Stack Exchange Network

Stack Exchange network consists of 175 Q&A communities including Stack Overflow, the largest, most trusted online community for developers to learn, share their knowledge, and build their careers.

Visit Stack Exchange

Questions tagged [boiler]

The boiler is used in a central heating system to heat water that is pumped through pipes to radiators within the home.

10
votes
2answers
90k views

How do I identify the C terminal on my HVAC?

How do I identify the C terminal on an HVAC, furnace, or boiler? If the terminals don't have a screw labeled C what should I look for on the wiring diagram? What steps should I take if a wiring ...
4
votes
2answers
22k views

Where do I connect my C wire from my thermostat when there are two transformers?

I have a Laars gas boiler that has 3 heating zones. I want to replace the old mercury honeywell tstat on the 1st floor (heat only) with a newer honeywell RTH9580 wifi model. I've taken pictures of my ...
1
vote
0answers
23 views

U.s. boiler / Burnham boiler alterations

i have a 203ncl-tei2 boiler installed in danvers Massachusetts. Regular elevation. This boiler also has a failed tejurland (universal control) powerventer motor on it that is only humming, not ...
2
votes
2answers
1k views

Mini-split vs gas boiler for heating

I recently had three mini-split heads installed, two downstairs and one upstairs, primarily for A/C. These are Mitsubishi units, rated down to -15C (or perhaps F, but it doesn't really matter for my ...
3
votes
4answers
73k views

The pilot light won't ignite on my boiler — what I should check?

We have just brought a new house and I can’t get the pilot light to ignite on the boiler, it is at least a few months since the boiler has been used. Where to I start on tracking down the problem? (...
3
votes
3answers
11k views

Combination boiler pressure zero after heating

I generally don't notice a performance problem with the boiler, but after I run the heat to the radiators and turn the boiler off, after cooling down the the pressure gauge shows zero. I can easily ...
2
votes
1answer
1k views

A boiler and a hot water tank … what is this configuration? (UK)

I'm a west-coast American living in London. I've mostly known homes with electric baseboard and central forced air heating, and a single hot water tank for showers and taps. In the UK hot water fed ...
2
votes
1answer
6k views

Potterton EP3000 -> Horstmann C27 boiler programmer wiring

I'm in the UK, using an ancient tempermental Potterton EP3000 boiler programmer, but I have a brand new Horstmann C27 which I'd like to replace it with. Apart from the mains supply, there are three ...
2
votes
1answer
253 views

Pressure level in central heating system

Recently (since last week), the pressure in our heating system (as indicated by the pressure gauge on the boiler) is dropping rapidly. We're having to top this up around once every two days. As I ...
2
votes
3answers
5k views

Where's the C terminal on my boiler control?

The new thermostat I purchased doesn't run on batteries, and needs 24 volt power. I have only a red and a white wire connected between the boiler and the thermostat, but there is also a third, unused ...
1
vote
2answers
431 views

any sort of inflatable cork to plug pipe when shutoff valve is being repaired

I need to fix some leaky return shutoff valves on a hydronic heating system. Is there such a thing as an inflatable device that can be used to plug the pipe to prevent the system from draining while ...
0
votes
1answer
117 views

My boiler's gas burner tube is catching fire, how do I fix this?

About 1 or 2 times a week I hear a roaring flame when my boiler tuns on. I've check on it and it appears one of the boiler gas burner tubes is internally on fire (see video I took of it). What is ...
0
votes
1answer
4k views

Repressurising Logic Combi 24 boiler

I bled a rad that was cold at the top, and not much water escaped. This fixed the rad, but the pressure in the boiler dropped to just below 0.3(It may have been low to begin with, since I hadn't ...