Questions tagged [hanging]

The tag has no usage guidance.

Filter by
Sorted by
Tagged with
3
votes
3answers
699 views

Simplest solution for hanging 50lb frame with welded hooks

I have a 50lb mirror I'd like to hang. It has an iron frame with two hangers welded onto the curved top edge on the back. Here's a close-up of one of them: The hangers are about 17" apart on center, ...
1
vote
2answers
372 views

hanging 140 lb on wall with metal studs

I am finishing my basement and have metal studs on the perimeter (just in case of any moisture penetration. Planning on hanging an 85", 140 lb flat panel on the wall. The drywall is not up yet, so ...
1
vote
1answer
36 views

How can I mount a mailbox on a stucco wall?

Been searching around and I have more questions than answers. I'm not sure what kind of stucco it is, but it is very smooth. The mailbox is a little heavier than you might expect (maybe 10-15 lbs). ...
1
vote
3answers
52 views

Attaching small, nearly zero weight cable clips directly to drywall without anchors

My project runs about 30ft of ethernet cable along garage (interior) walls. I have 5mm plastic R-Style clips and I need to put about 1 per foot (at least 30 clips). I'm looking for something that I ...
2
votes
1answer
61 views

How can I hang an IKEA Stockholm mirror on a brick wall?

I found tips for hanging the Stockholm mirror from IKEA using the technique here by Ray Li: https://hackerbits.com/life/how-to-hang-an-ikea-mirror-stockholm/ However, I have a brick wall in the ...
1
vote
1answer
172 views

Decorative hanging hooks into plaster and brick wall

I'm at a bit of a loss, but I feel like I can't surely be the only person with this issue. We have a number of keepsake / decorative items that need to be hung by a hook. An example is a surprisingly ...
0
votes
2answers
100 views

I need to screw into my wall but halfway in, it hits something hard

I tried in different spots on the wall but same thing. Is the whole wall like that? I live in a concrete building but not soundproof. I am able to use screws on other walls.
1
vote
2answers
140 views

How to hang a shelf in an invisible manner?

I recently decided to start building my own furniture whenever I could. To start small, I decided to go with a design’ish shelf that right now looks like that: I’d obviously like to hang it on the ...
0
votes
2answers
546 views

Can I hang things from a thick sound proofed wall?

I have a sound proofed room. It's constructed like this: Specifically, the layers of the wall are: studs 3/4" MDF 1/2" air gap (RC-8 channel) 3/4" drywall 3/4" drywall The exterior of the wall is 2"...
0
votes
0answers
60 views

Options and advice for two-point aerial yoga hammock

I'm looking to hang an aerial yoga hammock in our garage from 2 attachment points. I'm based in Australia which might change some of my measurements/ratings so sorry in advance! I can use a manhole ...
0
votes
1answer
57 views

Difficulty closing front door

Hi I have a new home and the front door is difficult to close. They have run the doorbell wire along the inside of the upper frame (as seen in the pic) and the door rubs against it. I’m worried that ...
1
vote
1answer
40 views

Using Different Screw in Drywall Anchors

I have custom mounting hardware for a floating shelf I'm looking to install. This hardware came with its own special screws, which are meant to be screwed into wooden studs and support the mounting ...
2
votes
6answers
4k views

How should I wall mount a TV with one metal stud and a gap between the drywall and exterior block?

I am mounting a TV on a wall (see photos). There is a 7/8 inch gap between the drywall and the exterior, and a single metal vertical stud (Florida) as indicated. I want to center the TV, which is ...
3
votes
1answer
235 views

Bulge in drywall after mounting tv

I mounted my 60” inch tv over my fireplace and a bulge has appeared on both sides in the last few days. I’ve done some searches and it sounds like this is a “nail or screw pop”. My question is this ...
15
votes
10answers
4k views

Safely hang a mirror that does not have hooks

I would like to safely secure a mirror to the drywall. The mirror itself is pretty light (probably under 5kg), the weight is not an issue. However, its back surface does not have any hooks or anything ...
1
vote
1answer
48 views

Contraption for hanging a mirror

A mirror has four pieces of hardware of the one appearing in the image, one at each corner. Attempting to insert simultaneously four flat-head wood screws in these slots would likely be frustrating. ...
0
votes
3answers
868 views

Hang item from top chord of 2x6 roof trusses?

The roof truss in question is part of a standalone shed structure in the back yard. Each truss is 2x6, and is composed of 3 planks - each side of the triangle, no center braces or anything. The width ...
20
votes
2answers
3k views

Will removing shelving screws from studs damage the studs?

