Questions tagged [bathtub]

The tag has no usage guidance.

Filter by
Sorted by
Tagged with
1
vote
1answer
33 views

Which copper adapter should I use for tub spout and what is the difference?

I'm going to sweat a 1/2" piece of copper with a Male Adapter Fitting to thread into the drop-ear for my tub spout. I purchased this: 1/2 in. Copper Pressure Cup x MIP Male Adapter Fitting Later ...
1
vote
1answer
28 views

What is the recommended way of removing a siliconed in tub jet tube

I was trying to get our jetted tub back in operational order when I noticed it was leaking. After cutting a hole in the wall in the other room, I traced the leak back to a tube that was not properly ...
1
vote
1answer
18 views

Connecting braided water connector with 1/2“ female connection to 3/4” male tub inlet

I'm currently using a 3/4" x 1/2" bell reducer and 1/2" nipple to connect my tub faucet's inlet flare (I think that's the right word?), but no matter what I do, I'm getting leaks on both ends of the ...
1
vote
1answer
66 views

Does the ledger board for a bathtub go under the flange or level with it?

Replacing a bathtub with a new one pictured. It will go into a 3-walled space. Durock and tile will be attached to wall to finish the job. I've been reading many articles and they mention a ledger ...
1
vote
1answer
90 views

old american standard bathtub faucet still leaks after replacing 2k-2c cartridge

Just replaced a leaky cold-water faucet cartridge and it still leaks. It's "better" but far from solved. The rubber on the old 2k-2c cartridge seemed to be pretty deteriorated (practically no longer ...
1
vote
2answers
31 views

Replace faucet handles in existing bathtub

I'd like to update the handles for the faucet in an existing soaking tub to something more modern than these knobs. Is it possible without taking out the tub?
1
vote
1answer
32 views

Can I remove just the upper part of my 1 Piece Acrylic Tub (Walls) and leave the tub in place?

I want to tile the walls in my bath but don't want to remove the one piece acrylic tub. Has anyone ever cut down the tub walls and tiled down to the edge of the existing tub? I anticipate placing a ...
1
vote
1answer
375 views

How to remove bathtub drain flange with nubs?

I have a non-standard bathtub drain flange that I'd like to replace (and also clean up the rust) that has a pair of interior nubs. The drain is 1.75 inches in diameter, and the nubs sit about 0.5 ...
1
vote
1answer
314 views

Fill hole in slab beneath tub to reduce radon?

We recently discovered that our downstairs bathtub has a large hole in the slab beneath it where the tub drain and a few other pipes go into the dirt. We had a radon mitigation system put in a few ...
1
vote
1answer
933 views

New bathtub diverter spout drains back into wall

I replaced my old diverter spout with a new one (both Delta), and I've found that the new one will leak water back through the hole in the wall if the diverter is switched off while the shower is ...
1
vote
2answers
1k views

Drywall/Cement board transition for a tub surround

I am remodeling my bathroom, and intend to replace my bathtub and surround. I have started ripping the 5/8 in. drywall from around the bathtub, and I intend to install a cement board and tile all the ...
1
vote
4answers
4k views

Shim Tub Surround for Cement Board

This has probably been asked a million times. Had a new tub installed today. The tub straps will interfere with my Hardiebacker, which I had planned to run right down to the top of the tub flange. So ...
1
vote
1answer
4k views

How can I relocate this drain to accommodate the new shower pan

I removed a fiberglass shower/bath combo and I wish to replace it with a TileRedi shower pan. 42x60 right drain. the problem is, the spec drawing shows the center of the drain to be 6 inches away from ...
1
vote
2answers
570 views

What are the design limits of a normal tub overflow drains (and their gaskets)?

We have a leak from the tub into the ceiling below. I'm pretty sure it's from the overflow drain, but as soon as the home warranty plumber heard this he said "oh, that's the problem, the overflow ...
1
vote
2answers
5k views

Tub spout leaking when water is off

What could be some reasons why a tub faucet's spout leaks when water is turned off? E.g. some gasket within the mixing valve perhaps? The shower doesn't leak, just the tub spout.
1
vote
2answers
3k views

How can I transition from baseboard to a flat bathtub?

