Questions tagged [floor]

For questions generally relating to the structure and construction of floors in buildings, including designs, materials, support mechanisms, load-bearing calculations, etc. For questions specifically about the top-layer covering of a floor (tile, carpet, hardwood) see the "flooring" tag.

Filter by
Sorted by
Tagged with
2
votes
1answer
38 views

Toilet flange concreted into floor, replacement?

I've got a toilet on the concrete floor. The old flange has rusted and disintegrated at the hold down bolt slots. But the flange is actually cemented into the floor. I think my #1 option is to cut off ...
2
votes
2answers
82 views

How can I prevent post support brackets from creaking under foot traffic?

I (well, a contractor) added a new addition to my house, and the floor creaks when I walk on it. I crawled under the addition and identified the problem. On each footing, there is a steel bracket ...
1
vote
1answer
42 views

Should we glue above and below our rubber underlayment for wooden floors?

We have received our delivery of 3/4 inch thick engineered wood planks. They are 8 inches wide, random lengths, and the white oak layer on top is about 3/16 thick. Subfloor is very good and solid ...
2
votes
2answers
116 views

Should I be worried, or is this a cosmetic issue? floor in 1935 apt building

We live on the 4th floor of a pre-war, 1935 apartment building in NYC. On one outer wall, the oak floor is separated horizontally about 1/2" from the wall/baseboard. The floor is also little sunken ...
1
vote
1answer
42 views

Sealing plywood edge and faces (Shed Floor)

I am laying a plywood sheet floor in my shed. I have plywood that is certified for humid conditions rather than wet and the sticker on it also says that the edges and faces should be sealed. It is not ...
0
votes
1answer
31 views

Cold air under base board heat from floor

My wood floor doesn't go all the way to the wall underneath the base board radiator. I have a draft coming from that section. - what can I put down to stop the draft and looks nice.
2
votes
1answer
61 views

Sunken area under bathroom cabinets

I'm remodeling a bathroom in a Houston, TX house that was built in 1969. After removing the cabinets on each side, I found that the concrete floor is approximately 2 inches lower where the cabinets ...
2
votes
2answers
73 views

What is the difference between floor and subfloor? Is subfloor a part of floor?

Consider the following image (img_1) I guess the whole thing is called a floor framing system and subfloor is a part of the system. So subfloor is a part of floor. is my understanding right?
2
votes
1answer
51 views

Is this a floor framing system? what is the difference between joist splices and floor joists?

I googled "floor framing" and got lots of results. The following (img_1) is the simpler one. According to the anotations in the image, there are 7 joists, 2 bearers, 6 stumps, right? Consider the ...
2
votes
1answer
91 views

My apartment still smells like polyurethane after over a month! I have a toddler with respiratory issues, please help

I just moved into a recently renovated apartment. I am not sure exactly what work was done or what products were used. It has new parquet wood floors and the place was sitting empty for a month. I ...
0
votes
0answers
55 views

What should I do to my hardwood floors before moving into a new house?

I have a bit of an interesting situation - I just purchased a home which was essentially new construction (basically taken down to the studs and thus the floors are brand new). This is my first home ...
1
vote
1answer
34 views

Grout floor then tile walls?

I've already got the shower floor tiled (4'x8'- half in 2x2 on shower pan and the other half 1'x2' tile). Im using epoxi grout on the floor, and regular grout of the same color on the walls. Should ...
2
votes
1answer
35 views

Kitchen floor mold?

Is this mold under the tile? There was a leak. The floor is not weak when standing on it. Does the subfloor need to be removed? Or would corcobium spray do the job? And how to remove tile glue? Thanks!...
0
votes
0answers
26 views

How can I provide effective access to a subdivided space below a non-structural floor?

One problem faced when finished spaces are built atop concrete slab floors (whether slab-on-grade/slab-as-basement-floor, or a suspended reinforced concrete structural slab floor) is "where do the ...
0
votes
1answer
83 views

Joist hanger too low?

I'm in the process of replacing the joists in a room in my 100 year old house (original members were too far gone with termite damage to do sistering). Original joists were true 2x8s with a 12 foot ...
1
vote
0answers
58 views

Is a tablespoon of vinegar and a cloth adequate to clean tiles with compiled soap, dirt residue?

