Questions tagged [furnace]

The furnace is part of an HVAC or central heating system used to generate heat. Typically this is done with gas, a heat pump, or an electric element. For hot water and radiator based heating, use the boiler tag.

Filter by
Sorted by
Tagged with
2
votes
1answer
2k views

Dip Switch settings for furnace circuit board

I have a 2-stage variable speed furnace installed with single stage thermostat. I would like to control W2 staging time delay using dip (DIP) switch settings on circuit board, but there is a sentence ...
2
votes
1answer
314 views

Can condensing furnace experience too much condensate and cause repeated short cycles?

I have a Carrier 59SC2B. I think it is single stage. I have had the unit for 3 winters now and this is the first winter that I am experiencing alot of problems. What is happening is: (the LED light ...
2
votes
1answer
118 views

Do high-efficiency furnaces work well in older homes with restrictive ducting?

I was told that a high efficiency furnace needs a certain amount of airflow to work properly. And that in an older home if you don't have enough duct work that a high efficiency furnace is actually a ...
2
votes
3answers
352 views

What pipe is this?

Hello and please bear with me. I'm no expert when it comes to plumbing but I will try to be as detailed as possible. I'm trying to understand what a pipe does in my basement. The pipe seems to be ...
2
votes
2answers
2k views

No water pressure in heating circuit

I have a natural gas hot water furnace and I can't get heat. First I turn up the temperature at the thermostat and I hear the furnace turn on, the supply line gets hot and half way down the line it ...
2
votes
1answer
56 views

What is required for seasonal maintenace of a heat pump?

Over the years I've had several local HVAC companies provide seasonal maintenance of the heat pumps and propane furnace in my house. It seems that every technician--even within the same company--does ...
2
votes
1answer
239 views

How can I improve the directional flow of my furnace exhaust pipe?

This one's for the creative folks. I'm in a condo on the top floor and I have a side neighbor. Both our furnaces exhaust out the back, under a four-foot roof section overhang (sticks out about a foot ...
2
votes
2answers
11k views

my furnace fan stays on even when at temperature

I recently installed a 2nd generation NEST thermostat. I'm not home very often, but I was paying particularly close attention to the furnace after installing this thermostat and I noticed that the ...
2
votes
1answer
841 views

What could cause the furnace blower to come on constantly and no fire in gas burner?

When thermostat is turned up on my hot air furnace, the blower immediately comes on, blowing no heat, had it checked and with some luck the burner fired after about 10 tries of switching on and off. ...
2
votes
1answer
3k views

Could a high limit switch cause the furnace blower to run continuously?

My furnace was running fine. The I noticed that the unit was blowing cold air. Checked the furnace burners and they were off. I turned off the unit on the thermostat and the blower continued to run. ...
2
votes
2answers
2k views

Is the furnace undersized?

I have a 2700 sq ft rambler home with cathedral ceilings over a large portion of it - over the hallway, 2 living rooms and kitchen. We replaced the furnace that was installed when the home was built ...
2
votes
1answer
5k views

Why is the circuit breaker for my furnace stuck in the off position?

The breaker for my furnace is stuck in the off position. We were away for the winter and had someone shut it off, and now the breaker won't turn on at all. We shut off the thermostat upstairs thinking ...
2
votes
1answer
574 views

Can a non-expandable filter be used in place of an EZ flex furnace filter?

My Carrier furnace has the EZ flex filters (16x25x5). These come with the plastic end caps that fit on the expandable filters. Can a regular filter, non expandable, of the same dimensions be used as ...
2
votes
2answers
2k views

Furnace Draft Inducer Repair: is previously installed back plate necessary?

I'm replacing a non-functioning draft inducer on the Goodman furnace in my house (GMP075-3). The previous inducer was mounted with a sheet metal back plate between it and the wall of the furnace. ...
2
votes
2answers
4k views

How do I troubleshoot an electric furnace?

