I'm trying to make this circle for my pool to put 3" of sand in it

  • Hello, and welcome to Stack Exchange. How many boards will your (mostly) circle have? Commented Jun 5, 2016 at 13:38

1 Answer 1


You can't figure this out without knowing how many boards your circle will have; once you choose the number of boards, just divide 360 by the number of bevels (one for each end of each board) and that's how far from 90° each end should be.

So, if you have 4 boards (a square):

  • 4 * 2 = 8 bevelled ends
  • 360° / 8 = 45°
  • each end should have a 45° bevel on it:

Rectangle with beveled corners

If you have 20 boards:

  • 20 * 2 = 40 bevelled ends
  • 360° / 40 = 9°
  • each end should have a 9° bevel on it, so each end should be cut 9° from perpendicular:

20-sided polygon

A couple of possible optimizations:

  • When you're cutting a board to length with a (say) 9° bevel, you automatically create a second end with a 9° bevel in the opposite direction. So, flip the board over and then cut THAT board to length with the 9° bevel. Bingo: half as many cuts.
  • Another alternative would be to leave one end of each board square (what I'm calling a 0° bevel), and then cut the other ends at twice the angle calculated above. Depending on the situation, this may mean less work.

(Just to be clear: what I'm calling a 9° bevel will result in a board whose end is cut almost perpendicular to the sides, not a board with an extremely sharp point on the end. Here's a page with more math for your calculations.)

  • 2
    I could add to this good answer that the bevel for 20 boards will apply to any length boards. Just make certain that all the boards are the same length.
    – Michael Karas
    Commented Jun 5, 2016 at 18:31
  • 1
    If you do decide to go with 20 boards to make the 28' diameter circle you will need to make each board about 4' 5 3/16" length on the outside (long side). If you want to make a more rounded circle of course more boards would be required. For example of you chose to go with 36 boards the bevel would be 360 / (2 * 36) = 0.5°. The outside length for 36 boards would be 2' 5 3/8". This latter choice would leave little waste if starting with 8' boards. The 20 sided design would require starting with 10' boards and there would be over a foot of waste from each board if cutting two per board.
    – Michael Karas
    Commented Jun 5, 2016 at 19:15

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.