Questions tagged [concrete]

Concrete is composed of cement, aggregate (including crushed rock and sand) and water. In homes, it's frequently seen in the foundation, driveway, sidewalk, patio, and stone walls. Note that bricks use mortar in the joints, not concrete.

Filter by
Sorted by
Tagged with
6
votes
9answers
57k views

What is the best way to remove and prevent leaf stains on concrete pavers?

We have a brand new paver stone walkway/patio. To my dismay, I noticed that their were leaf and acorn stains from the oak tree in the front yard. I've learned my lesson and I'm going to try to keep ...
6
votes
6answers
16k views

Can I build a deck this low to the ground?

I want to build a deck off the back of my house. The door is near grade level, about 1' above. The grade doesn't have very large slope, so that means that the beam at the far end would be below grade: ...
5
votes
3answers
11k views

Extending concrete Slab

I have a 10 x 10 slab (4 inches thick) that is already in my back yard in the corner. I bought a kit to build a 10 x 10 shed on it, and then realized that would put it right up to my fence. So my ...
6
votes
5answers
12k views

How do I hang a chair from a concrete ceiling using a single hook?

I'm putting in a "hanging chair" in the basement and it's supposed to hang from a single hook in the ceiling. The ceiling is reinforced concrete. Now, I'm about 125 kilograms (275 lbs) so I reckon ...
2
votes
2answers
236 views

What's the proper way to fill this hole?

Recently a dip formed in our flooring inside our sports performance training facility. We discovered that the concrete job there had a good number of stones in it, and I believe that it was that ...
2
votes
4answers
17k views

Stabilizing a gravel driveway with massive holes and steep inclination

I have inherited a 270 feet long driveway along a steep hill. It is part gravel/stone, and part concrete. It is in very bad condition. Every winter, rain threatens to wash away parts of it. Driving ...
1
vote
3answers
436 views

Installing hook on strange wall

I need to install some hooks on my wall, which I plan to use to perform elastic band exercises. Hence, I need to install these very well so that they will handle the stress properly. Situation is I ...
13
votes
10answers
115k views

Do I have to remove the old thinset before installing new tile?

I will be installing some new 12x12 tiles in two bathrooms approx 25 sq/ft each. When I pulled up the old tiles, there was no thin set that had made contact with them so the removal was very easy. Now,...
19
votes
1answer
6k views

How to add on to a concrete patio?

I would like to add on to my existing concrete patio with more concrete. I will about double the size of the patio. My question is, should I have the new patio free floating from the existing or ...
6
votes
8answers
54k views

How to remove construction adhesive from concrete?

We removed a wooden dance floor that was glued to concrete with liquid nails. How do I remove the liquid nails that is all over the concrete floor? Has anyone had success with heat, mineral spirits ...
2
votes
1answer
437 views

What type of substrate should I use to install pavers over an existing poured slab patio

I'm going to be putting pavers over an old slab patio. The current patio has settled and spalled, so I'm looking to pitch the paver patio in such a way that it drains as the original slabs did. In ...
12
votes
4answers
141k views

How do you secure wood framing to a concrete basement floor?

I'm using Pressure treated lumber for the bottom plate in a basement finishing project. What should I use to seperate the wood from the concrete? What are ways to secure the bottom plate to the floor?...
10
votes
3answers
11k views

How do I fill in around waste pipes?

Broke the concrete in my basement to run new pipes for the basement bathroom. The plumber put sand under the pipes to support them at the correct angle. I asked him not to glue the vertical sections ...
7
votes
1answer
383 views

How do I know when concrete needs replacing rather than just mud-jacking?

I have a concrete driveway and path to my front door. Much of it has become unlevel and I'm contemplating having it mud-jacked. However, before I do, I wanted to know how I could easily tell when a ...
5
votes
7answers
16k views

Why can't I drive this Tapcon into concrete?

I'm trying to drive a 2 1/2" long 3/16" diameter tapcon into a 50 year-old concrete slab/subfloor to attach a new toilet flange. The instructions on the case of Tapcons said to drill a hole in the ...
4
votes
1answer
2k views

How can I hang a framed picture onto a wallpapered concrete wall without damaging the wall surface?