I have 3 1/4in baseboard molding that I want to transition from to a flat surfaced bathtub/shower. What are the generally accepted options for doing so? I could cut it at a 45, 90 or some other option ...
1
vote
1answer
38 views

Humidity Sensor Bathroom Fan (UK)

Wonder if anyone can help? I have just replaced an old timed electic fan with a new humidity / timed sensor fan. The fan location has a 1x Perminant Live, 1x swiched Live (bathroom Light) and 1x ...
1
vote
1answer
1k views

Leaking whirlpool tub; in alcove, but no tile flange at bottom of walls

In brief: my alcove whirlpool tub has always leaked at the seam between the tub and tile wall, and it needs to be fixed. I just discovered that this tub has no tile flanges where it meets the walls; ...
1
vote
1answer
71 views

Bath Tub replacement

We're in the process of looking at getting a cracked fiberglass tub/shower replaced. We had one contractor come out that recommended using an acrylic AKERbyMAAX tub. I'm ok with the acrylic tub, but ...
1
vote
1answer
167 views

How can I attach a new drain to a drain pipe that's fallen away from the tub?

Hello everyone, Noobie here and I think I shot myself in the foot! I wanted to replace the old drain with a new one so my almost 2 year can have bubble baths. I was able to remove the old drain ...
1
vote
2answers
8k views

Questions about shower wall tile install

I'm getting ready to install 12x12 ceramic tile on our tub walls. What type of thinset should I use? Ancillary to that is the type of grout to use? Sanded or unsanded? While researching the ...
1
vote
1answer
858 views

Blue stains from water

What would cause blue stains and a blue tint to our bathroom tub and sink have water purification system in use for aprox. 7 yrs. Does this need any maintence
1
vote
1answer
1k views

What can I do about a jammed tub drain plug?

We have an older home with a parallel bar tub drain plug that is internal to the P trap. Similar to that of a Bathroom sink. Lift the lever up, to bring the plug inside the p-trap to position to plug ...
1
vote
1answer
383 views

How can I remove a stuck tub spigot?

While trying to remove the child safety cover from my tub spigot I managed to shear off the plug mechanism that activates the shower. The guy at the hardware store sold me a new spigot and now I ...
1
vote
1answer
28 views

If an overflow gasket does not fit, can it be rotated?

Our new tub is very vertical at the supply/drain side at the overflow hole. The drain fitting we have slopes backwards very slightly where it connects. The rubber gasket for the overflow is very ...
1
vote
1answer
597 views

Tub to shower conversion plumbing questions

I'm in the middle of a tub to shower conversion but am a complete amateur when it comes to plumbing issues. The tub is out, the walls are open, we have the stand up shower kit bought. But upon looking ...
1
vote
1answer
35 views

Can I have a wand installed in tub in addition to a 3-hole faucet?

I have a new tub being installed that takes a deck mounted faucet. I found a faucet I like which is a two handle, 3-hole type. However, it would be nice to have a wand mounted on the deck as well. Is ...
1
vote
1answer
63 views

Is it wise (or even code-compliant) to cut an access panel for my bathtub drain?

I am installing a replacement bathtub. I've decided that I need to slightly lengthen my overflow pipe, and it would be kind of nice to be able to inspect that area well for leaks, before I put up the ...
1
vote
2answers
31 views

leaky bathtub not sure where the leak is

We had drips from ceiling right below bathtub upstairs. It only happened when the tub was filled with water(even small amount, so probably not overflow issue). I don't see any bathtub crack. What can ...
1
vote
2answers
114 views

How should I shim the feet of a modular tub?

I did the tile in another bath - house built around 1990. Sub floor is in great shape and level(?). Sterling (Kohler) 'Ensemble' unit. It appears there are 8 'feet' that are a part of the 'grid' ...
1
vote
1answer
22 views

Replacing a washer in a 3 knob tub faucet

I have a leak from the hot handle of a 3 knob tub faucet when the water is running. I am able to turn off the hot water because I have access to the hot water heater but I live in a condo that does ...
1
vote
2answers
40 views

How do I cover/repair this piece of my bath tub?

See the attached pictures. I'm short on ideas how to cover or replace this piece. I can't afford a full tub replacement right now so that is out of the question. Thanks
1
vote
1answer
2k views

What is the best board to install behind a glue up tub surround?

I would think it would make sense to install a waterproof board like GoBoard or DensShield behind a fiberglass tub surround, but I can’t find an adhesive that specifically states that it is compatible ...
1
vote
2answers
468 views

Does it make sense to use a nipple to connect a tub spout to copper?

