0
votes
1answer
121 views

Furnace installation: What separates the good from the bad? [closed]

This page says, Poor installation can reduce [a high-performance furnace] to a mediocre furnace Conversely, asm-air writes, Remember, who installs your HVAC unit is more important than what ...
2
votes
2answers
899 views

Is it acceptable to drill a hole in the cabinet 'floor' underneath the sink to put a dishwasher hose through?

We are installing a dishwasher into an old house that has never had one, and want to know if it would be acceptable to drill a hole in the cabinet floor underneath the sink to run the hose through? ...
2
votes
2answers
3k views

Question about picking best wax gasket for toilet (specifically Toto)

I have a question about replacing wax gasket on a toilet. I hope my question is not too simple as this site is advertised as "serious DIY".My toilet is a Toto Aquia model ST464M, but I would think ...
1
vote
3answers
1k views

Where to install a carbon monoxide detector when the boiler is in a closet?

I have a boiler in my kitchen closet. The installation instructions for my carbon monoxide detector say the detector should be: at a horizontal distance of between 1m and 3m from the potential ...
4
votes
5answers
2k views

Can I mount 3 blades on a 5 blade ceiling fan?

In my son's bedroom I currently have a standard five-blade ceiling fan. We are currently changing the decorating motif in his room to "airplanes". I thought it would be really cool to change the ...
0
votes
2answers
73 views

need help with a pdu unit installation

so i recently been gift with a pdu from APC is an AP7864 this thing says that works with 120v/208v.3~ now the connector is a L21-220 wich has 5wire 4 poles, this thing is rated for 3 phase and a ...
1
vote
1answer
101 views

How can I lower wall cabinets after fitting drywall?

Before fitting a drywall, I measured 12cm from the ceiling and fitted battens (wall studs) across the length of the room to support wall cabinets. I didn't leave enough room - the wall cabinets are ...
1
vote
1answer
145 views

What are the risk of floating a solid hardwood above grade floor using a clip system?

I have been mired in this rabbit hole of picking a flooring for my new condo. I cannot glue or nail into concrete so I either I double floor it with plywood then hardood or I float. I have been ...
3
votes
1answer
91 views

Can a floating floor of click connected strand bamboo cup

I am in the market for some wood flooring and due to condo constraints I am forced to go with a floating floor. I am probably going with bamboo from Plyboo or Teragren. I am concerned about the ...
0
votes
1answer
699 views

How bad is the seam on my quartz kitchen countertops?

How bad is this seam on my quartz kitchen countertops? I am not sure if this is normal or how bad this is. I know there is usually a seam but this seems a little big to me.
1
vote
1answer
161 views

Tips and tricks to installing cabinet doors and mounting hinges

What are some tips to installing cabinet doors and hinges so that they are positioned correctly and look good? I've been to some showrooms (IKEA) where the doors look slightly crooked or they don't ...
2
votes
1answer
634 views

Standard Grade and Curb Height for ADA Compliant Shower Floor

I am managing replacement of a bathtub with a walk in shower for my mother in her condo. The HOA is demanding a shower grade of 1 inch per foot which seems far to steep for a person with disabilities. ...
1
vote
1answer
287 views

How to secure switch box flush with wall surface

Today I removed all the outlet covers in my home, and when I got to my bedroom light switch I noticed there was all this wood surrounding the switch itself. I tore that off as well, and after I did so ...
1
vote
2answers
1k views

Is installing a tankless water heater outside a good idea?

We currently have a gas water heater in our laundry room (part of a converted garage, on slab). The hot water and gas are (obviously) running to it with no problem. When I was getting a quote for a ...
0
votes
2answers
3k views

Can a toilet be properly installed without a flange?

