Questions tagged [cables]
The cables tag has no usage guidance.
15
questions with no upvoted or accepted answers
2
votes
0
answers
152
views
Power & Cables to outside workshop
(I am in the UK so UK Regulations apply)
I want to run mains power from my (new) house to an outside workshop, a cable length of about 50m. The workshop will have its own separate consumer. I also ...
1
vote
0
answers
49
views
Do I have enough room to thread 4/3 cable with ground through my basement?
I'm planning a partial basement renovation, including installing a subpanel to supply 70A, requiring 4 AWG copper wire. I'd like to avoid installing conduit, so I hope to use 3-strand + ground Romex.
...
1
vote
0
answers
124
views
Wire guage needed for adding a 100 amp breaker box in garage
I'm running a wire buried wire from my indoor breaker box to an indoor breaker box in my detached garage. I have a 200 amp main breaker box but in the garage I am using a 100 amp breaker box.
The main ...
1
vote
0
answers
171
views
What height to attach SWA cable to brickwork
I am about to fit SWA (Steel Wire Armoured) cable to the outside of my house to supply power for a garden office. The cable is mostly underground but will run along the back wall of my house for a few ...
1
vote
0
answers
357
views
Can I fish Romex cable through concealed part of basement ceiling in Canada?
I am running two 2-wire and one 3-wire Romex cables from the panel in the basement to another part of the basement. For most of the run I have access to the ceiling joists, but I need to cross a 2.5 ...
0
votes
0
answers
32
views
Insulating a pre-existing suspended bathroom ceiling
The previous owner of my house has redone the bathrooms and toilets pretty well, with nicely finished suspended ceilings and downlights.
What he didn’t take care of properly was insulation. The space ...
0
votes
0
answers
62
views
How to reroute 5 cables from street pole into attic?
I currently have 5 cables coming from a pole across the street. They have them attached to the eave of the house and that don't seem correct and the eave is tilting away from the house. One of the ...
0
votes
0
answers
65
views
Garage door spring/cable drum conundrum
Recently my garage door failed -- one side was not winding up completely, causing the door to slant and driving the other side into the track at the bottom.
There are two springs, and 7-8 years ago ...
0
votes
0
answers
33
views
Correct sealant for polyethylene (PE) cable and sandstone brick (external ethernet run)
What is the correct sealant to use to make a seal between a polyethylene-sheathed ethernet cable and a sandstone brick will for exterior applications?
I will drill a 10mm hole between the inside and ...
0
votes
0
answers
33
views
Single bulb pendant to 4 bulb pendant
I am replacing a basic single bulb pendant light with a 4 bulb fitting. There are 4 white cables coming from the new light fitting. Do i bundle them together?
0
votes
0
answers
374
views
Running Romex Along Shed Ceiling
We have been working on running electric to our outdoor shed recently, and are wondering what is the preferred way of attaching the romex along the vaulted/pitched ceiling for the lights.
The light ...
0
votes
0
answers
70
views
Cable trunking terminology
I have a few cables running between my desk to a nearby tv screen and an electric outlet. I was thinking about tucking them in a pvc raceway stuck to the wall.
For a more tidy solution, I'm looking ...
0
votes
0
answers
2k
views
Valid number of Cat 6 + Coax cables for pipe conduit?
Here's some old wiring done in my absence as my parents could only monitor so much.
Hate the use of Skinnier version on Flexi Pipe that won't allow any movement or pull once initial install is done. ...
0
votes
0
answers
51
views
Rails for fence?
We're working on installing a fence in our roof. I want it to have a minimalist look (something like this without the top rail), so that it doesn't interfere with the view.
We've already installed ...
0
votes
0
answers
407
views
DIY cable railing corner post configuration?
Using Steeltek pipe fittings to create a corner railing over a half lower level. My plan was to have the uprights and top & bottom rails made from the galvanized pipe & fittings and use cable ...