Questions tagged [flooring]

For questions regarding various types of floor coverings in general, including hardwood and laminate board, tile, carpet, and sheet flooring (linoleum/vinyl). For questions about the structure beneath this top layer, please see the "floor" tag.

18
votes
13answers
294k views

What direction should laminate flooring be placed in?

I'm thinking of installing laminate flooring and have a question: If I'm installing laminate throughout the house, should ALL of it be going in the same direction? Say for example, let's say I have ...
15
votes
3answers
2k views

How can I remove a plank from the middle of the field?

My attic has tongue and groove planking down as the floor, and I need to do some work up there. I'd like to only remove a couple planks in the middle of the field, rather than pulling up half the ...
14
votes
2answers
3k views

Low-cost hardwood flooring… what's the catch?

Genuine hardwood flooring is generally quite expensive... but a few local stores have glue-down hardwood planks that are actually cheaper than mid-priced laminate (~$1.80/sf). What's the catch? The ...
14
votes
1answer
48k views

Which is better for deck flooring: 2x6 or 1x6 deck boards?

My current deck flooring is done with 2x6x10' boards, however they have degraded to the point now where they need to be replaced. I'm wondering if there are any specific pros or cons for using the ...
12
votes
3answers
15k views

How do I lay “click system” laminate flooring across an opening?

I want to lay laminate flooring throughout my apartment as one big continuous floor. Normally you start laying a row against a wall and then create a new row and click it into the previous row. This ...
12
votes
1answer
3k views

Where should the floor transition from tile to carpet go?

I have 2 rooms planned, one will be tiled and the other will be carpeted with a door opening between them. Where should the tile stop and the carpet begin? In the figure below I have 3 different ...
11
votes
4answers
27k views

Why did my installer install 1/4 round corners like this and how can I fix it?

We had a guy come by to finish some previous tile work we had done. The morning of finishing the tile, he called and said he couldn't get the grout to stick along the edges, and it was just going ...
11
votes
4answers
27k views

How do I install cabinets on a floating hardwood floor?

We just purchased a bunch of cabinets for installation of a bar / kitchenette in the basement. There are 4 wall cabinets and four base cabinets. These are going to be installed on the existing ...
11
votes
3answers
7k views

Should I install hardwood flooring under my kitchen cabinets?

I'm doing a total kitchen renovation with solid hardwood flooring. Do I go hardwood all the way under the cabinets to the wall or stop just past the toe kick and finish the rest with ply of the same ...
11
votes
2answers
2k views

What are our options for carpeting the basement of a split-level house?

The basement level of our house (1/2 below grade) is currently just vinyl tile on concrete slab. It's cold during the winter, so we would like to carpet it. We do not get water penetration through ...
10
votes
5answers
10k views

Tongue and groove floorboards - which way up?

I bought some tongue and groove floorboards. I noticed the tongues and grooves were not centered in the edge but were offset. ┌───────────────────────────────────────────┐ ┌─┘ ...
10
votes
3answers
2k views

Should I install hardwood flooring or cabinets first?

I am installing 3/4 hardwood oak nailed down to plywood sub-flooring. If hardwood flooring is installed first, wouldn't buckling of the floor be a issue since hardwood expands and contracts?
10
votes
5answers
26k views

Can I start and stop a tile floor job?

I am tiling my bathroom floor and don't soon have a full day to dedicate to the job. Is it ok to lay down a few tiles each day and come back to the job when I have time? I would only lay mortar for ...
10
votes
2answers
8k views

How can I remove a portion of a hardwood floor board?

I am adding a small pantry with door to the kitchen area and want to continue the hardwood floors from the kitchen area into the pantry. After removing the baseboard moldings I see that the last ...
10
votes
2answers
120k views

Is there a way to 'remove' blackened water-stain from hardwood floor?

We have several large (3' x 6') blackened areas on our hardwood floor where water damage occurred. This discoloration goes deep. Our goal is to sand the floors and apply a clear coat, but we first ...
9
votes
7answers
87k views

Should I remove old linoleum when replacing a linoleum floor?

I'm planning to replace the linoleum floor in my kitchen in the next few months. According to a friend, I do not need to remove the existing linoleum and can just lay down new flooring on top. However,...
9
votes
3answers
26k views

Is a radiant floor enough to heat the room?

