Questions tagged [conduit]

Electrical conduit is used to protect electrical wires, when a simple jacket alone is not enough. Conduit may be metal or plastic (PVC). Use with the [electrical] tag.

Filter by
Sorted by
Tagged with
12
votes
6answers
40k views

Why is ENT rarely used for electrical wiring?

As best I can tell, the National Electrical Code 2011 allows electrical non-metallic tubing ("smurf tube" or ENT) to be used for running 120 V electrical wire. But everywhere I look, I see remarks to ...
13
votes
2answers
4k views

Can I use old abandoned iron pipe as electrical conduit?

I have an older house (1920) and I have been planning on doing some rewiring to get rid of some k + t stuff. Anyway, I just noticed today that there are some irons pipes that used to be part of the ...
8
votes
1answer
754 views

How should I install a signal cable duct from new home office to a wiring closet?

I'm constructing a new home office and rather than having fixed cables from the (existing) wiring closet, I want to have the flexibility to add/remove/change cables in future, so I've been looking at ...
9
votes
2answers
10k views

How do you protect romex at the end of an EMT run?

Sometimes you need to run a circuit through both protected & unprotected space. For example, you might put a recep in workshop (unfinished walls = unprotected) over a crawlspace (protected). To ...
1
vote
1answer
2k views

How do I insulate around conduits and into difficult edges in my attic?

I am thinking about adding a little over a foot of insulation to my attics. I understand that there shouldn't be gaps between fiberglass batts (I read that this can reduce efficiency by 25%, whatever ...
6
votes
5answers
18k views

Does a grounding wire from a breaker panel to an outside grounding rod need to be in conduit?

I've got a breaker panel in my detached garage (it is not a sub-panel, but is a primary forked off just past the meter). The panel seems to be wired correctly- the neutral and ground bars are tied ...
3
votes
1answer
545 views

What is the safe/proper way to run non-metallic conduit between floors?

I need to run a CAT5 line and a 22/4 alarm wire from my 2 story attic to the first floor. I have access to the interior of the walls (I will re-dryboard). I'd like to run carlon ENT from the attic ...
5
votes
3answers
2k views

Running electric cables in basement shop

I am setting up a workshop in the unfinished area of my basement. I need to run a couple of electrical outlets and would like to run them along the block walls through grey PVC. Will this be a ...
4
votes
4answers
7k views

What's the correct way to pass wire to exterior electrical box?

I'm doing some remodeling in our basement, and came across the following (see pictures). It looks like the contractor simply wrapped tape around the conduit to secure the box to the wall. How are ...
2
votes
2answers
3k views

What extra conduit should I include in a utility trench?

I'm putting in a trench with electricity + water + phone from the street to a future house site. The trench will be around 150' long. The electricity and phone will each be in their own conduit, ...
2
votes
4answers
13k views

How does the cost of conduit compare to conventional wiring?

I know I want to future proof my new construction by installing conduit instead of trying to guess what wires I'll want in 50 years. But I want to understand the cost of conduit vs. non-conduit, at ...
6
votes
2answers
639 views

How do I set up a wiring closet that connects to the exterior of the house?

I'm looking to build a central wiring closet for ethernet, phone, and co-ax. I would like this closet to have a single pipe to the exterior of the house, which service lines can come in through. ...