Questions tagged [conduit]

Electrical conduit is used to protect electrical wires, when a simple jacket alone is not enough. Conduit may be metal or plastic (PVC). Use with the [electrical] tag.

Filter by
Sorted by
Tagged with
1
vote
2answers
713 views

Reducing 1 1/2“ conduit to 1/2” liquid tight

I'm running multiple wires through the same PVC conduit pipe (1.5") that need to exit into flexible liquid tight that is (0.5"). I'm not seeing any reducers for doing something like this other than ...
4
votes
2answers
6k views

Cable securing/support, conduit, etc when exiting main service panel: questions

I'm totally confused by this. Looking for any help that anyone can provide. I've attached a photo of the top of my recently-installed (inspection passed) service panel. The top of the panel sits ...
4
votes
2answers
11k views

What size wire should I use for my yard shed, and how deep should I bury it?

I'm planning to build a shed next spring, and want to make sure my thoughts on power are correct. The shed is about 100' from the house, with another 20' inside the house to get to a subpanel. All I ...
2
votes
1answer
492 views

is fire alarm system conduit color clearly identified on NFPA or UFC?

Inspector says that I have to use red emt conduit for fire alarm system. I want to prove that it doesn't specified in any standarts.
3
votes
1answer
144 views

Easiest & NEC 2011 compliant way run wire into attic?

I have this surface mount wiring connected to an outlet through the bricks (bottom-middle in photo). I would like to branch from this to add a switch (through bricks) and go straight up into the ...
1
vote
1answer
51 views

Running 8/3 along strongback

I'm running a 220(240) 8/3 line for a table saw in my garage. I can fish the 8/3 to the box. I need to run the line to the other end of the garage. The other lines are run down the 1.5" side edge ...
3
votes
2answers
7k views

Is a conduit required or recommended when running SER wire in unfinished space?

I'm planning on installing a 100amp sub panel in the garage. The garage is right around the corner from the main load center in the basement, but part for that path goes through the stairway from the ...
2
votes
1answer
254 views

How to run low voltage wire from one side of kitchen hood to the other?

I need to run low voltage wire for under cabinet lighting from one side of an exhaust hood to the other. I would like to install a conduit so that the wire can be pulled later in the project (after ...
1
vote
2answers
1k views

Running conduit between basement and 1st floor

My basement is currently unfinished but within the next few months we plan on finishing half of it as living space. Before the framing and drywall goes up I want to run a conduit between the ...
1
vote
1answer
110 views

Adapting an outside wall outlet to suface mount conduit?

This was a previous question with some great answers. How can I adapt a wall outlet to suface mount conduit? One answer was: "There are collar boxes available that have conduit KO's (knockouts). Just ...
5
votes
4answers
892 views

How one is supposed to “plug” a conduit running from basement to attic?

I'm going to install a 2" conduit from my unfinished basement into the attic, through the first and second floor. It will be used primarily for getting Cat6 cables into upstairs bedrooms. 2" diameter ...
2
votes
1answer
786 views

Where can I find straps or hangers to secure/support FMC?

I am looking for products to secure FMC (flexible metal conduit). I am having trouble finding any straps or hangers larger than trade size 3/8" that are labeled for anything other than EMT (electric ...
1
vote
1answer
325 views

Is there such a thing as a backless junction box/conduit fitting?

I have a battery enclosure for a small off-grid solar installation, and I want to run the battery cables out of the enclosure to the DC breakers and inverter. I'm looking for a backless junction box ...
0
votes
1answer
4k views

PVC electrical conduit connection to service panel

I am installing an outdoor conduit that consists of four #8 AWG THHN wires inside gray 1" PVC. I need to hook it up to the main service panel and I am not sure what's the best way to do it. I ...
3
votes
2answers
22k views

Conduit Size for Sub-Panel run?

I have old overhead wires that go between my home and a detached garage. The plan is to remove the overhead wires and install a new sub-panel in the garage with an underground (PVC 80) run between the ...
0
votes
2answers
2k views

Hanging EMT conduit exterior to home

How high does exposed EMT have to be from ground running down side of home?
2
votes
1answer
4k views

Is PVC conduit OK above ground to hook up a Jacuzzi?