I have a framed picture about two feet by three feet in size that weighs about one pound (not a sheet of paper). I want to hang it onto a wall that is of full-blown hard concrete and covered with ...
3
votes
2answers
2k views

How to repair cracks in concrete overhang over entrance

I have a slab of concrete over the front entrance of my house with some serious cracks in it. I don't actually know what the proper name for it is, which makes this difficult to Google - so I've ...
3
votes
2answers
5k views

Should I use solid concrete or cement block for an egress window well?

I am having some contractors build a window well for an egress window at my house. I have the option of doing solid concrete walls for the window well, or cement blocks (which he said he will fill ...
3
votes
1answer
6k views

Installing a strong-tie post anchor on unlevel concrete

I'm building a short (3.5 ft) fence in my front yard. I have most of the posts sunk in dirt holes, but two of them will need to be mounted on a concrete slab. The problem is that the slab has a ...
3
votes
2answers
103 views

What type of control joint is best for my concrete project?

I'm looking at getting a lot of concrete work done and am looking to educate myself past the minimal anecdotal information I posses so that I can have a better conversation with prospective ...
2
votes
3answers
3k views

Building on top of 3/4'' plywood subfloor

I want to build this: http://www.mrmoneymustache.com/2012/12/21/how-to-make-a-relatively-sweet-shower-cheap/ and I'm building in my basement bathroom: on top of the foundation I have 2x4 (horizontal) ...
2
votes
3answers
8k views

Can I use construction adhesive alone to attach pressure-treated wall plate to concrete floor?

Replacing walls in basement due to flooding. Contractor installed sump and drain pipe around the inside of the cinder block wall. I want to put in new wall, concerned that TapCon or other hammer/gun ...
0
votes
1answer
816 views

instead of removing low area…puddles in my concrete patio

Amending my original question... The edge of slab is only a couple feet from Low area and it would pour into gravel theoretically if not for the low point. would it make more sense to try to grind ...
0
votes
2answers
2k views

Can I tile over Linoleum felt paper on a concrete slab?

I have a contractor coming in to tile my home. My floor is a post tension concrete slab, home is only 4 yrs old. The contractor said they could just tile right over the linoleum, but after reading ...
0
votes
1answer
55 views

Shedding trees - concrete Patio

what can I apply on an old concrete patio that has maple trees constantly shedding/ staining?
21
votes
1answer
29k views

Are cracks in a newly poured concrete basement floor a problem?

I'm having a new home built and found a large crack in the newly poured concrete basement floor and wanted to see if it's something I should be concerned about. The floor was poured sometime in the ...
9
votes
3answers
62k views

How can I prepare uneven concrete basement floor for vinyl planks?

I have roughly 600 sq ft of basement that needs new flooring after some unfortunate flooding this past summer. We had carpet over concrete and are now looking to lay vinyl planks down. There is about ...
6
votes
4answers
38k views

How to mount hooks into concrete ceiling that must be able to support several times bodyweight?

I am on the top floor of a loft apartment that used to be a factory. I want to install several hooks or some other fixture into my concrete ceiling from which I can hang gymnastic rings, a punching ...
14
votes
5answers
64k views

Why do builders say that wet concrete/mortar is not as strong?

I have been watching a few videos demonstrating the mixing of mortar and cement and a constant theme is that you must not have the mix too runny. I cannot fathom the reason... Does anyone care to ...
9
votes
2answers
19k views

How can I level my basement floor, which has a 4-inch dip?

I googled today on how to level a basement floor. Most people recommend using SLC (self leveling concrete)... I don't think I can just use that because of the pitch of my floor (and from what I hear, ...
9
votes
2answers
29k views

Is it safe to drill small holes in load-bearing concrete beams for expansion bolts?

It seems to be very common to drill small holes in any kind of structural concrete for mounting fixtures without worrying too much about any kind of reduction in strength of the structure, but I ...
6
votes
4answers
2k views

Is it possible to patch concrete stairs?

At my church, there is an old set of stairs made of concrete. They've begun to crumble on the top to the point where the treads are no longer flat and smooth. I've not seen any material that has ...
6
votes
8answers
67k views

Do I really need to use primer when painting an unfinished concrete floor?

