Stack Exchange Network

Stack Exchange network consists of 175 Q&A communities including Stack Overflow, the largest, most trusted online community for developers to learn, share their knowledge, and build their careers.

Visit Stack Exchange

Questions tagged [doorbell]

Installing, troubleshooting or repairing a doorbell.

0
votes
2answers
907 views

Doorbell constantly rings even after replacing switch

This is a newer home in the US (fewer than 10 years old). The doorbell started ringing all the time. Disconnected button and it stopped. Replaced the button with a new button, and it stayed on all ...
0
votes
1answer
14 views

Swann HD Doorbell

I want to hardwire my Swann HD doorbell, rather than using it's in built battery. Can I use an existing cable which supplies 18Vac 1.25amp from a powerplug, whereas 16-24Vac 1amp is specified in the ...
0
votes
1answer
643 views

Nest Doorbell not ringing indoor chime

I recently picked up the doorbell from Nest, the Nest Hello and set it up. One issue that I'm running into is what wires should be used when trying to make it work with the indoor chime. The ...
2
votes
0answers
97 views

Extremely old doorbell transformer filled with black gunk?

I need to replace my doorbell transformer in order for my Ring video doorbell to consistently have sufficient power. After searching long and hard I finally located the transformer, which appears to ...
1
vote
0answers
148 views

What are these extra black wires connected to my doorbell chime?

I attempted to install a new SimpliSafe video doorbell, and after everything was connected I found that the doorbell chime inside produced a disturbing humming sound. I contacted SimpliSafe, who sent ...
1
vote
0answers
74 views

Rear outdoor range hood turns on when doorbell rings

I have an outdoor range that is on my back porch that is built into the wall. There is a GFCI outlet right next to the range (not sure if that is related). For some reason when someone rings the ...
1
vote
0answers
37 views

Wired doorbell problem

Doorbell does not ring. Tested wires to buttons, they have power. The chime unit seems to have power to both back and front all the time, even after disconnecting wires from both buttons. Not sure ...
0
votes
0answers
27 views

Installing Nest Hello Doorbell

So my problem with this has nothing to do with the electronics - it's strictly a physical one. The problem I'm having is that whoever wired my existing doorbell left about 1" of wire, with no give, ...
0
votes
0answers
53 views

Doorbell, intercom and door release

I have the same exact set up as the photo on Decrease apartment intercom door buzzer volume and am trying to figure out how to disable the doorbell/buzzer without disconnecting door and intercom ...
0
votes
0answers
19 views

Humming from Door Bell TRansformer

Lately, I have been hearing a loud humming sound coming from the vicinity of transformer and door bell chime area. Is this normal for a transformer/chime combination that is 40 years old??
0
votes
0answers
164 views

How can I mount a Ring Pro on this door post?

My wife has had her heart set on getting a Ring Pro video doorbell since someone at work demonstrated theirs. We picked one up from Lowes today, but discovered we had an issue when we got home and ...
0
votes
0answers
159 views

Doorbell button wire low or no voltage

I have existing wiring for my doorbell that goes from the front door to a closet. No actual doorbell or chime is hooked up, just wiring. When I connect a 24v transformer to the closet end, I'm ...
0
votes
0answers
89 views

Removing or re-using doorbell from home alarm system

My home has an alarm system inside that I've never used and don't have much interest in. I don't know if there's a password needed for the panels, and I haven't tried to program them. At some ...
0
votes
0answers
2k views

Fixing constant humming from mechanical doorbell with video doorbell ringers (ring/skybell)

We have an old house with a neat mechanical doorbell. The bell is one of the hammer/bell kinds. I've installed 2 video doorbells which have been powered by this just fine. I tried to add a 3rd but ...