Questions tagged [door-frame]

The tag has no usage guidance.

Filter by
Sorted by
Tagged with
2
votes
4answers
199 views

Door Does Not Close Properly

I have a door in my home to one of the bedrooms, that will not "catch" when you close it. If you lift up on the doorknob then it "catches" and will remain shut. I was curious, if I put a "stronger" ...
0
votes
1answer
99 views

New door binding on frame

I recently remodeled my bathroom and my father-in-law helped me install a new door to the bedroom. At the time it was installed the door would open and shut perfectly. But now that the wall and trim ...
1
vote
2answers
384 views

Bowed Stud at Rough Opening Door Frame

I have a door frame that we had a hard time figuring out due to ceiling bulk heads. The Rough Opening was supposed to be 82x32, however, after drywall we have a Rough Opening of 81 3/4" x 31 1/2". The ...
0
votes
2answers
181 views

euro hinge installation too far

I decided to replace the hinges on my doors recently. Unfortunately, I drilled the holes in the door a bit too far from the edge and when I try to open the door it hits the frame. It seems to me I ...
0
votes
1answer
398 views

How to fill in hinge and door handle mortises?

Replaced an interior hollow core hinge door with a bi-folding one and now need to fill in the mortises in jambs. I've read people recommending all sorts of things and got a bit confused. There's ...
2
votes
1answer
10k views

Gap between door and frame is too large at latch location

As you can see in the photo the gap is the right size towards the top and bottom of the door but widens in the middle and is the widest where the lock is so the bolt barely reaches the strike plate. ...
0
votes
1answer
368 views

Load Bearing Weight Capacity of a 3/4“ x 3/4” Wood Molding?

I'd like to custom install Ikea PAX sliding doors into my existing closets, recessing them into the closet opening. My idea is to create a custom "frame" simulating the Ikea closet frame onto which to ...
2
votes
1answer
2k views

Sliding Door Frame Slightly Bent Towards Center

I recently moved into a new house and have noticed that the sliding door frame slightly bends toward the inside of the house. If you open the door and stand perpendicular to the door in the door ...
0
votes
2answers
259 views

Why does a steel door frame for drywall have a double return/backend

Title pretty much says it all, but here is a picture just in case: I think it has to do with the wall achors but I can't find a definitive answer. Just to clarify: steel frames for masonry walls ...
2
votes
1answer
124 views

What is the most important aspect of plumbing door frame

When installing the rough framing for a door frame, what is the most critical thing to get right? Since lumber is rarely a perfect, uniform, straight piece of wood, there are going to be all sorts of ...
7
votes
2answers
2k views

How accurate does a door rough-in need to be?

Having never installed a pre-hung door before, I am wondering how accurate does the door rough-in need to be? I am planning on installing a 28" bathroom door, which has a 30" rough in. After framing ...
0
votes
1answer
58 views

Product & technique recommendation to trim this door

So I had a new retaining wall built for the walkout from my basement, and there is a small gap (about an inch) between between the door frame and the wall. Currently it is filled with spray foam that'...
0
votes
1answer
170 views

How can I fix my door frame

So yesterday I accidentally locked my bathroom door so I had to kick in the door and now a piece of my door frame came off (the door still closes and is fully functional ) I wanted to know how I can ...
1
vote
3answers
1k views

How to block airflow under an interior door over carpet

I have an air conditioned bedroom. I'd like to prevent heat from entering thru the door. I got door seals for the sides the top of the door, but I can't figure out a good solution for the bottom of ...
1
vote
5answers
2k views

New door jamb is smaller than the one it replaced. Can I use it?

I've installed the new jamb, however the new jamb appears to bow a bit, and goes in quite a bit at the bottom. I haven't screwed it down yet, or shimmed it, I wanted a second set of eyes (and 3rd, 4th,...
3
votes
2answers
2k views

Exterior door jamb construction

I've an entryway with a 9 inch jamb. I'm planning on buying a slab door and building a custom jamb. Few questions : What kind of wood is the best for exterior door jambs ? How do I extend the ...
2
votes
1answer
1k views

Hanging a new shed door on a frame that is not level

I have moved into a house that has an old shed without a door. I have just bought a tongue and groove, braced and ledged door and primed and painted it. I'm looking to install it. I have 3 issues: ...
7
votes
10answers
15k views

Why is a steel security door safe if they can break the glass, slide their hand in, and unlock the door?

