Questions tagged [grounding]

Grounding, also earthing, refers to the practice of providing a direct conductive path to the physical ground for an electric short to a chassis. Tag questions involving the installation or retrofitting of grounding with this.

Filter by
Sorted by
Tagged with
4
votes
4answers
2k views

Can armored bx cable come into contact with other metal objects?

I am running armored 12/2 bx to wire 4 high hats, the armored cable is grounded. There is a heating duct which I must go over, but the AC will come in contact with it... Is this ok or do I need to ...
3
votes
2answers
660 views

How to track down a short circuit in attic with pressed metal ceiling?

When switching on a light the circuit breaker tripped. On the distribution board, I switched off the sub-circuit for the light. The rest of the house and the plugs in the room with the light still ...
1
vote
2answers
988 views

Can having a bad grounding situation destroy a circuit breaker?

We moved into a home, built a while ago. there are wires hanging and covered in black tape on a chimney. I bought 2 sconces and put them in place. i did not hook up the ground wire on one of them, ...
1
vote
1answer
2k views

How do I make ground connections at my receptacle boxes?

I searched for my question but could not find the answers. I had the inspector out for my rough in on electrical inspection. He said I did a very nice job but I need to make all my grounds at all my ...
0
votes
2answers
489 views

Replacing receptacle, ground and neutral are connected

My house was built in 1974. I have doubts the wiring has changed since then (aluminum everywhere) and have already noticed some bad things (downstairs potlights on same breaker as upstairs living room!...
1
vote
1answer
186 views

Can a grounding rod be connected to service neutral only?

My grounding rod is connected to the service neutral at the weatherhead where it enters the house. Should it not be connected to the ground bar in the 200A breaker panel?
0
votes
1answer
128 views

Will I get electrocuted if I contact a live wire on an earthed appliance?

I have an appliance that has the wires connected well and it has been grounded (earthed). If I accidentally get into contact with a live wire will I get electrocuted considering it has already been ...
3
votes
1answer
4k views

Must I ground my dishwasher to a metal plate?

I bought a Bosch 800 Series Dishwasher Model SHP68T55UC to install into my year 2000 house. Whenever I read tutorials online for installing dishwashers, I see that the ground wire goes to a metal ...
3
votes
2answers
81k views

How to fix an “open ground” on a receptacle that seems grounded?

In the master bedroom on one wall there are two receptacle that when tested shows “open ground”, I have replaced the receptacle on both (with new tamperproof receptacles) and while doing that checked ...
1
vote
2answers
95 views

Grounding subpanel to box - 'tap threads'

I've installed a subpanel and need to ground the grounding bar to the actual panel box. I was instructed to run a #6 jumper to a hole on the box, attach with a screw, making sure to 'tap threads'. ...
1
vote
2answers
2k views

Can I use conduit to ground an antenna?

I have an HD antenna mounted to a storage shed, not even as high as the house roof. It's close to where the electrical service enters the house. There's no ground rod in sight. (House built in 1971.) ...
2
votes
2answers
4k views

What options are there to achieve both grounding/ground-fault and arc-fault protection on old 2-wire circuits?

The three receptacle circuits in my house are 2-wire NM, but have 3-prong receptacles. My electrician recommended and installed GFCI breakers to provide "grounding" to these circuits. I now realize ...
9
votes
2answers
832 views

Outlets not grounded? Remedy?

For some months, I'm renting an apartment in the Canary Islands. It looks like the plugs are not grounded. For example, when I connect my laptop, a ThinkPad T420si, then I feel an unpleasant sensation ...
0
votes
1answer
538 views

Adding electrical service to detached garage

Please let me know if this sounds correct- Sub panel fed from 80amp breaker in main building 200amp load center. Roughly 75' of 1" PVC conduit from existing load panel, under existing timber deck, ...
6
votes
3answers
4k views

Cloth-covered NM questions

My 50s era ranch home is wired using cloth-covered NM, as you can see in these photos (taken in a basement closet located under the stairwell where the NM is run exposed): Should I be suspicious of ...
0
votes
3answers
8k views

Grounding a receptacle when there is no ground wire?

I am replacing old receptacles with new tamper-proof ones. I opened one in my basement and realized it wasn't currently grounded, the electrical housing is a real mess and has a copper "ground" wire ...
1
vote
0answers
220 views

Has this light earthed itself?

