Questions tagged [hot-tub]

The tag has no usage guidance.

10 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
2
votes
0answers
75 views

How much D.E. does this Jacuzzi filter need when it says “3 scoops” on the label?

This Jacuzzi filter requires "3 scoops" of diatomaceous earth. How much is that in SI units?
1
vote
1answer
58 views

Can I wire both a 50 amp hot tub and 50 amp RV plug in the same box?

I have two projects in the works, installing a hot tub and building an RV pad. Both the RV and hot tub run on 50 amps and 220 volts. RV's plug-in but hot tubs are wired directly. Is there a single ...
1
vote
0answers
2k views

Is my electrical panel big enough for my hot tub?

I just bought a hot tub that requires a 240 volt, 50 amp dedicated circuit. My electrical panel has a rating of 100 Amps. Max. All the breaker slots are full but I am wondering if I could consolidate ...
1
vote
0answers
414 views

2000 Hotsprings Sovereign Will not heat

My 2000 Hotsprings Sovereign will not heat at all. Work Performed: Installed all new filters. Installed new 1.5kw/6kw replacement heater. Unhooked all hoses to make sure of no air locks. ...
1
vote
0answers
23 views

Hot tub heater turns off when both vents are open

My hot tub will turn on if one of the vents to the heater is shut. As soon as I open both the hot tub turns off. Any suggestions? Thanks
1
vote
0answers
2k views

What type of wire should I use to install a Jacuzzi J-345 hot tub?

I am installing electrical for a hot tub in my residence. I have a rough idea for a plan that I would like advice on. I'd appreciate your help in pointing out gaps with respect to the NEC. Hot Tub ...
0
votes
0answers
20 views

Hot tub water does not get warm

We had repairs done to the hot tub. Supposedly it is good to go. I feel like there's something I should do with the control panel (buttons) in order to heat the water up. I was able to set the ...
0
votes
1answer
81 views

How to remove broken freeze plug adapter in a spa pump

This is the wet end of the Emerson pump in my Jacuzzi spa. Pictured above is a broken freeze plug adapter. The freeze plug adapter threads into the pump (lower center of pic). It broke with part of ...
0
votes
0answers
39 views

Leveling the base for a hot tub?

A lot of outdoor concrete slabs / patios have a slope for drainage. If you put a hot tub in such a location obviously it would also be out of level. Is there any standard or recommended way to level ...
0
votes
0answers
96 views

Gfci breaker will not turn on at hot tub disconnect

I installed a new GFCI breaker for a hot tub on the deck in a separate box from the main panel. Wired it to the hot tub . but it will not turn on. Would a wire at a lug not fully secured cause the ...