Questions tagged [heat]

The tag has no usage guidance.

20 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
2
votes
0answers
1k views

Trane Weathertron Stat to Honeywell RTH2510

I have a Trane Weathertron thermostat thst I am replacing with a New Honeywell RTH2510. This is a heat pump with auxiliary electric heat. The wires on the Tran thermostat are. R, T, O, G, Y, B, X2 ...
1
vote
1answer
47 views

Hook up new thermostat

Top brown picture is my old thermostat white is the new one , do I have it wired correct? On out side unit we have replaced motor, fuses, compassator ,cc contactor ,relay . We have a heat pump. But ...
1
vote
0answers
59 views

Energy loss through bathtub drain

I noticed that there is significant heat loss at my bathtub drain. If I put my hand above the bathtub drain, I feel an icy draft. The plumbing is directly under the bathroom, in an unfinished ...
1
vote
0answers
31 views

Portable heat pump strange thermostat

I've got an Olimpia Splendid Ellisse HP portable heat pump with strange/incorrect thermostat readings. According to another thermometer the room temperature is currently 16.9C, the heat pump ...
1
vote
2answers
371 views

Furnace Blower fan doesn't start

I have a keeprite high efficiency furnace that Was a part of my new house. It's 2016. The Honeywell thermostat is set at 23 deg C. This is what happens when the temperature is below the cut-off I ...
1
vote
0answers
18 views

Hot water ghosting

Hot water gets really hot. When heat zone calls it is also traveling through hot water zone. I replaced taco flow ck valve. It is branched off of same feed going to heat zone valves but I was tol that ...
1
vote
0answers
695 views

Any ideas for reattaching these baseboard heaters to the wall?

This baseboard heater (Hunter Heatmaster Convection Baseboard Heater - Model 35514) has come away from the wall. Its twin is having a similar problem. It seems neither was installed using a drywall ...
1
vote
1answer
820 views

Honeywell VR8300A3500 Single Stage Heat Gas Valve to Ecobee3 with C wire

Hey everyone have a quick question regarding a honeywell VR8300A3500 Single Stage Heat Gas Valve and the introduction of a Ecobee3 wifi enabled thermostat with a "C" wire. just want to make sure i am ...
1
vote
0answers
89 views

How to insulate roof from heat (sunlight)

I'd like to insulate roof which is over my flat in 4 store building. MY flat is the last one and every summer is a killer for me as about for 1 month a year I have constant temperature of 30 Celsius. ...
1
vote
1answer
1k views

What should we do about asbestos tape on heat ducts?

My daughter just had a home inspection of a home from 1900 and there was asbestos tape noted on the seams of the duct work. What should we do? And I am assuming it is not only on the visible ducts. ...
0
votes
2answers
37 views

New 250 Watt heat lamp installed over shower

Heat Lamp goes out after approx 12-15 minutes, obviously getting hot. could be lamp have a thermal coupling? Seems I should be able to add a 250 watt on any circuit without damage. Why is the light ...
0
votes
0answers
20 views

Zoned 2 stage heat pump system, aux heat not engaging

Homeowner here...I have a 2 stage heat pump split system with the ducting zoned for 2 zones. The units are as follows: Compressor: Goodman GSZC16 heat pump Zone control board: Honeywell HZ322 ...
0
votes
1answer
52 views

alternate or no Insulation over heat tape

Can I operate a well pump with no pressure tank by using the breaker as a switch? I have about 10 feet of well PE black pipe from the ground in the crawl space to the utility closet (inside heated ...
0
votes
0answers
51 views

Why does the GFCI protecting my in-floor heat trip when the bath fan is switched on?

I have an under floor heating pad to heat the bathroom floor . It has a thermostat with a built in GFI in it and trips only when you turn off the bath fan . How can I correct this
0
votes
0answers
57 views

Two Separate Systems on one Thermostat?

I have a baseboard hot water system and a separate gas furnace with heat and AC. Thus far, they have been on two separate thermostats. Is there a way to put them on one thermostat or is there a ...
0
votes
0answers
248 views

Should I use MDF or plywood behind my wooden burner?

I want to mount a cast iron wooden burner like in the image close to the wall (a double wall with the neighbours, not an outer wall), at about 25-35 cm distance. The exhaust pipe runs vertically. I ...
0
votes
2answers
2k views

heat pump condenser fan not running in winter

it is -5 degrees outside. Our thermostat is set at 70 degrees and the house heat is 58 degrees. the fan blade on the unit outside is not moving. the hvac system inside has a sticker on the unit. the ...
0
votes
1answer
64 views

Rapid on/off cycling of furnace

My 50-year old wall furnace keeps cycling on and off as it gets near the set temperature. Can I fix this by changing to a new thermostat? It's a 2-conductor cable (no blower).
0
votes
3answers
221 views

Floor heat cables under linoleum flooring?

everyone. Is it possible to lay heat cables on a bathroom floor before I lay down linoleum. We would like to help create some warmth in the winter. Given our current situation I don't think it's ...
-1
votes
1answer
36 views

Internal Gas Heaters

My property has no LP gas currently. I am converting an out building and need heat in several of the rooms. Can I run a gas line along the horseshoe shaped inside wall that is a common wall to all the ...