We are hooking up a Jacuzzi and need to run # 8 wire above ground What PVC should we use to run under our house to get to the back yard? I have read Schedule 80 PVC will work.
2
votes
1answer
1k views

Non-metallic conduit support on horizontal surface in inaccessible space

NEC says I need to secure 1" nonmetallic rigid conduit (Schedule 40 PVC to be precise) every 3 feet, which makes perfect sense when it is hanging between supports horizontally, across joists, or on a ...
2
votes
3answers
1k views

How to connect metal conduit to in-wall NM cable?

I have NM cable in metal conduit running along a wall. At a corner, the conduit enters wall space, and ends at a metal box in the wall. The line is continued by in-wall NM. How should I handle the ...
1
vote
4answers
8k views

What diameter PVC conduit should I bury under my front yard?

I'd like to run two 20A circuits to the other side of my front yard. I'll be using 12AWG THWN conductors, over a length of about 20 feet through PVC conduit buried at a depth of 18 inches. What ...
0
votes
2answers
102 views

What conduit should I install underground that meets code?

I want to run a conduit under my front yard about 20 feet. I will be trenching to 18 inches deep, but was curious what the easiest conduit is to install that meets code? PVC? EMT? Liquidtight?
0
votes
0answers
492 views

Commencement of Rewiring Room with EMT conduits inside the walls

I am rewiring an old house (50s) with romex to have the flexibilitiy to run it outside conduits when necessary and to further protect the wire from creatures plus making it easier to upgrade in the ...
3
votes
3answers
8k views

What size conduit should I use for Coaxial and Ethernet?

I'm looking at feeding both a coaxial and an Ethernet(probable cat6A) cable too multiple locations in my house shortly. I was wondering what size conduit should I use?
1
vote
2answers
2k views

How do I install EMT conduit for an outdoor 6/4 power run?

I need to run NEMA 14-50 50A outlet from the breaker show to the garage (approximately 30') . From the red line, I plan to run 1" EMT conduit as show in the picture, four #6 wiring inside, 50A breaker ...
0
votes
1answer
409 views

Requirements for adding outdoor outlets

I would like to run a line of outlets on the front side of my house. Ideally there will be: 1 circuit of outlets that are always on for general use 2 circuits of outlets that are on timers, one for ...
0
votes
1answer
554 views

Adding ground to an existing conduit

Continuing my basement shop brainstorming... As I said in another question, the good news is that I've got a 30-amp 240V circuit more or less in the right place and available, and easily accessible ...
1
vote
2answers
1k views

Running LV conduit through attic - what do I need to know?

I want to run 1" LV conduit (Carlon Resi-gard) through the attic. Basically, I am using the attic for the "horizontal" run from one room to another. I will be sealing the hole with some caulking, ...
6
votes
4answers
57k views

How many CAT6 cables can fit in 3/4 conduit?

I was planning to get 3/4" conduit (Carlon ENT/Smurftube) to run network cables through the house. Just how many CAT6 cables can safely fit into 3/4" conduit?
1
vote
1answer
504 views

Is there a way to find rebar in concrete walls?

I was wondering if there is a way to find the tie rods and also plastic electrical conduit in concrete walls. In Ecuador all walls are made from poured concrete and plastic conduit is run. But it all ...
1
vote
2answers
4k views

Do separate pieces of EMT conduit qualify as “pull points”?

Question: Do two separate pieces of EMT conduit joined by a connector qualify as a "pull point"? Background: I need to make six 90 degree turns in 2" EMT conduit to route wire for a new sub-panel ...
0
votes
6answers
874 views

3" conduit with many bends - is it worth to build it?

I am working on sending some cables (RG6, Cat5 and speaker cables) from basement to the attic. This is a typical 2-story house. After reading some posts found over the Internet, I am now considering ...
1
vote
1answer
5k views

Any issue with running 240v and 120v THHN in the same conduit and can they share a ground?

Im running electrical for a mini split which requires a 240 line and there has to be a GFCI outlet near by so I'm running that too. The only way to get it there is through conduit (not buried) so I ...
30
votes
4answers
5k views

How to future-proof a long cable run

I'm starting on a project that will involve digging a long (roughly 150-200 meter) trench from my house down to the road. The trench itself will be a considerable expense and so while the ground is ...
2
votes
1answer
7k views

Can I bury RG6 in the same conduit as electric?