Someone put a toilet in for me, he used different bolts than came with the toilet because he said the bolts that came with the toilet wouldn't work. He said the floor was rotting but he needed to get ...
2
votes
1answer
537 views

What type of substrate should I use to install pavers over an existing poured slab patio

I'm going to be putting pavers over an old slab patio. The current patio has settled and spalled, so I'm looking to pitch the paver patio in such a way that it drains as the original slabs did. In ...
1
vote
0answers
24 views

Is it necessary to cement down parimeter pavers when laying a paver patio [duplicate]

I'm going to be installing a paver patio over an existing poured slap patio. it is surrounded on two sides by brick wall, and a third side by pressure treat wood ( the side of a house build on ...
0
votes
3answers
546 views

Can I glue two 1“ solid oak treads to make one 2” tread?

I am licensed floor contractor in the state of California. I am installing solid oak treads in open steps in stairs 2"x12"x43", because open steps over 39" wide must be over 1 1/2" thick. But, 2" ...
0
votes
1answer
193 views

Water pipe extension to livestock corrals

I have horses and sheep that live about 100 feet from the main house/ outside water faucet. We want to install a pipe that allows access to the water down at the corrals, what sort of things should I ...
0
votes
2answers
222 views

Does this kitchen faucet fit with this sink?

I bought a kitchen sink and kitchen faucet. (Links are in a text file at this location because I'm not allowed to post more than 2 links.) https://www.dropbox.com/sh/zq4kbe5baavaodb/...
0
votes
1answer
1k views

fireplace door and stone veneer over brick fireplace

Do you install fireplace door before laying stone veneer or after the fact? Suppose you do it "BEFORE", then the installation is clear, you just screw that metal frame to the bricks from inside. Here ...
1
vote
1answer
56 views

Laminate Hardwood floor installation

I am installing a laminate hardwood floor. When I hung my drywall I left a half inch gap off the concrete to allow my flooring room to go under the drywall to cover. My question is, how do I allow ...
1
vote
1answer
1k views

How much expansion space is need for solid oak flooring?

I have purchased Bruce 3/4" solid oak flooring and I am looking for some guidance with respect to expansion space. This is standard tongue and groove flooring that will be nailed down. This is also ...
2
votes
1answer
2k views

Laundry box and water hammer arrestor

I am trying to install my new washer & dryer combo. There are a few things that I am not sure since plumbing hardware and markings are a bit different in the US compared to once I used in Russia. ...
3
votes
3answers
97 views

Can I install a hardwood floor in the kitchen?

I don't know if I can install a hardwood floor in my kitchen. What would you recommend ? Thank you so much Camille
7
votes
5answers
19k views

Advantages to quotes from Lowe's/Home Depot vs direct from contractors?

I am looking to have vinyl siding installed on my home. Are there any advantages to getting a quote from Lowe's or Home Depot instead of contacting contractors directly? It seems that this is just ...
4
votes
3answers
2k views

Faucet supposed to stick out this far?

A local plumbing company installed my tub/shower. In my uneducated opinion, this faucet doesn't look right and seems to be sticking too far out. Should it look like this? I don't want to be overly ...
4
votes
2answers
1k views

Shower surround - does it need adhesive?

I just had a plumbing company over to install a tub and shower surround. I noticed when showering that the walls all bounce against the studs if you touch them. Not sure if that's normal, I looked ...
0
votes
1answer
374 views

How to deal with a thick wire in a mounting nipples for a chandelier?

I have a chandelier that came with a very thick insulation on the wires which were intended for use as a plugged in lamp. I am installing it as a chandelier, and it came with the mounting hardware, ...
1
vote
1answer
2k views

Wood laminate floor wont snap together can I just nail it down

I bought a whole lot of this snap together wood flooring, thinking I would just snap it together and be done. The store was closing out all different styles and colors. I was going to just mix and ...
1
vote
2answers
2k views

I have a neutral wire, what do I hook that wire to?

I have 4 wires on a new switch, 2 of them going to ground. One green and one silver (bare) coming from the bracket of the switch. In the electrical wiring of the house I have a neutral wire, what do I ...
2
votes
1answer
185 views

Are these doors installed correctly, and are they secure as they are?

I hired a contractor to install 2 prehung fiberglass exterior doors in my home and I'm not sure if he measured incorrectly, but both doors have at least 1-1.25" of gap space on the sides between the ...
0
votes
1answer
2k views

How far from the wall should I put the toilet flange?