I would like to know if an electric or hydronic radiant floor is enough to heat the room or if it's just to have a warm floor. And if yes, what is the efficiency (the time it take to warm the room, ...
9
votes
2answers
706 views

Floor tile layout process?

I am working on tiling a small bathroom with vinyl floor tiles. As I was measuring to ensure there are no unusual pieces in the corners and thresholds, I decided to check for an application to help ...
9
votes
4answers
143k views

Should I remove baseboards prior to installing laminate or wood floors?

I recently bought around 650sft of laminate floors, to replace around 570sft of carpeted floors in our MN home. These will go in on the main floor, right above an unfinished basement. I'm planning on ...
9
votes
1answer
16k views

How can I remove large nails from cement?

I am redoing the flooring in my basement and removed a built-in toy chest. I disassembled the chest and the floor 2x4's are attached to the cement with large nails. If I had to guess on gauge I'd say ...
9
votes
4answers
39k views

Do I need to glue down linoleum flooring?

I am installing a new linoleum floor in a small bathroom (approx. 6' X 6'). This is a replacement for an old linoleum floor. The replacement will be a single piece. Talking with the local big box ...
9
votes
2answers
5k views

How do I obtain a smooth, white floor?

I'd like to obtain a smooth, seamless, a bit shiny, white floor in an apartment. Something similar to this: How can I achieve this? I was thinking about epoxy flooring. Is that the correct route to ...
8
votes
4answers
57k views

How do I lift a fitted carpet without damaging it?

We recently bought a house and had a bit of work done on it. We then had carpets fitted in a lot of the rooms and all was fine. Recently noticed in our spare room (after shifting some of the crap ...
8
votes
3answers
15k views

How do I reinforce the attic floor?

We have an attic I'd like to use as an extra room. The frame of the house is solid 2x8" beams and i'm told that the weight is not a problem there. The attic framing is just a typical framing though. ...
8
votes
4answers
4k views

Floor joists connection to eaves

Apologies if this is a duplicate. I'm attempting to floor my loft space. It currently has 47mm x 75mm ceiling joists, not enough for a floor. I am going to add something like 47mm x 200mm along ...
8
votes
2answers
793 views

What to look for in buying laminate flooring

We are beginning to look at replacing the floors in our home and are considering laminate flooring. We are wondering if there is a difference in type and quality, especially when pricing is concerned. ...
7
votes
11answers
111k views

How can I protect a hardwood floor from a rolling office chair?

My wife's office has solid hickory hardwood floors, and I'd like to protect the floor from her rolling office chair. What can be done to protect the floor? Should I even be concerned about the chair ...
7
votes
6answers
62k views

When tiling a floor must I start in the middle of the room?

I am tiling a small bathroom ~45sq ft. The book I am referencing suggested starting the tile in the center of the room to prevent laying any tiny fractions of tile near one side of the room. I'm ...
7
votes
3answers
3k views

Skinny strip at end of room

Laying vinyl plank flooring, and have ended up with the skinny strip problem at the end of the room. Don't want to tear the whole thing up and start again (economically impractical, apart from ...
7
votes
3answers
5k views

How to replace just a few boards in hardwood floor

I want to replace a few boards in our pre-finished bamboo hardwood floor. After i take the damaged boards out and put the new boards in, how do i get the last board in? How do i get the existing floor ...
7
votes
2answers
12k views

How do I use a floor nailer near the wall?

I have the floor nailed down in the entire room , except for the last seven courses. The pneumatic floor nailer can't get any closer than that without the mallet hitting the wall. Do I really have to ...
7
votes
2answers
16k views

How can I replace a board in floating wood floor?

I have a condo with a concrete subfloor so I floated an engineered wood floor above it. It's not a "click-lock" floor, it's a glued T&G install. A contractor recently did some work in the unit ...
7
votes
2answers
50k views

How do I make where my carpet meets tile look nice?

We've recently replaced our kitchen tiles. I'm happy with the results but have no idea what to do with the edge. How do I clean this edge up so that it looks more appealing?
7
votes
2answers
16k views

How do I repair a nick in vinyl floor?