We live in a newly built home. My husband hung some Ikea shoe bins on the wall and mounted them in to the studs. I am going to paint the hallway and would like to remove the bins and hooks, patch the ...
1
vote
3answers
77 views

How to find stud when magnets indicate there's one present, but can't find it with a drill

I've got a wall that I'm trying to mount a relatively heavy painting on (~25lbs), and am trying to use magnets to locate the stud. Here's where they stick: I've tried to drill into where I expect the ...
0
votes
1answer
54 views

Lean Ikea Krabb mirror against the wall (for decoration), need something to prevent them from slipping

https://www.reddit.com/r/DIY/comments/298y83/help_lean_ikea_krabb_mirror_against_the_wall_need/?utm_source=amp&utm_medium=&utm_content=post_title There's similar questions online that were ...
1
vote
1answer
68 views

joist bridge for hanging porch seating

Want to build and hang a "bed/sofa" 64Lx32W on PT deck w/PT 7x2x10' rafters 16"oc. Spacing of rafters wrong for hanging. I can cut down size of the seating, but it defeats objective. QUESTION: can ...
1
vote
2answers
1k views

How to hang a projector screen from a thin horizontal part of slightly curved ceiling

I have a brick wall in front of which I want to hang a projector screen. Here is an image of a typical projector screen that I am looking to buy: The part of my ceiling near the wall is curved(the ...
1
vote
1answer
66 views

Hanging exercise equipment on cinderblock wall

I live in a townhouse and am separated from my neighbors by a cinderblock wall. In my garage it is pretty exposed. I would like to hang a kayak, punching bag and pull up bar off of the wall. Kayak ...
1
vote
1answer
75 views

Can I hammer nails in this type of brick?

I want to hang some pictures on the wall. The wall is made of porotherm bricks similar to this one: I have two options: drill some holes with a masonry drill bit, insert some plastic dowels and a ...
0
votes
2answers
46 views

Joist hangers “droop” when installed?

Whenever I use hangers I end up with something that looks wrong. Hangers have two sets of screws. One, the "flat" screws, drive into the wood your hanging onto. The others, the "diagonals" drive into ...
3
votes
1answer
479 views

How to get proper support for a closet system from a firewall?

I am installing a closet system which is supported from a single track. The wall I am attaching this track to isn't a standard wall but a firewall between my townhouse and the next. The cinderblock ...
0
votes
0answers
42 views

What is this wall fixture with a locking arm? How much weight is it rated for?

So, I have this thing attached to the concrete wall between mine and my neigbhor's balconies: The arm has a slot in it's base that lets it slide around the nearest axis, and another slot that engages ...
15
votes
8answers
94k views

How can I hang a shelf with no visible fasteners?

I just built a shelf for a bedroom based on instructions found at Happy at Home. Problem is: the blog doesn't explain how to hang it! Can someone help me figure out a clean way to hang this shelf ...
1
vote
3answers
223 views

Can screwing too far (about 1.5 inches) into a stud can weaken it?

I put up some IKEA cabinets (using their suspension rail). I used a 5mm (#10) x 50mm (2 inch). Minus the drywall and rail it probably went in about 35-40mm (1.5 inch) into the stud. After all was ...
1
vote
1answer
34 views

How to hang off of wide circular hole in concrete?

I have a concrete wall with many 2-inch diameter, 1.5 inch deep, perfectly cylindrical holes on it. I’d like to hang some relatively lightweight (up to 10 lbs) decorative stuff off of these holes. ...
0
votes
1answer
42 views

Can I use a 1/8 thimble with 1/16 wire rope?

I'm hanging some items from a ceiling. The hardware stores around me all have plenty of 1/8 wire rope and 1/8 fittings, but when it comes to 1/16 size, aside from the wire rope itself, the only 1/16 ...
2
votes
2answers
136 views

How can I securely hang a very heavy object on wall made of hollow bricks?

