Questions tagged [gap]

The tag has no usage guidance.

14 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
2
votes
0answers
140 views

Help! Large gaping on newly installed solid bamboo floors

Im in a dilemma with flooring. We had our old laminate flooring removed and replaced with solid strand woven click lock bamboo. We used what we though was a reputable company, they had insurance, ...
2
votes
1answer
46 views

Repairing above-ground gaps and holes in foundation

I am moving into a house (built 1911) that had a few things turn up on the inspection. One corner of the basement has an indoor cistern, and there are some gaps and a hole in the cinder blocks just ...
2
votes
0answers
128 views

How can I fill a narrow gap in the countertop along the back of my new glass cooktop?

I had to replace my glass cooktop. I checked the specs on a replacement, and ordered the one I thought would fit. When I dropped it in the new stove top, I had a 7/8" gap. The specs online were ...
1
vote
0answers
51 views

How do I adjust this “hidden” door hinge?

How do I adjust this type of hidden door hinge so that the hinge part on the door itself gets closer to the hinge part on the door frame? I figure it's done using the two top and bottom hex screws on ...
1
vote
1answer
474 views

What to do about gap between tile and tub

This is my first shower tiling project and the tub was not level at all. To make sure my tiles were level I left a gap between the first row and the tub on one side (see picture). The gap is 1/2” at ...
1
vote
0answers
504 views

Filling gaps between staircase and plaster wall

I purchased a home that was a two family converted to single. Brick veneer on the outside and block inside. I have been assured by two structural engineers that I have no foundational issues. I have a ...
1
vote
0answers
563 views

What's the proper way to attach an exterior door threshold?

I'm adding a hardwood threshold to bridge the gap between interior hardwood flooring and an exterior threshold leading out to our flat roof deck. My question(s): I've got the piece fitted and plan on ...
1
vote
0answers
65 views

Could anyone suggest the best way to fill large gaps in the drywall under the sink?

All through our building the area under our sinks looks like this: left side is a 1 inch gap, right side is 2 inches! I could put in steel wool or spray, but how would I caulk over it? Any other ...
1
vote
0answers
35 views

drywall gap again after foundation repair

My foundation (crawl space) was repaired recently, huge job, home not level. There had been a gap in a corner where the sheetrock had dropped down but that side (plus adjoining 90 degree) was reframed ...
1
vote
0answers
1k views

What to use to seal large gaps in corners where brick ends?

I have a few weird areas in my (new to me) house where brick and mortar are basically meeting corners or endings, and leaving huge gaps. The first one is a gap between the back of the brick and the ...
0
votes
0answers
15 views

GAP filling between laminate flooring and wall

I have large gap, between my flooring and the wall, almost 3 cm. Could you please advise on how to fill it and cover it. Looking forward hearing from you. Kind Regards
0
votes
0answers
21 views

Should I use silicone or caulk between skirting board and vinyl tiles, cement and vinyl tiles?

Should I use silicone between vinyl tiles and wooden skirting? I imagine yes since the skirting board may contract even though the tiles do not? What about if there is no skirting i.e. vinyl and ...
0
votes
0answers
47 views

attic firewall gap

Twin home, built 1987. In the unfinished attic the last joist does not fully touch the firewall and there is a sizeable gap, 1-2 inches. There is some splatter from mortar along it. I suppose this ...
0
votes
0answers
855 views

gap between skirting boards and laminate flooring

I put down some laminate flooring with an underlay. Where the skirting board and flooring meet there is no gap. (for the most part!) However, where the bed frame legs are up against the wall, the ...