Questions tagged [heater]

The tag has no usage guidance.

Filter by
Sorted by
Tagged with
0
votes
2answers
1k views

Bypass the Timer FM-DS3(e) on Hyundai heater

I have the oil heater Hyundai with mechanical Timer FM-DS3(e). I want to baypass the timer. Let the energy go on the heater. Looks like energy (red)cabel comes to 4 and one part of (white) cabel comes ...
3
votes
2answers
22k views

Water heater overflow outside drain pipe

My water heater's overflow outside drain pipe has been running hot water out of it non-stop. I turned the inflow water valve to the water heater off and the water stopped running. But what is ...
1
vote
0answers
151 views

My gas heater relief valve keeps blowing, is the circulator installed backwards?

So I had a contractor put in a new circulator last season. Its a honeywell PC3F. I tried turning my heater on for the first time this season and the relief valve blew. I tried replacing that and ...
3
votes
2answers
10k views

Why would a portable heater set off a carbon monoxide alarm?

I've got a small portable heater purchased from Target for about $10. When you first turn it on, it always has that burning smell from the element heating up. It clears up after about 10 min. ...
4
votes
1answer
2k views

What should I do with the white wire when wiring a 240 volt garage heater?

I was given a 240 volt garage heater from a friend. When I built my garage I had the electrician run a wire so I could put a heater in down the road. He ran a orange wire with 4 wires in it black red ...
2
votes
2answers
8k views

How do I wire a 240 Volt 500 Watt baseboard heater?

Do I run 12-2 wire to a wall thermostat and heater off a 20 amp breaker? Does the black and white wire go to a double pole breaker?
1
vote
1answer
579 views

How to check the heater element of an Electrolux ESI 6160 dishwasher?

I have an Electrolux dishwasher, that occasionally does not heat the water. I suspect that the heating element is somewhat badly connected. How can I check that. Especially, does someone have ...
1
vote
1answer
2k views

My plumber installed my hot water baseboard backward. The feed and return are hooked up backward. What problems will this cause?

I believe my hot water baseboard heater was hooked up wrong. The feed and return are opposite. The plumber said it's not a problem as we'll still get heat. Is that so, because we don't get a lot of ...
4
votes
2answers
11k views

How should I install a thermostat for a baseboard heater?

How would I go about installing a thermostat for my bedroom's baseboard heater? I've seen lots of articles on how to replace an old thermostat but I'm installing a thermostat for the first time here. ...
2
votes
2answers
8k views

How do I design the circuit for baseboard heaters?

I am designing the circuit(s) for my basement apartment (cca. 800 sq ft) baseboard heating solution. I am planning to buy Berko HBB Series heaters and distribute them as shown in the below table. ...
3
votes
3answers
422 views

What kind of portable electric heater should I use in my kitchen?

My landlord doesn't see the need to install a heater in the kitchen, but I do as it's like 12°C (54°F) in it this morning. I'll buy an electric one then. But I realize there are many types: fan heater,...
1
vote
2answers
2k views

Why is water flowing into my hot water tank from the output pipe?

When I was replacing the hot water heater and the shut off valve I found this issue. Once I turned on my main water I kept the shut off valve closed to the input so I could ensure there was no leak ...
0
votes
1answer
263 views

Why are there planks above the heaters?

Just moved in a new house. All heaters have a plank (same width and depth as the heater) 10cm above them. Please see the picture below: I conjecture it's for preventing some of the heat to go ...
1
vote
0answers
3k views

Do I need to add a protective layer to insulation for wall heater?

I am going to install a 4000 watt wall heater to an add on. It is the kind of wall heater that is seated in the wall. i also plan to install insulation in between my wall studs. there will be ...
1
vote
1answer
12k views

How can I safely remove one baseboard heater out of a set of two?

I have two baseboard heaters on either side of my living room. They are both on the same breaker and connected to the same thermostat. The breaker looks like it takes up two spots and has a 20 on the ...
3
votes
2answers
3k views

Can I connect a combination heater/fan unit to the existing bathroom wiring?

I have a dedicated 15A circuit for a top-floor bathroom fan with heat lamps which draws much less than capacity. There is nothing else on this circuit. I know that code for a 15A 14ga circuit at 80% ...
1
vote
1answer
1k views

How do I quiet a noisy furnace condensate pump?

I have a mostly-finished basement, with the furnace in a utility room off the main room. I feel the condensate pump is noisy, but this is my first heater with one, so I'm not sure if its normal dB or ...
2
votes
2answers
5k views

How do I use this H/L/V Wiring?

I am replacing an OLD h/l/v with a BROAN 100HFL I DO NOT have a 12/2 and a 12/3 coming from the 3 switches on the wall. I DO have this, two 12/2 coming from the 3 switches AND another 12/2 that ran ...
4
votes
1answer
4k views

What could cause a clicking noise in an electric water heater?

I get clicking sound from our electric water heater as well. it lasts for a while, then stops...then starts again, etc. we recently had technician out who said it needed to be cut back on the setting ...
1
vote
3answers
1k views

Cannot figure out wiring of most basic Honeywell thermostat (heater only)

I live in an apartment with central heat. It's controlled by a round Honeywell thermostat. The heater ticks really loudly and annoyingly when it heats up and cools down (probably a topic for a ...
1
vote
1answer
1k views

Why is my electric wall heater slow to turn on and then quick to shut off?

I have a few electric wall heaters in my bathroom and laundry room made by Intertherm. They may be 30 years old. When you turn the dial to high, it takes 10 minutes or more before it actually turns ...
2
votes
0answers
2k views

Why isn't my Empire heater getting any gas? [closed]

My Empire heater does not seem to be receiving any gas when I turn or press the pilot knob. I believe the gas is supposed to flow when you press the pilot knob to light the heater but nothing comes ...
4
votes
1answer
367 views

Hot air gun / paint stripper for melting plastic

I'm not sure if this is the right kind of question for this site, but I thought that people here are more likely to know the answer. I'm looking for a hot air gun in order to melt plastic - mostly ...
3
votes
1answer
7k views

Where should I install a wall heater?

I have a house with no wall heater, and would like to install one. What criteria should I use to help me determine the best place for the heater? Is it better, for instance, to be on an inside wall? ...
3
votes
2answers
191 views

What to do about furnace that's drawing gas odors into the room instead of heat?

I have a gas furnace. It was heating up the place fine and worked for years until the other day. All of a sudden it started drawing air that smelled like strong gas odors into the room rather than ...
1
vote
1answer
593 views

Installing a switch for a water heater's lower element

I'd like to install a switch for the lower element of my water heater. I haven't even looked inside the water heater yet, but I'm a little confused about what the best way to go about doing this ...

1 2 3 4 5
6