I'm turning a one car garage into an office and want to paint the floor. I bought some Behr concrete paint, and the guy at Home Depot insisted that I have to put down a layer of primer first. Do I ...
3
votes
4answers
13k views

What is the best way to remove pet odor from concrete?

The concrete floor in my garage had been home to a large dog for several years. There is a visible stain and strong smell in one area of the garage floor. The concrete does not appear to be sealed ...
3
votes
1answer
2k views

What is involved in enlarging a concrete garage door opening?

I have a concrete garage with an opening measuring 99" wide by 85" high. There is 10" of concrete from the door opening to the left and right walls and about 1' above. All walls are 8" thick and ...
2
votes
2answers
3k views

Concrete slab at a brick wall

I want to build a concrete slab (upon which a deck will be build later) at the foot of a brick wall (by foot I don't mean the foundation foot, I just mean where the brick meets the grade level). I ...
11
votes
5answers
23k views

Can I mix latex paint into concrete

would like to color concrete mix can I use outdoor latex paint to mix in with the concrete?
10
votes
1answer
227 views

In a house fire, how hot does the foundation have to get before it too has to be replaced?

Not long after the Oakland Hills fire in the early 90's I was talking with a homeowner. I ignorantly said that at least he can still rebuild on the same foundation. He said that at about 2,000°F the ...
7
votes
6answers
21k views

How do I hang shelves on poor quality brick/concrete walls?

I'm trying to install some shelves in my apartment (brick/concrete) but when I drill holes the walls almost seem like they're made of sand. I'm not able to securely fix the screws (I'm using wall ...
6
votes
3answers
27k views

What is the best way to fill a hole in a concrete basement floor?

My basement floor has a hole cut where the water line enters the house. This hole is around 2ft square, and digging down a little I hit dirt and small roots. I'd like to seal this hole as I believe it ...
6
votes
2answers
34k views

What should I do about a crack in the concrete slab in my living room?

We purchased the house about 2 years ago. The house is about 50 years old. Today we removed the carpet and the hardwood floors under the carpet. We found out the slab has an approximately 10ft long ...
6
votes
4answers
1k views

How will concrete fill in?

So I am pouring some footings for a deck I am building and my current plan is to dig a hole that is 18" wide and 18" deep. I'm then going to suspend a sonotube about 6 inches above the bottom (using ...
6
votes
2answers
11k views

What should I consider when cutting/making window in concrete foundation?

I am thinking about putting in another window for my basement apartment. I would like to know what do I need to consider before trying to find a contractor to do this. I have uploaded a picture of ...
5
votes
5answers
8k views

What are my options for tiling over an uneven concrete floor?

UPDATE: After doing my research, it seems like I will need to level the floor before tiling. My carpenter doesn't know how to it so I will have to get a contractor to do this job. How much would it ...
5
votes
2answers
6k views

When would I use epoxy anchors?

Epoxy anchor is essentially a metal alloy rod set onto epoxy. A hole is drilled and cleaned, then epoxy is put into the hole and the rod is inserted into the hole and left until epoxy sets. Using ...
5
votes
2answers
11k views

How to level a section of raised concrete floor?

I had a plumber move a toilet drain on cement slab. The new concrete he poured is about 1/8" higher than the rest of the floor. I need the floor to be level for tile installation. The new concrete is ...
4
votes
3answers
6k views

Building a raised wall for a pond

We are looking to build a small pond (9'x18'x6'), but we want the edge to be raised up about 8". I am thinking about using CMUs (Concrete Masonry Units) which are 8x8x16. The entire pond will be lined ...
3
votes
1answer
785 views

Can I rest cement posts directly on the bedrock to build a structure for a large shed?

So I live in Canada, where winters are cold, and where there's not much soil above the bedrock. I would like to build a sturdy structure for an existing "shed" (in fact a 100-year old former stable or ...
3
votes
2answers
2k views

How should I waterproof a concrete roof?

We have a 28y/o Medical Clinic in a remote area of Haiti. The roof is concrete and has one coat of DryLoc on it which is lifting off in many areas. The roof is 136' X 35' with a very slight pitch to ...
3
votes
2answers
13k views

Adding rebar to deck footings and piers?

I've heard a few people mention adding rebar to deck footings and piers to make them stronger, but I haven't been able to find any details on how exactly to do this. Is it sufficient to just hammer ...