OK I had a hard time thinking of a good title but here's the gist of the problem/concern I have which I can't find an answer to anywhere online. Please note that this is a very specific but common ...
6
votes
2answers
341 views

Why do we screw doors into the doorframe rather than the studs?

I just finished fixing my door to my garage, which would not latch because the door had sagged. The final remedy was to drill the holes in the hinges deeper and put 2" long screws into the frame to ...
2
votes
2answers
17k views

How to reverse a door's opening direction

I found a previous question which is similar to this. However, that person was asking about having the door open outward in the opposite direction. I had initially thought about doing as much, but ...
2
votes
2answers
9k views

Adding sidelights to a front entrance that does not have them

I am trying to determine the cost, effort and complexity of adding sidelights to an entrance way that currently does not have them. Would the entire front door way need to be re-framed, header, ...
0
votes
2answers
3k views

How can I seal an interior door

One of my bedroom doors has gaps at the bottom and side. How can I close or seal these gaps. I would like to heat only this room and prevent loss of heat to other rooms. The gap at the bottom is from ...
2
votes
1answer
885 views

How to attach short bottom plate for door frame to concrete floor?

I'm framing out my basement, which I've done once before in an old house. I use the treated wood (green board?) for the bottom plate, raise up the frames, get everything level, and use cut nails to ...
0
votes
2answers
1k views

Mold Growing on Top of Exterior Door

I am not that knowledgeable with mold. On my exterior front door by the head and the door stop I have mold growing. I checked the drywall and it doesn't seem to have any water damage. I was thinking ...
0
votes
2answers
214 views

Badly Hung Door

When opening this door more than 90 degrees or so, it hits the floor, which I checked, it's level. It seems the doors was not hung properly. 2 choices, when open as far as it will go, just produce ...
0
votes
1answer
99 views

Door Casing Gap Against Cement Board

My home was built in the 1950's and I'm in the middle of a full bathroom renovation. Basically I installed some door casing today, nailing it to the door box/frame. As expected, this left an ~ 0.33" ...
0
votes
1answer
933 views

Fixing part of interior door jamb/frame

The bottom portion of my door jamb/frame to a bedroom was rotting, so in a pinch I remove the rotting portion (because of the terrible smell, and my kids were starting to pull at it). How can I fix ...
2
votes
2answers
15k views

Installing a door threshold on concrete slab

I am trying to install the following door threshold on a concrete slab. The door leads outside and the old threshold was rotted from water penetration. The following pictures show the concrete ...
1
vote
1answer
97 views

Wood frame door and window repair. Steps by step answers please. In Ecuador

These are the wood parts that have been very badly damaged by sun and water. How can i restore them to the natural color they had. Id like step by step information please. Also i am in Ecuador so some ...
1
vote
1answer
833 views

How would I go about installing a prehung door in this opening?

I've got an actual opening of 35.5" in an opening between my basement and garage. I'd like to install a prehung door (first time), and am a bit confused about the width necessary for framing. My ...
1
vote
1answer
60 views

ivy growing between sliding glass door frame

On the ground floor of my house, I have a sliding glass door. A small stalk of ivy has grown through the caulk (or other sealant?) between the frame/wall of the house and the frame of the sliding ...
1
vote
2answers
5k views

Filling Gap Between External Door Frame and Wall - For Securing Strike Plate Screws

What can I use to fill a gap between a door frame and the wall, at the location where the strike plate screws will be anchored? I recently installed a new external door frame where the wall ended up ...
5
votes
2answers
5k views

Best way to cover bedroom doorway that has no door?

I have recently moved to a new 'two room' apartment which I guess was formerly a one room apartment that was that was split in two by a wall whose stability I cannot really vouch for. The main ...
2
votes
1answer
100 views

When is the best period to fix a door frame?

