Questions tagged [bathtub]

The tag has no usage guidance.

0
votes
1answer
24 views

Tracking Potential Bathtub Leak Without Removing It

I've noticed that the corner of my bathtub gets wet. When a paper towel is placed there, it gets soaked in a short while. There is no large amount of water leaking out though. That spot just gets ...
0
votes
2answers
41 views

Bathtub faucet is not responsive

The bathtub faucet on the cold water side is doing something strange. When I turn the handle, nothing happens until I turn it a little more than half of the way around, then the water comes rushing ...
0
votes
2answers
157 views

Lowering the water pressure in my bathtub spout

I have a small tankless water heater and the flow from my bathtub spout is too strong and the water will not get hot. How can I reduce the flow in just the bathtub spout?
1
vote
0answers
190 views

How do I install a bathtub's surround on a cinder block wall?

I'm trying to install a tub and surround. The two short walls (left and right) are studded and I can secure on those studs but the back wall is cinder block. Do I need to add studs to the cinder block ...
5
votes
2answers
286 views

What should be used between a concrete tub and wall tile?

I have an older home that has a large, decorative concrete bathtub/shower with tiled enclosure walls. The walls behind the tile and tub are poured concrete. (Yes, the house is very sturdily built.) ...
0
votes
1answer
63 views

Do I need to replace this sub floor after bad tub installation?

I bought this house ~6 months ago and I noticed then that the caulk around this tub was not installed properly. I just barely got around to opening it up and seeing what was underneath and I found ...
3
votes
5answers
23k views

How do I replace a broken bathtub drain?

I am trying to replace my bathtub drain however the cross bars have broken off so I am unable to unscrew it from the tub. How can I unscrew it? EDIT: This is approximately the product I am trying ...
0
votes
1answer
43 views

re-combine shower and tub in master bath

I have separate tub and shower, and the shower plumbing is in the wall that separates the two, and the tub faucet is on the deck (?) of the fiberglass tub. I am considering doing away with the tub ...
0
votes
1answer
56 views

Should I redo it?

Reinsulated an exterior wall in shower. I had some faced insulation to use up so put it in the wall with the paper to the outside, no staples or tape. I have 6 mil plastic for interior vapor barrier. ...
0
votes
3answers
88 views

How do I stop water from building up in toilets and bathtubs?

Today, I awoke to water on my bathroom floor. What caused it? My house has a septic tank and two bathrooms, a master bedroom and guest bathroom. The guest bathroom had water on the floor, and the ...
0
votes
1answer
25 views

Reattaching Drain Rod to Trip Lever

The trip lever on my bathtub drain has broken. The small loop on the back of the trip lever drain broke off (see picture) and thus can't connect to the rod anymore. Now when I went to purchase a new ...
5
votes
5answers
2k views

Why does hot water only run for 30 seconds in bathtub?

In the bathroom of this rental is a tub with a shower diverter. It's an older setup with a hot & cold faucet and a center valve (one direction diverts to shower, the other to the tub faucet). If ...
1
vote
2answers
20 views

Replace faucet handles in existing bathtub

I'd like to update the handles for the faucet in an existing soaking tub to something more modern than these knobs. Is it possible without taking out the tub?
1
vote
1answer
943 views

Basement rough-in. Converting plumbing from a tub to a fiberglass shower

the basement rough-in was completed with a shower/tub rough-in. I want to convert it to a shower. I bought an alcove left drain fiberglass tub. The shower does have a p-trap and everything should be ...
2
votes
2answers
141 views

How to replace cartridge for this tub valve?

I need to replace the hot water cartridge on my jacuzzi tub. This is all I have access to -- I can't get to the other side. I can't tell how to disassemble this valve to get the cartridge out... any ...
0
votes
0answers
45 views

Why did the caulk around my tub develop brown/yellowish spots after only two days and what can be done?

Two days ago we re-caulked our tub using DAP Kwik Seal Ultra and left it undisturbed until today. Unfortunately it developed these brownish yellow spots and I am unsure why. I haven't been able to ...
0
votes
3answers
53 views

How to replace a Jacuzzi bathtub faucet

I have moderate plumbing skills. What is the procedure for replacing a leaking Jacuzzi bathtub faucet? Mine is similar to the picture. I DO NOT want to break through the tile to get to the bottom ...
0
votes
1answer
724 views

Exterior wall vapour barrier behind shower install?