I recently purchased a Grohe tub spout and it requires a MNPT fitting on the copper. The MNPT fitting must be placed behind the CBU and the tolerance is 1/8". Since I haven't chosen my tile yet, I'm ...
1
vote
2answers
275 views

Can pvc fittings and pvc pipe be used to install tube and shower fixture

Can pvc fittings and pipe be used to install tub and shower fixture.
1
vote
2answers
1k views

Does a bathtub spout with a diverter have to be on the same side as the valve, or can I move it over to the side of the tub?

I'm putting in a shower/tub unit and we want to have the tub spout on the side of the tub in the middle. The valve unit will be in the usual place on the end of the tub, with the shower head above it....
1
vote
1answer
3k views

Should my bathroom's plumbing vent be downstream of the toilet connection?

My wife and I just bought a house and have been smelling sewer gases from our tub. After taking a look at the piping, the tub doesn't have a p-trap. My original plan is to install a trap before the ...
1
vote
1answer
58 views

Can't pry off sliding shower door frame

I'm removing a sliding shower door frame (tub-mounted) and had no problem getting the top and sides off. Then I started on the bottom portion attached to the tub. Cut through the caulk and went as ...
1
vote
1answer
292 views

Tub leaking at the supply line

Today I tried to replace my tub faucet since the old one was dripping out of the front. The new one looks great! Unfortunately, it seems to drip at the supply pipe. The following picture shows the ...
1
vote
2answers
560 views

How to remove this brass collar from the pipe

The bathtub faucet is leaking at the diverter so the water can't be directed to the shower head. I bought a universal replacement (different brand) and attempted to remove the old one (it was a Delta ...
1
vote
1answer
3k views

Vapor barrier behind durock? [duplicate]

I am redoing a shower, tearing off old tile, replacing green board with Durock. I need help on whether I should or should not put a plastic sheet, vapor barrier over the studs before putting in the ...
1
vote
2answers
1k views

How do I remove bathtub drain screw?

I currently have a toe touch drain stopper installed (see first photo), and would like to replace it with a twist stopper (see second photo). The screw on the bottom of the toe touch stopper is ...
1
vote
1answer
524 views

Bathroom Tub Handle Leak

I initially had a drip coming from the spout in the bathroom tub. I replaced the hot and cold water stems and put new seats in both. This fixed the drip. The problem I now have is when I turn on ...
1
vote
1answer
712 views

Sealing what appears to be a non standard overflow drain

I have an overflow drain, as seen in the picture provided, that isn't sealed. The common wisdom I've read online has been to seal with a gasket, but my drain doesn't seem to be anything like the ones ...
1
vote
1answer
2k views

How to best repair poorly fitted rubber ring around overflow of bathtub?

I flooded my downstairs neighbor and after doing some troubleshooting, I figured out why. The overflow outlet on my tub was poorly fitted by the previous person touching it (I bought the condo like ...
1
vote
1answer
878 views

Leaking bathtub from seal underneath around drainspout

Our tub is leaking from a curved line around one side of the drain underneath the tub. We have a hole in the ceiling to see it and can see little droplets of water forming along that area. The ...
1
vote
1answer
80 views

3 pole switch with 2 wires

Old house. Replacing existing Bath fan/light/heater with new version. A single three switch pole (hope I'm describing that right). Old set up ran 2 12-2s as the power source We replaced the old wire ...
1
vote
1answer
197 views

Gaps created by cement-board being further that the bathtub-lip when tiling?

My installation: Cement-board = over the bathtup lip. There's one-two spots where the cement-board is not not flush with the bathtub lip creating gaps behind few tiles are supposed to be. Can i just ...
1
vote
2answers
257 views

fast fill faucets and fast drain for 70 gallon walk-in tub

Is there a size requirement for a fast-fill faucet? 1/2 inch or 3/4 inch supply pipe? Will it work with a 1/2 inch line? Also, what size drain for a fast empty of said tub of 70 gallons?
1
vote
2answers
7k views

Loud water sounds when tub faucet is turned on

I have the Alder tub/shower combo (http://www.moen.com/adler/spot-resist-brushed-nickel-posi-temp-r-tub-shower/_/R-CONSUMER%3AL82694EPSRN). When I turn on the water for the tub, the sounds of water ...