When we moved in our condo, one of the doors had issues closing correctly so we decided to fix it during last autumn. We made it to close perfectly. It seems the house has moved a lot during this ...
1
vote
3answers
71 views

How can I get my entry door to stay closed?

Our entry door opens and closes fine but it won't engage the latch when it's closed. It almost seems like it's too small for the frame. The wind just howls through the opening and the strike plate on ...
-2
votes
1answer
2k views

How can I fix a hole in a hollow wooden door?

Recently the lock in my wooden door failed and the only way to open the door was to "motivate" the lock. Unfortunately the door was hollow and I ended up putting my foot through it. Now, rather than ...
3
votes
1answer
815 views

How do I repair this interior door?

I am trying to fix a door that the kids broke. Should I use use wood glue, clamps, and some small nails?
1
vote
3answers
2k views

How do I keep the door jamb moulding from pulling away from the wall when hardware is screwed in?

Total novice here. My wife wants one of those security door guards (a hinged arm that swings open to a point) on the door. I had bought the hardware, but put it off when the provided screws turned out ...
1
vote
0answers
200 views

What do I need to do to extend the width of a doorway?

I want to make the doorway from my kitchen 39 inches longer opening the kitchen up to the living room. The door way that we have now is only 36 inches wide and I want to make it 75 inches wide. What ...
0
votes
1answer
3k views

Uneven/big gap between door and stop trim weatherstip will not seal

When closed, the gap between the outside face of my garage entry door and the stop trim built into the door jamb/frame is very uneven. The door opens into the house. On the hinge side and the top, it'...
0
votes
1answer
3k views

How do I install a new header in an exterior load-bearing wall?

I am replacing a 36-inch exterior door with a double door, 6 feet wide. It is going into a studded ground floor wall. There is another story above it. House is 24 feet wide. Assuming I am reading the ...
1
vote
2answers
927 views

Does the rough opening for this door need to be reframed?

I bought an inexpensive 32" prehung entry door to replace an old wood door in my detached garage. After removing the old door and some really bad furring work, the rough opening is just shy of 36" ...
2
votes
2answers
2k views

Best method of repairing plastic door frame

I dropped a canister going through the outside patio doorway and the corner chipped away the plastic door frame. I see that these frames are all one piece and expensive and time consuming to replace. ...
4
votes
1answer
6k views

What animal are these coffee-ground-like leavings around my doorframe from?

We are finding strange stuff around the frame of our bathroom door. It looks almost like ground coffee, and has no discernible smell. It's getting out of hand: we cleaned it up yesterday and this much ...
0
votes
4answers
232 views

How to fix doors not closing

I had a contractor come in and finish my basement. He done a decent job for the price but now a couple months later my doors wont shut. They worked perfectly fine before but now it seems the top ...
1
vote
1answer
313 views

What technique is used to cut these door moulding?

I have some door trims that need replacing and I want to match them with the rest of the house. I tried doing a straight mitre but they don't look as good and because it's an old house the door isn't ...
4
votes
2answers
19k views

How to frame a door in a passageway?

I'd like to add a door into the entrance of a passageway which leads into the bedrooms. The entrance dimensions are 87 1/4 X 39 3/4 and is drywall. it seems the standard door widths are 36 X 80, so it ...
1
vote
0answers
51 views

Sticky door when opening, sounds like sticky paint [duplicate]

I am trying to find a solution to my door sticking when I open it. It creates a loud popping sound from the wood after being stuck together. This would be my bathroom door, i work late hours and when ...
2
votes
1answer
1k views

Door newly out of plane - just winter weather or bad framing?

My front door is out of plane - the top left corner does not sit completely in the frame. The funny thing is this is brand new. We've lived in the house for two years and it just started this winter. ...
0
votes
1answer
1k views

Making a timber frame cupboard door using an MDF insert to hold its shape

I have been working on a design for some cupboard doors. The requirements are: - Simple to build so that an low-skilled wood-worker (myself) can put it together. - Be strong enough that the door ...