I am burying electric wire in a PVC conduit from my house to my shed, I want to run RG6 cable for cable TV also, can I run the RG6 in the same conduit as the electric wire? without any trouble or ...
2
votes
1answer
9k views

Which cable/conduit should I use to run a new 240 volt line for an oven?

I'm in the middle of a kitchen remodel and have hit a slight snag and need some advice on how to proceed. I'm moving the oven into an island, which requires moving the 240 line used for the oven. The ...
2
votes
1answer
137 views

“Stringing” conduit together

Is it OK to take a piece of string and slip the conduit pieces you are putting together onto it before you assemble them? I was thinking that doing this would be easier than trying to fish or feed a ...
2
votes
5answers
7k views

Will galvanized metal conduit balusters resist rust?

I'd like to use galvanized metal conduit as deck balusters with pressure-treated lumber. Will the bare metal resist rust? If not, is there an inexpensive way to improve its rust resistance?
2
votes
1answer
1k views

Exposed Romex cable on garage ceiling without conduit protection

I am working on an old house. The garage ceiling (attic floor) has exposed beams (ie. it doesn't have sheetrock on the underside that provides for a finished ceiling). The power to the garage door ...
1
vote
0answers
899 views

How should I secure electrical wire to a cinderblock wall in a crawl space?

I just purchased a house that was built around 1995 and has a cinderblock foundation that is exposed under the deck. There is a detached workshop that is about 100ft from the house that gets its ...
3
votes
1answer
320 views

How should I route PVC electrical conduit around lightning prevention downleads?

What precautions or steps are needed when routing Schedule 40 PVC Electrical conduit across (90 degree crossing) a lightning prevention downlead? This downlead looks to be braided copper cable ...
0
votes
1answer
523 views

Adding electrical service to detached garage

Please let me know if this sounds correct- Sub panel fed from 80amp breaker in main building 200amp load center. Roughly 75' of 1" PVC conduit from existing load panel, under existing timber deck, ...
0
votes
1answer
1k views

How to waterproof metalic electrical conduit entrance in concrete wall?

I have concrete garage inside the hill below house level. Electrical metal conduit runs underground and enters the garage at the top of concrete wall. It may 12"-15" below surface. See pictures. It's ...
5
votes
1answer
3k views

What would be the most economical way to run wire for a driveway light?

I want to run electrical power through my woods to end of driveway. There will be no driving or walking over this area of 300', but I do have squirrels, deer and other "critters" that might chew. What ...
7
votes
1answer
5k views

How can I adapt a wall outlet to suface mount conduit?

I have a single gang in wall outlet in my basement. I would like to adapt it into surface mount EMT conduit to get an outlet at a different location. Ideally I would be able to keep a plug at the ...
1
vote
1answer
314 views

What should I do about damaged electrical conduit?

I'm adding an electrical line to my outdoor pool breaker box. I was digging near the box with a pickaxe (yeah, I know, stupid) and was trying to be careful, but I was not careful enough. I don't ...
2
votes
1answer
724 views

Drilled a shallow hole in concrete ceiling and some water came out. What now?

We are on a ground floor of a condo building and to put up the partitions I drilled a small hole and after about 1" depth the drill fell into a void (about 1" more) and about a quart or so of clear ...
3
votes
2answers
2k views

What is the preferred method for removing & replacing electrical wiring in the garage?

I just purchased a house built in the mid-1990s in Kansas, U.S. The garage is generally finished: It has sheetrock walls and ceiling. It also has outlets spaced every 6 feet or so about 4 feet above ...
1
vote
2answers
3k views

Is a weather resistant gfci required outside in a metal box with in use cover?

I have a pool that is just off my deck. The gfci I have went bad so I need a new one. It was a 15 amp gfci in a metal box attached to 1/2 in emt conduit with a metal box and a non in-use cover. This ...
1
vote
1answer
857 views

In the UK, what type of flexible conduit should I use for electrics in shed that run underground and emerge through the concrete base?

In the UK, what type of flexible conduit should I use for electrics in shed that run underground and emerge through the concrete base? I see various standards quoted such as IP66. Would this be ...
1
vote
2answers
263 views

Running conduit near knob and tube wiring

I have some new AC ducts in our new house that will soon be concealed behind new drywall, but before the drywall goes up, I wanted to run some conduit from the upper floor down to the basement for ...