I have a Coleman 3300-9051 electric furnace w/AC. The blower continually runs. Where do I find a repair manual and/or what could be the problem. How do I test it.
2
votes
1answer
1k views

Why does my gravity vented wall Furnace keep turning off/

We have an Empire gravity vented wall furnace: That turns off. According to the instructions, this is because the vent safety switch. But when I open up the furnace, it appears to be vented just ...
2
votes
0answers
65 views

Humidifier not keeping up with HRV

I just moved to an new (for us) house and we seem to not be able to keep the humidity up in the house. The house comes with a Heat Recovery Ventilator (HRV) that in the winter runs all the time on low ...
2
votes
0answers
24 views

Goodman motherboard with broken/cut wire

I have 2 Goodman furnaces with the same issue. In the middle of the motherboards there is a plug with a red wire and blue wire, and a white wire loop - pictured. My white looped wire is broken or cut. ...
2
votes
1answer
76 views

2 wire thermostat wire want to be able to select fan only

I have an older furnace with only 2 wires at the thermostat "white and red". No issues at all with my system works as should. Thermostat is new Honeywell basic model not smart. I want to ...
2
votes
0answers
855 views

Thermostat not getting power (Nest E74)

I replaced an old Honeywell thermostat about a month ago with a Nest thermostat. Friday Nest started displaying an E74 error. I have two furnaces and two outdoor units, one for upstairs and for ...
2
votes
0answers
43 views

Rheem RGDG unit turns on w/thermostat off, blower come on and inducer motor switches off and on

I've having a problem with my rheem model rgdg-10nbrjr The air conditioning works, turning it on at night it blows cold air and the house indeed gets cold. However the furnace unit itself ...
2
votes
1answer
411 views

Position of dryer vent relative to gas meter and furnace intake

As part of renovations to our house (built in the early 70s) we are reconfiguring the laundry room and moving appliances to the opposite wall. The laundry appliances will now be to the left of the ...
2
votes
1answer
625 views

Unable to locate filter on Gas Furnace

Can not find where the filter for this furnace is. It is a gas Rheem Criterion II. Have watched YouTube videos but none look like mine. Thermostat keeps saying filter needs replacement.
2
votes
0answers
76 views

How do I stop the ticking noise coming from my furnace duct? [duplicate]

I've had some HVAC people here to look at the ticking noise coming from our furnace duct. One of them installed a brace on the piece in question. This seemed to make the ticking less frequent, ...
2
votes
0answers
33 views

Garage Furnace Runs Only 45 seconds at a time

I have an older Janitrol Moffat furnace in my garage. It was converted sometime in the past from propane to natural gas. It takes quite awhile for it to heat up enough for the fan to kick in and once ...
2
votes
0answers
82 views

Replacing a motherboard on a Carrier 8000VS Furnace

Hi guys, I am trying to finalize the wiring of my new carrier motherboard. I have about four more wires to connect and the new motherboard is slightly different than the old one. The pictures I’ve ...
2
votes
1answer
14k views

Pilot won't stay lit after replacing thermocouple

The pilot won't stay lit on my furnace, when I release the button it just goes out. This started occurring after I did some gas plumbing and had to relight the pilot. I suspected the thermocouple ...
2
votes
0answers
629 views

Installing Ecobee3 with Trane Furance

I am installing an Ecobee3 and have found that, while the common wire exists, it is not connect to the furnace. The wiring schematic for my specific furnace can be found in this PDF There is no ...
2
votes
1answer
1k views

No power in r line after changed thermostat

I have a carrier furnace 2008, just changed my old thermostat to new nest thermostat, forgot to turn off the power. Now I have no power on my r line, checked short fuse still good, red light in front ...
2
votes
1answer
9k views

Goodman gas furnace limit switch opening, blower only runs with a/c

I apologize in advance for some of my incorrect terminology. My father has a 2004 Goodman GMH80904BN gas furnace with a/c. The a/c has functioned properly all summer here in Ohio, we have recently had ...
2
votes
0answers
37 views

Which brand of furnace is more reliable and lasts longer? [closed]

I'm in the market for a gas furnace and was wondering which brand is more reliable and lasts longer. Sort of like which car brands are known to last longer and/or be more reliable. Most of the brands ...
2
votes
0answers
745 views

Constant cold air from vents with new downdraft furnace

Replaced with newer, high efficiency furnace and cold air constantly coming out of vents (except when furnace running). It's like the downdraft is totally free flowing and when windy outside very ...
2
votes
0answers
2k views

How can I reduce noise from an air handler unit in an open closet?