What is a good product that can effectively clean tiles without damaging them? The type of tiles are floor tiles I think are ceramic based on this and are not shiny. I would like to clean them of ...
0
votes
1answer
58 views

Building a raised platform fort

I want to build a 4m x 5m raised platform for my kids fort. It will be 2m high. I have a few questions: It is OK to attach the posts at the corners or will I need more in the middle? What do I ...
0
votes
0answers
57 views

How heavy can my fireplace be?

Hello: I am a diy and am relocating a gas fireplace. It backs on an outside wall with one floor joist parallel to the wall under the fireplace. The joist is 2x10 x25ft. Beneath is a wall on an ...
1
vote
1answer
139 views

Floor sagging between joist- please help

I recently bought an old home- 102 years old and have some flooring issues. The long story is we bought it knowing it had foundation problems in the rear right corner. The home had a poured concrete ...
1
vote
1answer
82 views

What to do about gap in bottom of plasterboard wall when fitting floating floor (UK)

I have removed the skirting boards in my new build house, as I am going to fit engineered wood floor via the floating method. The issue I have is that after removing the skirting, I was presented ...
0
votes
0answers
33 views

Advice on building a livable cabin floor on a concrete slab [duplicate]

I'm planning to build a 10 x 12 livable cabin based on a shed design. The cabin will rest on an existing concrete slab. Many shed designs recommend building the floor with equally spaced joists. ...
0
votes
2answers
77 views

Advice on building a livable cabin floor on a concrete slab with insulation and plywood

I'm planning to build a 10 x 12 living space based on a shed design. The shed will rest on an existing concrete slab therefore my plan is to lay 6 mil polyethethylene sheeting and foam board ...
2
votes
2answers
78 views

Is it ok to insulate external cantilever floor joists with foam board to fix cold floor?

We have very cold floors in the kitchen because the outside air is moving up through the external cantilevered floor. I'd like to insulate it by cutting 2" foam (probably XPS or Polyurethane) and ...
1
vote
0answers
68 views

New hardwood floor crackles

It would be really great if someone could give me some advice on the following issue: Last year I bought a house and had a hardwood floor installed (solid hardwood, stapled on plywood over crawlspace)...
0
votes
2answers
40 views

Touch up my garage floor after applying epoxy coating

We put RustOleum epoxy floor paint on the garage floor. There were light streaks on it when it dried. We repainted the light spots and reapplied the sparkles. It looks like its not going darken to ...
0
votes
2answers
49 views

Water under shower floor caulk

Shower walls and floor are ceramic tile and caulked around bottom. That caulk keeps getting moldy fairly fast, so I removed caulk (this is second time in a few years) and was going to replace. I ...
1
vote
1answer
68 views

Replacing floor boards and joists

I am replacing water damaged floor boards in my bathroom. They were previously tiled and I will be tiling them again. It's an apartment and below the floor is concrete, with joists between the ...
0
votes
0answers
50 views

1920’s 2 story brick home sagging ceilings down the middle

I am not sure if I should sister joists for both the 1st floor ceiling and then the second story floor or can I jack up just the 1st floor ceiling and take care of it that way. Its a hip roof with no ...
0
votes
2answers
48 views

slab heat pipes and radon reduction

My house has slab heat and the pipes come out of the dirt and go to the heating unit. This is located in my basement and I'm wondering how to seal it to help reduce radon entering the house.
0
votes
1answer
54 views

Subfloor tolerance for engineered hardwood

I am installing (floating) 3/8" engineered hardwood with 1/8" QuietWalk underlayment on a cement slab. I have used a grinder and leveling compound to remove the large valleys and hills. Now I have ...
1
vote
1answer
76 views

Spider-like / roots? mold?

We recently discovered our dishwasher was leaking under our flooring into the subfloor (formerly the floor - oak before the previous owner added pergo). We’re in the process of cleaning it up and see ...
1
vote
1answer
82 views

Proper subfloor for hardwood in a renovation

I'm doing some work on the 2nd floor of a 1955 cape. The subfloor is 3/4" tongue and groove planks and there are 3/4" (maybe 5/8") fir plywood sheets installed over that. The sheets are... odd... ...
0
votes
2answers
85 views

How can I seal a two inch gap in the floor along a wall?