I'm installing a new toilet and I'd like to know how far from the back wall I should install the flange. I think that 12" is recommended, but I see that lot are installed closer. Sometimes as close ...
2
votes
1answer
867 views

How to install crown molding to ceiling only

I live near a bog. Our house heaves in the winter - BAD. We get large horizontal cracks along ceiling. We thought of ceiling molding to cover it but continue to read "nail to wall studs". Well that ...
1
vote
1answer
2k views

How to install timer on 3-gang switch

I am a newbie to tackling electrical projects and need some help. Thanks in advance! I am trying to install a Defiant digital timer for my garage flood light. The garage light switch is just inside ...
1
vote
2answers
1k views

How to install new outdoor motion sensing light [closed]

I have a new home which does not have any sort of outdoor lights for now. I want to install motion sensing lights on 2 of the exterior walls. I got a quote from an electrical contractor but he is ...
7
votes
3answers
5k views

Should I install drywall panels parallel or perpendicular to ceiling joists?

I am going to be putting drywall up on my ceiling soon and I am not sure which is the best orientation\layout for the drywall. The ceiling joists run horizontal to the following images. The section ...
4
votes
1answer
198 views

What are expansion joint requirements for magnesium oxide wallboards?

I was asked to get some information concerning installing magnesium oxide wallboards. It's a material I just got to know and never worked with, so I want to learn what are requirements for installing ...
0
votes
2answers
2k views

What do I need in order to install under cabinet lights?

I want to install hardwired, under-cabinet lighting, but I need some guidance on what kind of devices (transformers/drivers/adapters) I need to complete the project. I know very little about ...
4
votes
1answer
550 views

Metal doors, Mortise locks, and … mobile liner?

Spent last night retrofitting a fancy electronic combination lock on a metal door for the first time, and encountered something I don't understand. The door has previously had another mortise lock, ...
0
votes
2answers
2k views

What are reasonable expectations for LVP floor installation?

TLDR; What should a quality LVP floor installation feel like? Is it reasonable to have few barely noticeable soft spots? or should entire floor feel consistently solid through the entire area? I had ...
0
votes
1answer
70 views

PERGO Locking Hardwood Flooring in wet areas? [duplicate]

Can I install PERGO Locking Hardwood Flooring in wet areas?
1
vote
2answers
693 views

I need help identifying hot and neutral feed wires for sub panel installation

I am installing a sub panel in my garage this weekend. The previous owner had a subpanel in the same location, but when they moved they took the panel with them. The wires from the mains panel in ...
1
vote
1answer
153 views

TV Fixings - 40" LED fitted to drywall using one metal stud and snaptoggles is it safe?

My son has just fitted my new 40" LED TV to drywall. He did attach a board to the drywall but when he purchased the board he had assumed the metal studs were 18" apart not 24" so only bought a 20" ...
1
vote
3answers
4k views

Is an HVAC license required for DIY home owner AC installation in the State of Georgia?

Does anybody know for certain if in the State of Georgia, an HVAC ("conditioned air") license is required in order for a homeowner to install their own HVAC system?
1
vote
2answers
140 views

What can I do with vinyl tile where the floor edge is open, like at a descending staircase?

I'm thinking of installing vinyl tile in one floor of my house, but I have two places where the floor does not meet a wall, for example, where a staircase begins to descend. What sort of elegant ...
1
vote
3answers
215 views

mounting 60 inch TV with steel plates?

Mounting a 60 inch TV where studs are 22inches apart. Can I use 2 steel plates that are each 48 x 1 1/4 x 1/8 inch thick and then bolt them to my bracket and to the wall studs at each end and one ...
1
vote
5answers
1k views

Electrical engineering background, can I do electrical work on my house

OK Folks, some introduction. I wasn't born in the US, I come from the underdeveloped world, where due to lack of resources it was usual to have a pair of bare wires acting as a light switch (seriously!...

1 2 3
4
5
8