There is discussion of vapor barrier behind a shower at this question, and many recommend not to have a vapor barrier behind the backer board if you are using a membrane on top of the backer, as it ...
0
votes
1answer
158 views

How to remove grime from shower handle hole? Can't remove handle for repairs!

Hello: I have a leaky tub spigot and I think the issue is the valve behind the handle. I just can't get an traction with any allen wrenches in the hole shown -- I think this is because of grime/...
1
vote
1answer
69 views

Should a bathtub be installed on a concrete slab or the subfloor that will be installed over the slab?

I am currently finishing my basement and looking to install a bathtub. I have already decided that I will be using a sub-floor in the basement. My question is: Should I place the bathtub directly on ...
0
votes
2answers
1k views

Shower mixer handle sticking out too far aesthetically

This question is common enough that it should have a place on the stack exchange - so that the best answers can easily be found. After redoing a bath and waiting to see that everything comes together ...
-3
votes
1answer
39 views

Looking for a bathtub door

I'm looking for a stylish glass shower door. Which will be good between frameless and the framed sliding tub door?
0
votes
0answers
42 views

Moen 1225 cartridge does not stay in place

I recently replaced a Moen 1225 cartridge (for a T8350 Moen faucet). That fixed the leak, but now when I turn on the faucet (by pulling it out) the faucet does not stay at the temperature I put it at....
1
vote
1answer
604 views

Very strange: tub & shower blocked, but toilet and sink fine, and snake won't fix it

Here's a doozy that so confused my plumber he left without fixing the problem: the tub and shower are both backed up but are somehow connected, since water in one will cause bubbles and eventually, a ...
0
votes
2answers
38 views

Claw foot tub faucet riser problem

Renovating bath and bought new kingston brass faucet with hand-held shower. Room is almost finished and looks better than expected so I decided to purchase the add-on shower riser with diverter so ...
0
votes
1answer
63 views

Problems while replacing old bathtub with recently bought bathtub?

I'm just upgrading my old dumb bathroom with the new faucets. The biggest change during remodeling is the bathtub. The builder put in a smallish tub, and I’m now going with a luxurious soaking tub ...
0
votes
1answer
653 views

What's the correct name for this type of bath and shower mixer tap?

I'm looking for a way to find a certain type of tap but I'm not native English and have no idea of the terminology, or even what I need exists... Wall has 2 pipe endings, 15cm apart. I need one big ...
0
votes
1answer
430 views

How to disassemble Harden (Symmons) tub/shower valve trim?

I'd like to replace the old Harden tub/shower valve trim in my condo's bathroom. As far as I know the Harden company (which already went bankrupt) only made trims and they used Symmons hardware under (...
0
votes
2answers
185 views

Shower in another room leaks when bath is running

I have a free-standing bath in my bedroom and a separate shower stall in an adjacent room. When we run hot water in the bath the shower head starts running-- not just a drip... more like moderate ...
0
votes
1answer
27 views

Wiring of jacuzzi bath tub (replacing normal tub)

I bought a "Jacuzzi" brand bath tub - standard size (30x60) with jets - to replace old "normal" tub. I can do the plumbing/finishing, but not sure about the wiring code requirements. So far i ...
1
vote
2answers
51 views

Twisted Wall Studs In Tub Surround

I have a new tub that is being installed and then I'm going to tile the tub surround. The problem is that several of the wall studs are either broken, bowed, or twisted pretty bad. What's the best way ...
0
votes
1answer
43 views

Slight brown tint when starting cold water from tub faucet?

More specifically, when I haven't used my tub for a couple of days, and I start the water (only the cold) there is initially a bit of brown tint in it, but it rapidly disappears. It's fine if I'm ...
4
votes
4answers
17k views

How can I vent a bathtub trap when the drain is routed under the tub?

