I have a Kenmore dryer that won't heat. Here's what I know:

240 voltage comes into dryer. Checked wires inside where power connects.

Thermostat, high limit thermostat, heating element, and fuses all have continuity

Lint tubes all clean.

Motor switch has continuity

WHAT COULD THIS BE? Maybe the control board? (although doesn't look damaged or have any black marks from a surge and dryer buttons work fine)

  • Have you checked that power is sent to the heating element? – isherwood Jul 5 '16 at 16:21
  • Motor turns the drum? What about the cutoff switch in the door? – Wayfaring Stranger Jul 5 '16 at 16:24
  • Thanks for the quick response guys. Isher - I checked the power flow to the element - no power. Wayfaring - motor turns the drum. Cut off switch is ok (I assume) because the drum turns – Matt Anderson Jul 5 '16 at 17:04
  • 240V is probably controlled by a relay; can you hear the relay "click"? – Daniel Griscom Jul 5 '16 at 17:15
  • Much of the control board electronics are TTL or ECL, and you'll never see any damage even though ICs are blown. As Dan G commented, if you can find a relay in the line to the heater, see if that can be toggled. – Carl Witthoft Jul 5 '16 at 17:23

look for an thermal fuse on the heating element. If the coil over heated these thermal links pop cost from 5-15$ (as long as the heat coil is good) This may be the cause.. usually held in with screws easy to change.

| improve this answer | |
  • Good idea, but OP mentions fuses. – isherwood Jul 5 '16 at 19:00
  • yes but that one gets over looked quite often and, it is the control for the heater relay so the wiring looks two small. – Ed Beal Jul 5 '16 at 19:43
  • Just replaced one of those on a coffeepot. It's the most common cause of failure. There are two varieties, one shot, and resettable. – Wayfaring Stranger Jul 6 '16 at 13:52

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.