After accidentally earthing the live wire going to the outside light whilst putting a faceplate back on (patched up now), the light has stopped working. I've just been out with a multimeter to see if ...
3
votes
3answers
8k views

Can I splice grounding wires together to reach an old outlet that needs a ground?

I have a two prong outlet in my house and there is a ground wire behind it, not connected. The ground wire ends in a junction box halfway to the breaker box. Only the neutral and hot wire continue ...
0
votes
1answer
136 views

have power at outlets and lights, with only hot connected from panel..,, whats going on?

I was replacing only the supply wiring running from Electrical box to a existing circuit in my kitchen, which starts at an wall outlet and branches to lights and other outlets. I first connected the ...
2
votes
2answers
2k views

How should I connect a grounding wire from a device to this box?

I'm replacing this simple 2-connector light switch with a 4-wire dimmer. The 2 new wires present on the dimmer are neutral and ground, and only neutral has an obvious home. The box has no visible ...
3
votes
2answers
13k views

Is there a reason not to connect the ground wire to a chandelier?

So, I am replacing the insides of a chandelier, but now I dont understand why the person who installed it would leave the ground wire hanging without being connected. I can see a ground wire taped ...
1
vote
1answer
8k views

How should I ground a GFCI to a metal box?

I've replaced some old GFCI receptacles in my kitchen, which live in metal electrical boxes. The old GFCIs did not have grounding conductors attached, but it seems that the boxes themselves are ...
1
vote
1answer
722 views

How can I connect the wire that goes to the grounding rod to the grounding electrode system? [duplicate]

I'm trying to install an outdoor antenna at my parent's house and was wondering how to connect the wire that goes to the grounding rod to the grounding electrode system through the service panel when ...
5
votes
2answers
1k views

What are the grounding requirements for a panel fed from another panel?

I have a 60 amp subpanel in my garage and plan to add a second 30 amp subpanel to an out-building 130 ft away (fed from the 60 amp). I Plan to run 6 AWG 4-wire from the 60 amp to the 30 amp in 1 1/2 ...
1
vote
1answer
261 views

Is this a ground wire in my ceiling light canopy?

I just installed a ceiling light fixture, which has a feature I've never seen before. The fixture has the traditional white, black, and green wires. I attached the white and black fixture wires to the ...
0
votes
0answers
131 views

Should I be worried that my ceiling light has current when turned “off”?

I am based in the UK. I was replacing a ceiling light when I noticed an issue. When I used a voltage screwdriver the live wire in the ceiling pendant was showing a voltage present even when the wall ...
0
votes
2answers
3k views

Is it okay to drill a ground rod through pavement?

All the sides of my house are paved, and I need to drive a new ground rod for an antenna. Would it be against code (NEC) to drill a hole in the concrete to pound in a ground rod? Bonus question: How ...
3
votes
1answer
2k views

How do I ground a TV antenna on my shed with the cable running underground to my house?

I want to mount a TV antenna on my shed in my back yard and run the wire underground to my house. The shed is about 60 to 70 feet from the house. There is electrical service in the shed, but there is ...
0
votes
0answers
22 views

TV Arcs with Cablebox through both Coax and HDMI [duplicate]

Here is our setup Outlet in older house that was replaced with a GFI last year. (no issues until recent) The GFI doesn't have a ground wire running up from the basement. Just the white and black ...
0
votes
2answers
13k views

Installing a fixture with no ground, no ceiling box

I recently bought some nice track lighting to brighten a room who's only light source was buried in a corner. I removed the old fixture and found (to my horror) this: Two wires, no ground, no box (...
2
votes
1answer
466 views

How do I properly ground a light fixture?

I installed a light fixture in my bathroom and need help grounding it properly. The previous fixture wasn't grounded. When I removed the fixture, there were two wires, one black and one white, from ...
3
votes
1answer
890 views

Do I need to ground Ethernet cable run beneath a pier & beam house?

I'm fairly amateur when it comes to home networking, though I get the basic concepts. I bought a 1000' spool of this Cat6 Ethernet cable, simply because it was the only outdoor-rated cable sold by ...
0
votes
1answer
109 views

New Fan Switch Grounding Cable issues

I installed a new switch for a new ceiling fan. For power, I pigtailed the 3 wire cable to my new switch from an existing light switch. My problem is with the newly installed ground cable. The 2 ...
4
votes
4answers
8k views

How can I upgrade a 3 wire appliance receptacle to a 4 wire receptacle?