I am … very slowly … thinking about replacing the probably circa 1950's galvanized steel drain pipes in my basement with PVC. In particular, I would like to replace the drain line under ...
1
vote
1answer
63 views

Tub to shower conversion plumbing questions

I'm in the middle of a tub to shower conversion but am a complete amateur when it comes to plumbing issues. The tub is out, the walls are open, we have the stand up shower kit bought. But upon looking ...
0
votes
1answer
33 views

Bathtub drain & overflow

Decided to DIY a refinish kit on my tub (it’s a rental and I’m broke); unfortunately, I cannot get the rusty, corroded drain to budge. Tried special tools, tried inserting pliers into the X and using ...
2
votes
0answers
59 views

Bathtub pump motor - ineffective ground through water pipe?

I opened up the space underneath my bathtub for the first time in this house. The tub is a "spa" style and has a pump motor to circulate water through jets. (I'm in NY / USA). I noticed that the ...
0
votes
1answer
51 views

How to effectively patch/recaulk small crevices between bathtub and bathroom tile?

There was some mold growing inside the caulk at one corner of my tub so I cut it out. In doing this I discovered I have a few small gaps in the old caulk I'd like to fill. I want to practice ...
0
votes
1answer
79 views

How do I remove the connected **plunger** of a bathtub linkage assembly that won't fit through the opening?

I have a trip lever mechanism on my old tub and want to replace it because the water stop lever is faulty and the tub drains and leaks slowly. I removed the cover plate from the overflow opening and ...
9
votes
3answers
7k views

Do tub drains of the same diameter ever have different thread-per-inch counts?

My tub's drain flange has had the little cross piece inside it broken out, which means I cannot screw a grid drain into it. Right now, it's totally open and an invitation for my toddler to drop stuff ...
1
vote
1answer
30 views

Can I have a wand installed in tub in addition to a 3-hole faucet?

I have a new tub being installed that takes a deck mounted faucet. I found a faucet I like which is a two handle, 3-hole type. However, it would be nice to have a wand mounted on the deck as well. Is ...
4
votes
7answers
36k views

How can I fix a bathtub that was not set properly?

I think the floor was not prepped correctly. The tub creaks a lot and there is a great deal of vertical play when standing and moving around. The tub does appear to be level, so I don't think that's ...
0
votes
0answers
27 views

Waterproof membrane under alcove tub? Tiling the bathroom floor

I’ve completely demoed my bathroom, I’m going to install the alcove tub and then tile the floor. It’s a one story house and it’s a concrete subfloor. My question is: do I apply the waterproof membrane ...
1
vote
1answer
23 views

Can I remove just the upper part of my 1 Piece Acrylic Tub (Walls) and leave the tub in place?

I want to tile the walls in my bath but don't want to remove the one piece acrylic tub. Has anyone ever cut down the tub walls and tiled down to the edge of the existing tub? I anticipate placing a ...
0
votes
1answer
34 views

Accidentally removed grout behind bathtub caulk, necessary to replace?

I got so excited my first time removing caulk that I believe I have removed some grout as well that was behind the caulk. Of course, I'm most worried about water damage, so is it best to replace the ...
1
vote
2answers
53 views
1
vote
2answers
58 views

Identifying old single handle shower valve/cartride?

Need help identifying the tub/shower faucet valve/cartridge in the pictures below. I shutoff the main and removed EVERYTHING in preparation for replacement at a later date, and realized I never took ...
0
votes
1answer
20 views

Can I install a trip lever drain on a new tub that doesn’t currently use one?

I have a brand new tub. How can I tell if I can install a trip style drain? Right now we are just using a plug and the faceplate doesn’t have a lever. I was reading online that these drains aren’t ...
3
votes
4answers
4k views

How to remove a tub drain with no spokes?

I attempted to use my tub drain removal wrench to remove a bath tub drain. Unfortunately the spokes of the drain broke and the drain flange cracked. Not being terribly skilled at plumbing I am now ...
0
votes
2answers
61 views

How can I repair the damaged coating in my bathtub?

The cat peed in our tub and I poured pure white vinegar in the tub to deodorize. I left about an inch of it in the tub for a couple of days. After I drained it I noticed that the glaze was gone where ...
0
votes
1answer
25 views

Patch for Tile Sealant Coat

I have a problem with the tiles around the tub in my ~1910 residential apartment building in Washington DC. At some point the existing tile was coated in some sort of sealant layer, which has ...