How can I reduce the noise from an air handler unit? I have a Goodman AR42-1 air handler unit in an open closet. The setup looks like this: When the air handler activates it sounds like this: ...
2
votes
0answers
2k views

Why does my gas furnace run once then wont come back on until reset when temps are below 30 outside? [closed]

My gas furnace will run one cycle and then not come back on until the switch is reset. Once the switch is reset it will kick on immediately run once and again I will have to reset before it will kick ...
2
votes
2answers
2k views

Goodman gas burner not lighting

Goodman warm air gas furnace. Gas burner would not light.Status code light blinked continuously. Igniter glows red hot. I cleaned flame sensor with fine grade sand paper. Checked transformer line ...
2
votes
1answer
177 views

Why would my Maytag FG6RC high efficiency furnace restart in the middle of a heating cycle?

My furnace is probably 7-8 years old, and this heating season the furnace has developed a strange problem. The furnace starts normally, but before the temperature reaches the thermostat setting the ...
2
votes
1answer
6k views

how to change furnace filter (bottom return) for Lennox G43UF

I have a Lennox G43UF furnace and I am not sure if I need to have both a filter for a side return and bottom return. If I do (which sounds logical), where would the location of the bottom return ...
2
votes
1answer
400 views

Is my Heat pump and gas furnace installation incorrect?

I moved into a house about 2.5 years ago, and the previous owners had a heat pump installed, together with a gas furnace. Recently I had my furnace repaired (faulty igniter) and the HVAC technician ...
2
votes
0answers
1k views

Are w1 and w2 both energized during a second stage heat call from the thermostat?

Short version: does two-stage thermostat always close W1 circuit when it closes W2 circuit, or they might be closed independently? Long version: I have two-stage furnace, currently connected to older ...
2
votes
0answers
334 views

Why won't my condenser turn on when I run my heat pump?

I have a York Affinity condenser. When I run my heat pump, I expect it to turn on somewhere in the cycle but it doesn't. It generally does this once a year. The usual fix is to cycle the power of the ...
2
votes
2answers
1k views

Can I replace my furnace's high limit switch with a comparable third-party part?

I have an older Lennox furnace. The high limit switch (#60T15,130F) has gone bad. I haven't been able to find on-line this part number with the exact temp limit specs, and Lennox no longer carries ...
1
vote
2answers
23k views

How do I build a firewall around my furnace/water heater?

I'm in the planning stage of finishing my basement. I'd like to section off the furnace and water heater, and am assuming that I should fireproof that section of the build. What's the best way to go ...
1
vote
5answers
5k views

Is there a filter-reminder thermostat that uses run-time instead of total time?

My HVAC filter is in my crawlspace and is a hassle to change. I don't want to change it more than needed. "Change it every month" is bogus advice because in some months (like May) we don't have to run ...
1
vote
1answer
3k views

Can you vent electric dryer into furnace return?

I've got an electric dryer currently vented outside: Behind the door to the right is our heat pump furnace: I was thinking about, during the winter, venting the dryer (properly filtered for lint) ...
1
vote
3answers
1k views

How can I find an appropriate replacement air filter for my furnace?

Background: I got a Bryant 915SA furnace with my new house and it's time to replace the air filter. Problems: The filter is not branded so I don't know what company made it. The filter is not a ...
1
vote
2answers
877 views

What could be wrong with my furnace?

The furnace started blowing cold air so I checked the furnace and the burners weren't lit only the pilot was on. This happened last year and repairman said that if it got too hot would trip a sensor ...
1
vote
3answers
3k views

Old Carrier Furnace, 3-Wire Pilot Assembly, Electrode Sparks Continually While it Runs

Our 29 year-old Carrier furnace relies on a 3-wire pilot with an intermittent spark igniter. It sparks probably around 30 times before the gas valve opens and the furnace fires up. That's a lot of ...
1
vote
3answers
2k views

Sealing gas duct vents with silicone

Is it okay to use silicone to seal gas furnace heater supply ducts? If so, do you know how long the silicone will need to cure before the system is useable? Some background: I've been trawling around ...
1
vote
2answers
893 views

Is the ventilation in my utility closet a construction mistake?

With colder weather here in Northern Colorado (down to 22° F) my Goodman 90% efficiency furnace (GKS90453BX) came on for the first time in the (ca. 2005) home that I recently moved into. The furnace ...
1
vote
2answers
127 views

Do natural gas furnaces have internal breakers?

I rent a house with a natural gas furnace. The furnace was not working at the beginning of this winter, and so we called the landlord to fix it. The landlord hired a repair man, who came and noticed ...

1
3 4
5
6 7
18