We had some recent work done on our house and it appears that one of the workers nicked the vinyl flooring in the kitchen -- resulting in a circular gash about 3/4 inch wide. Here's a picture: ...
7
votes
2answers
3k views

What do I need to do to raise a subfloor?

We're installing an engineered wood flooring in a room that already has a plywood subfloor. The engineered flooring will be 1/4" shy of the height of the hardwood in the other rooms, so I'd like to ...
7
votes
3answers
40k views

Can I use leveling compound between plywood and cement backer board?

I'd like to install slate tiles over a pre-existing plywood floor. The plywood floor is 3/4" and sits on joists. There's a dip about 3/8" deep by 2 feet wide by 5 feet long. My plan was to fill it ...
7
votes
2answers
36k views

How can I build a cheap, do-it-yourself dance floor?

I would like to make a cheap DIY dance floor and I attained a roll of 3.5 ft x 6 ft vinyl linoleum for free. Can I use this in making a dance floor? Has anyone built their own cheap DIY and what ...
7
votes
2answers
6k views

Cutting a Custom Threshold: Best Tool for the Job?

I am in the process of creating a custom threshold to go from a tiled surface down to a carpeted surface. The tile is about an inch above the carpeted floor, so I decided to make a custom threshold in ...
7
votes
1answer
16k views

How should I build a raised subfloor for my basement bathroom?

I've ripped out the bathroom in my basement that was finished by the previous homeowner. I'm now rebuilding, and curious to the most correct way to go about this. The whole basement was finished ...
7
votes
4answers
279 views

Damp concrete floor in bedroom

Had water overflow into bedroom and closet. New laminate floor removed. Concrete floor has glue strips from another flooring that is sticky in some places. Will thoroughly clean with as little water ...
6
votes
8answers
54k views

How to remove construction adhesive from concrete?

We removed a wooden dance floor that was glued to concrete with liquid nails. How do I remove the liquid nails that is all over the concrete floor? Has anyone had success with heat, mineral spirits ...
6
votes
3answers
3k views

Hardwood floors cupping even after replacement

Let me start off by saying that I am NOT a flooring expert or installer, I am a homeowner looking for answers. About 3 years ago, my home was built in southern Louisiana with reclaimed/antique pine ...
6
votes
2answers
2k views

Frame or floor planks first?

Is it best to frame a powder room and a couple closets first, on top of plywood subfloor, or best to lay hardwood planks first then frame on top? I guess it would be fewer cuts to frame second. What ...
6
votes
4answers
29k views

How should laminate flooring be secured next to brick?

I want to install laminate flooring in a family room that has a brick fireplace. Part of the laminate would be directly next to the brick base of the fireplace. What kind of base-board or base-piece ...
6
votes
1answer
5k views

Should I tile or carpet first

I am getting new carpet in lounge room. I also wanted to tile a small area that leads from lounge room door to outside. Like a small entry area to stop dirty feet walking straight onto carpet. My ...
6
votes
2answers
570 views

Is it practical to have a wooden floor installed in an apt in India?

I own a house in India. It is on the 3rd floor of an apartment. The floor of the apartment is all concrete with tiles on it. Having lived in the US for a few years now, I have come to like the ...
6
votes
3answers
13k views

How should we sand and treat our Victorian floorboards?

We have recently bought a new house, well a new old house. It dates from 1900, we have taken the carpet up ad are now looking to sand back the exposed original floorboards. We plan on giving the ...
6
votes
4answers
38k views

What hardwood flooring is recommended for high traffic areas?

I am having a house built and the developer wanted to charge me $10/sq ft for the cheapest $3/sq ft Bruce Oak, and more for anything better quality. There was no charge for Vinyl so, I had them put ...
6
votes
1answer
2k views

How to install linoleum floor under carpet?

I am replacing an old linoleum floor in my bathroom (replacing it with just another linoleum floor). It looks like the current linoleum floor was installed prior to the carpeting and the edge by the ...
6
votes
2answers
10k views

How can I strengthen attic rafters for storage?

I have standard 2x4 rafters and want to use it just for storage and I am worried they are not strong enough. I was thinking I could buddy ( or sister) up the 2x4's with another 2x4 or 2x6. or stack ...