I would like to hang a blackboard (it could weigh 160 - 190lbs) on an interior wall made of hollow terracotta brick like this. In the case of solid bricks I see there are a number of solutions ...
8
votes
2answers
1k views

Hang 20lb projector screen on Hardieplank

The siding on my house is Hardieplank cement fiber board. I have a 20lb manual pull down projector screen that I would like to hang onto the side of my house to create an outdoor theater. The studs ...
0
votes
1answer
64 views

Ideas to hang five polycarbonate squares to ceiling

I have five plastic (polycarbonate) squares that I need to hang / attach them to the ceiling (concrete). They can touch the ceiling, or have little (maximum 2 inches) gap between the square and the ...
0
votes
1answer
56 views

Hanging Internal Doors - is a frame made from 2 x 2's strong enough

I have recently removed some light hollow wardrobe doors from a frame made of 2 x 2's and have just had delivered some reclaimed pine doors to put in their place. I want to know if the frame made of ...
2
votes
5answers
4k views

Hanging up large whiteboard in rental property

So my roomates and I got a large whiteboard for studying, it measures 1800x900mm and has a stainless steel border and backing. At a guess it's easily 20kg, and we've currently got a rather ad-hoc and ...
3
votes
1answer
53 views

Best Option For Securing Lightbox

I’m having some trouble with a light fixture. I have installed a hanging light and it seems that the electrical box in the ceiling is coming out. It has spring clips but they’re not strong enough to ...
7
votes
1answer
5k views

How should I attach a chin-up bar to floor joists?

I want to mount a chin up bar to engineered I-beam floor joists. Am I safe to mount it directly up into it with lag bolts? If the spacing isn't correct and I span some joists with 2x4s, should I run ...
0
votes
1answer
41 views

Correct fixture for plasterboard that has another board behind it

I'm trying to put up a whiteboard on a plasterboard wall. I am screwing the holes from one end into a stud, but the other end does not line up with a stud. I therefore planned on using wallmates. ...
1
vote
2answers
67 views

How to tie the optimal cordelette in this specific 7 point scenario?

This is a followup to this question: How to fasten one end of a rope to multiple points so as to distribute load equally? Specifically, I'm following this answer's advice about using a cordelette. ...
1
vote
3answers
120 views

How to fasten one end of a rope to multiple points so as to distribute load equally?

I'd like to hang a cocoon-type hammock device from a few railings overhead. It hooks onto a single point and hangs vertically, as opposed to a traditional hammock that you'd see hung horizontally ...
6
votes
5answers
12k views

How do I hang a chair from a concrete ceiling using a single hook?

I'm putting in a "hanging chair" in the basement and it's supposed to hang from a single hook in the ceiling. The ceiling is reinforced concrete. Now, I'm about 125 kilograms (275 lbs) so I reckon ...
7
votes
3answers
2k views

How can I hang a large but light poster on a concrete pillar?

I have a large (est. 5'x7') sheet of plastic foam with a poster printed on it. It weighs maybe 3 lb and is reasonably stiff. I'd like to hang it on a solid rectangular concrete pillar about 2' wide. ...
4
votes
4answers
414 views

Can I use hollow wall anchors in a lath and plaster wall?

I have a stable enough lath and plaster wall, which I would like to put a box framed picture on. Usually with a box frame picture on to a plaster board or dry wall, or even a brick or stone wall, I'd ...
1
vote
5answers
61k views

Hanging picture on a very hard concrete wall [duplicate]

Situation: Appartment in a panel building. Very hard concrete walls -- all, thick or thin. No plastic hooks (like these on alibaba that usually work for people around do not work for me, the little ...
0
votes
1answer
22 views

How to hang hard to hang picture [closed]

I have a picture frame where the wood is narrow, maybe 1/4 inch. The backing board has sawtooths near the top. If I hang by sawtooth it seems I’ll be hanging on nails, not hooks (most hooks I see ...
7
votes
7answers
61k views

What's the best way to hang an unframed poster on a sloping wall without using something that will damage the poster?

What's the best way to hang unframed posters on a sloping wall without using tape or velcro or glue that would damage the poster? Thumb-tacks don't work too well because the poster ends up sagging ...
0
votes
2answers
71 views

Drill through a pass through header/top-plate to hang pot hanger

I want to install a pot hanger in this pass through between my kitchen and dining room. The product came with some wood screw hooks, and I want to swap them for some threaded hooks and throw a nut on ...
1
vote
2answers
424 views

Drilling into stone wall with plaster on top

I'm trying to hang a curtain rod. The wall is irregular stone, with plaster covering it. I have masonry bits, a drill, and an impact driver (no hammer drill, though I may be able to borrow one). When ...
0
votes
6answers
21k views

Will gently hammering thumbtacks into my wall help them stay better?

So I'm thinking about fake-upholstering a wall in my bedroom in my apartment to create a focal wall without having to paint. I don't want to drill holes 'cause I'll be moving out of there in like 9 ...