I have a cabin, wired for 220 and even has a sub-breaker near the outlet. There are 3 wires to the connector (two hots and the neutral). The range-top that I want to hook up is a 4-wire model (2 ...
1
vote
2answers
484 views

Where do I attach the earth conductor on a plastic fixture?

I'm replacing some outdoor lights. The old ones were metal, and the earth wire was connected to a screw on the base. The new fixtures are plastic, and there's no earthing screw. Where should I connect ...
1
vote
1answer
337 views

A ground rod where a drain needs to go

My house sits on a hill, and the gutters don't properly drain. As a result, I'm digging a new drain along the side of the house to re-route the water. However, while digging the drain, I came upon a ...
7
votes
1answer
19k views

Can I extend an electrical ground wire with a copper wire crimp?

I am working with an electrical socket and I need extra length on the ground wire. It doesn't seem unreasonable that I can attach an extra three inches to the existing one and attach it with a copper ...
2
votes
2answers
5k views

Japanese Appliance has a Green/Yellow Ground Wire coming out of it, What should I do?

So I recently purchased a Japanese Toiletseat thing (I can't read japanese but I've just been translating little by little), and it has a ground wire (a green/yellow wire) Coming out of the back, ...
0
votes
1answer
693 views

Does HVAC lineset need to be grounded?

My HVAC contractor says the installation of the line set between the air handler and the condenser outside is complete but he has not grounded the lines. Do HVAC copper pipes need to be grounded?
0
votes
0answers
54 views

Ligth Switch with 4 wires

I removed an old light-switch and the following appeared: I went to Brico, showed them the old switch, and got the one below. I am wondering a bit how to connect it. I am a bit worried that I only ...
5
votes
4answers
50k views

Can I safely ground a light fixture if the ceiling box has two hot and one neutral wire (no ground wire)

Checking for dupes, I saw this question, but the situation appears different as my box is metal, among other things. I'm fairly new to electrical projects, so bear with me. I recently installed a new ...
4
votes
2answers
7k views

Why does my computer have a ground fault only when a peripheral is attached?

I have a weird problem regarding grounding: I have a computer, printer and a LCD screen connected to the electric outlet through a power strip. My computer is zapping me when I touch the body so I ...
2
votes
1answer
1k views

What do I do with the ground wire?

I just bought a wall timer to replace a three-way switch. The wall timer comes with three wires, one for the common screw wire, and the other two are for the travelers, with no place for a ground wire....
6
votes
4answers
20k views

What could cause the ground wire on my baseboard heater to burn?

On the photo below, you can see that the ground wire as burned. Description of what i know: the wire is connected on a 240V line to my baseboard heater the wire seems to be a AWG 14/2 I don't know ...
1
vote
1answer
609 views

Integrating into knob-and-tube wiring: okay to borrow a ground [duplicate]

I have a mixture of knob-and-tube and NM-B. If I'm extending from knob and tube, but I have a (different) an NM-B circuit nearby, is it technically allowable to ground via ground wire in the other ...
3
votes
1answer
2k views

Where do I attach the fixture grounding wire when no supply grounding wire is provided?

I am replacing an undercounter light and I have a black, white and red supply wire but no green or bare copper supply wire. Where do I attach the green ground wire attached to the fixture?
2
votes
1answer
2k views

How can I make a fake ground output?

I'm having problems with my electrical oven: I get shocked when I touch it. I think the way to solve this is to connect the ground wire it has (the green wire) to ground? The problem with that is ...
5
votes
2answers
10k views

Can I terminate a ground wire to the neutral bus if the ground bus is full?

I have a Crouse-Hinds main load center. The ground bus is at the top left of panel and the neutral bus is at the bottom right of the panel. I want to add a 15 amp circuit for two outlets in my ...
1
vote
1answer
1k views

Ground wire behaves weird

I never experienced this and it doesn't really make sense. I installed recessed lights(6) with the switch. I connected them all in parallel. The house uses only two wires for lights, white and black. ...
4
votes
1answer
768 views

Why do I hear intermittent speaker hum that goes away when I turn lights off or on?

I'm hearing speaker hum in a stereo system that I recently hooked up. I can't pinpoint when the hum begins, but I've identified that turning certain lights off or on in the same room eliminates the ...

1
8 9 10
11
12