I need some help wiring a combination switch/GFCI outlet in the following situation. The second diagram is from the instructions and seems to match my situation, however they have an outlet downstream rather than a lightswitch (is this irrelevant?) and there are 2 black cables coming from downstream which seems to be a mistake that I need clarified.

The existing wiring is a big mess:

enter image description here

enter image description here

enter image description here

Looking into the back of the box:

enter image description here

An illustration of the current wiring:

enter image description here

  • Hello, and welcome to Stack Exchange. Do you have the installation directions for your GFCI? Does it address this situation? Jul 15 '16 at 21:35
  • Hi Daniel. It comes with 3 diagrams and the 3rd one seems similar to my situation, however they have another outlet downstream rather than a lightswitch, and more importantly, they seem to have made a mistake and forgot to colour-code the wires properly, as there are 2 black wires coming from downstream rather than a black and a white.
    – MarcGuay
    Jul 15 '16 at 21:42
  • That diagram does not make sense to me. It seems to show wires labeled "black switch lead" (which would normally be a switched hot) connected to the terminal for the load-side grounded conductors (neutral). Jul 15 '16 at 22:00
  • @JimmyFix-it -- that's where the wires for the switch come out Jul 15 '16 at 22:09
  • The two black switch leads internally connect only to the switch, it's like a completely separate device from the GFCI.
    – Tyson
    Jul 15 '16 at 22:25

Based on the diagram so far, here's how the GFCI switch/outlet combo should be wired:

  • Black from breaker to LINE HOT on GFCI/switch
  • White from breaker to LINE WHITE on GFCI/switch
  • White from switch-cable and white from light nutted together and pigtailed to LOAD WHITE on GFCI/switch
  • Black from switch-cable and one black from GFCI/switch nutted together and pigtailed to LOAD HOT on GFCI/switch
  • Other black from GFCI/switch nutted to black from light

(If your GFCI has the two-wire, clamp-plate terminals as in the diagram depicted, you can save a couple nuts and the pigtail wires by terminating both wires to the clamp plate instead -- they are designed to terminate two wires, one in each hole.)

  • I've modified the diagram that came with the device to match your description - does this seem correct? c2.staticflickr.com/9/8581/27734194033_a8e6c24d31_b.jpg
    – MarcGuay
    Jul 16 '16 at 19:57
  • @MarcGuay -- yup, that's it Jul 16 '16 at 20:09
  • Thank you. Does their colour labelling make sense to you?
    – MarcGuay
    Jul 16 '16 at 20:21
  • And is it correct that the light/switched load will not be grounded?
    – MarcGuay
    Jul 16 '16 at 20:36
  • @MarcGuay -- it seems like whoever drew their diagram goofed, and yes, in your case, it is correct that things aren't going to be grounded -- the GFCI protection is an acceptable substitute. Jul 16 '16 at 21:15

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.