I have almost a 2 inch gap between my wooden floor and wall in the apartment I am renting. I think the dust down there is causing me allergies and I’m worried about the cold AC air escaping down there....
1
vote
1answer
34 views

Peel & stick tiles for temporary floor covering over chip board?

We recently had a toilet tank crack. I caught it within two hours. stripped the carpet and foam underlay from the affected hallway, vacuumed up the water, and had a fan on the chip board all within ...
0
votes
2answers
109 views

LVL Span Ratings and Beam Placement

I work with LVL beams frequently and see a lot of them placed under I-Joists to carry load of the floor. This is usually no big deal in 9' deep basements but in 8' basements an 11-7/8" triple LVL beam ...
0
votes
1answer
62 views

spa weight of 4,250 lbs

I have a pre-existing patio and would like to add a spa tub which weighs 4,250 lbs filled with water. Unknow is, re-enforced with re-bar? the exposed one side appears to be at least 18 inches thick. ...
16
votes
1answer
2k views

Orange material in grout lines - need help to identify

Having recently moved into a new (resale) house, I looked closely at the grout lines on one of the tiled shower floors and noticed many small gaps in the grout lines with an unidentified orange ...
3
votes
1answer
70 views

How to close this wall

My house has a small "porch" near the main door. In many years I've been here, I never once used this area that is on the North side of the house as a porch. It tends to collect junk that I need to ...
7
votes
6answers
1k views

How to laser-level close to a surface

Many self-leveling lasers, including my Bosch GCL 2-160, have a limitation when used to level a ceiling or a floor: the horizontal laser beam often cannot get within several inches of the ceiling or ...
0
votes
0answers
44 views

Uneven floors from settling rim joist

We're trying to fix the uneven floors in our 850 sqft, 80 year-old house in San Jose. Our contractor opened up the floors and the problem appears to be that the floor joists rest on a skid, while the ...
2
votes
3answers
88 views

Concrete or mud pad below two layers of tile in bathroom. Not sure what it is and whether to demo it?

I recently started renovating one of our bathrooms. After removing a few tiles there was a second layer of tile beneath. Below the second set was a concrete/mortar base that is ~1.5 inches thick and ...
0
votes
1answer
105 views

What causes and how to fix lifting floorboard?

It doesn't seem to want to lift up. I assume it is some sort of tongue and groove board because there are no nails or screws anywhere. When I press down on the lifted part with a lot of force it ...
0
votes
0answers
42 views

Repairing cut wooden floorboards on either side of the main joists

How do I repair cut wooden floorboards that have been cut on either side of the main joists, as now the floor is squeaking and bouncing all of the time? I have tried attaching baton underneath with no ...
0
votes
0answers
28 views

Domed concrete floor (garage) needs leveling

I am about to replace a 14ft wide garage door. The concrete floor is domed in the centre of the doors width. The mid section of floor is roughly level for about 6 feet wide but falls away each side ...
1
vote
1answer
37 views

Q: What is the safest way to clean soiled concrete for tiling in a small kitchen?

I'm planning on tiling my kitchen floor which is bare concrete. However, I did a water test on the concrete and it's soiled to the point that water beads up on the surface. The floor most likely needs ...
0
votes
0answers
123 views

?? black tubes in basement floor?

My house in Canada is 14 years old . From original construction, rising up out of the concrete basement floor are 18" black tubes about 3/4 inch O.D. in three different locations . What are they for ?...
0
votes
0answers
54 views

How to install second subfloor?

I'm putting in 12mm floating laminate with a 4mm felt underlayment in my living room and I noticed some bowing in the current subfloor to the point where I can see it while standing up. The high ...
5
votes
1answer
461 views

Cutting already installed tile?

I am planning on installing floating laminate flooring in my hallway among other places in my house. I wanted to take out the tile on the outside of this small bathroom and I wanted to wait to replace ...
0
votes
1answer
53 views

What STAINABLE wood fill is best to use on a plywood floor? [closed]

I am doing a quick fix on an existing plywood, unfinished floor. I need to fill the gaps between boards before staining, then applying polyurethane. I have plenty of Minwax Stainable Wood Filler to ...
1
vote
2answers
96 views

Approaches to level a concrete floor with shallow pipes

I have a situation very similar to How to level a section of raised concrete floor?. Except, in my case the obvious solution of grinding the high point is not possible. In my hallway I have a raised ...

1 2 3 4 5 12